Lines Matching full:writing

131 An array is ``created`` by writing appropriate superblocks to all
230      devices.  Writing a number (in Kilobytes) which is less than
233      Writing the word ``default`` will cause the effective size of the
250      and writing will effect the ``new`` value, leaving the ``old``
258      and can be read from here.  Writing to this value may resize
293      Writing a value of 0 disables safemode.
298      writing the word for the desired state, however some states
309          Writing is equivalent to STOP_ARRAY ioctl
320          Writing this, if accepted, will block until array is quiessent
426      The accepted values when writing to this file are ``ppl`` and ``resync``,
495 	Writing ``faulty``  simulates a failure on the device.
497 	Writing ``remove`` removes the device from the array.
499 	Writing ``writemostly`` sets the writemostly flag.
501 	Writing ``-writemostly`` clears the writemostly flag.
503 	Writing ``blocked`` sets the ``blocked`` flag.
505 	Writing ``-blocked`` clears the ``blocked`` flags and allows writes
508 	Writing ``in_sync`` sets the in_sync flag.
510 	Writing ``write_error`` sets writeerrorseen flag.
512 	Writing ``-write_error`` clears writeerrorseen flag.
514 	Writing ``want_replacement`` is allowed at any time except to a
517 	Writing ``-want_replacement`` is allowed at any time.  It clears
520 	Writing ``replacement`` or ``-replacement`` is only allowed before
578 	is too big to fit in a page, it will be truncated. Writing
585 	to fit in a page, it will be truncated. Writing to this file
640       read are meaningful for writing.
677       If the array has a write-intent bitmap, then writing to this