Lines Matching +full:led +full:- +full:controller

1 What:		/sys/class/leds/<led>/flash_brightness
6 		Set the brightness of this LED in the flash strobe mode, in
7 		microamperes. The file is created only for the flash LED devices
11 		/sys/class/leds/<led>/max_flash_brightness.
13 What:		/sys/class/leds/<led>/max_flash_brightness
18 		Maximum brightness level for this LED in the flash strobe mode,
21 What:		/sys/class/leds/<led>/flash_timeout
28 		of the strobe. The file is created only for the flash LED
31 What:		/sys/class/leds/<led>/max_flash_timeout
36 		Maximum flash timeout for this LED, in microseconds.
38 What:		/sys/class/leds/<led>/flash_strobe
49 What:		/sys/class/leds/<led>/flash_fault
55 		Flash faults are re-read after strobing the flash. Possible
58 		* led-over-voltage - flash controller voltage to the flash LED
59 			has exceeded the limit specific to the flash controller
60 		* flash-timeout-exceeded - the flash strobe was still on when
63 		* controller-over-temperature - the flash controller has
65 		* controller-short-circuit - the short circuit protection
66 			of the flash controller has been triggered
67 		* led-power-supply-over-current - current in the LED power
69 			controller
70 		* indicator-led-fault - the flash controller has detected
71 			a short or open circuit condition on the indicator LED
72 		* led-under-voltage - flash controller voltage to the flash
73 			LED has been below the minimum limit specific to
75 		* controller-under-voltage - the input voltage of the flash
76 			controller is below the limit under which strobing the
79 		* led-over-temperature - the temperature of the LED has exceeded