Lines Matching +full:two +full:- +full:user

7     Addresses scanned: I2C 0x2c - 0x2f
13     Addresses scanned: I2C 0x2c - 0x2f
15     http://pdfserv.maxim-ic.com/en/ds/DS1780.pdf
19     Addresses scanned: I2C 0x2c - 0x2f
31 ---------
33 chip MSB 5-bit address. Each chip reports a unique manufacturer
37 -----------
39 microprocessor-based systems, providing measurement and limit comparison
40 of up to four power supplies and two processor core voltages, plus
41 temperature, two fan speeds and chassis intrusion. Measured values can
42 be read out via an I2C-compatible serial System Management Bus, and values
45 analog channels to ensure a fast interrupt response to any out-of-limit
54 ------------
58 each two seconds. User-space may read sysfs interface faster than the
69 The LM81 12-bit extended temperature measurement mode is not supported.
72 -----------
73 On chip temperature is reported as degrees Celsius as 9-bit signed data
75 are 8-bit signed data with resolution of one degree Celsius.
81 ---------
82 Two fan tacho inputs are provided, the ADM9240 gates an internal 22.5kHz
83 clock via a divider to an 8-bit counter. Fan speed (rpm) is calculated by:
89   * User sets 0 to fan_min limit
90     - low speed alarm is disabled
91     - fan clock divider not changed
92     - auto fan clock adjuster enabled for valid fan speed reading
94   * User sets fan_min limit too low
95     - low speed alarm is enabled
96     - fan clock divider set to max
97     - fan_min set to register value 254 which corresponds
99     - low speed alarm will be asserted if fan speed is
101     - auto fan clock adjuster disabled
103   * User sets reasonable fan speed
104     - low speed alarm is enabled
105     - fan clock divider set to suit fan_min
106     - auto fan clock adjuster enabled: adjusts fan_min
108   * User sets unreasonably high low fan speed limit
109     - resolution of the low speed limit may be reduced
110     - alarm will be asserted
111     - auto fan clock adjuster enabled: adjusts fan_min
118 -------------
121 power up or reset. This doesn't do much on the test Intel SE440BX-2.
136 The reading is an unsigned 8-bit value, nominal voltage measurement is
144 -----------
145 The chip has five inputs to read the 5-bit VID and reports the mV value
149 -----------------
152 this pin. On an Intel SE440BX-2 the Chassis Intrusion header is
160 Alarm flags reported as 16-bit word
163     ---     -------------       --------------------------
176 that alarm bits may be cleared on read, user-space may latch alarms and
177 provide the end-user with a method to clear alarm memory.