Lines Matching +full:assigned +full:- +full:resolution +full:- +full:bits
15 Andigilog has both the PECI and pre-PECI versions of the Heceta-6, as
16 Intel calls them. Heceta-6e has high frequency PWM and Heceta-6p has
18 Heceta-6e part and aSC7621 is the Heceta-6p part. They are both in
22 specification. First enhancement is temperature reading resolution. We
23 have used registers below 20h for vendor-specific functions in addition
24 to those in the Intel-specified vendor range.
27 The fan speed control uses this finer value to produce a "step-less" fan
28 PWM output. These two bytes are "read-locked" to guarantee that once a
29 high or low byte is read, the other byte is locked-in until after the
32 sheet says 10-bits of resolution, although you may find the lower bits
38 when compared to the competition, in addition to the higher resolution
42 We offer GPIO features on the former VID pins. These are open-drain
63 assigned to up to 4 PECI addresses. This is not possible in the default
64 Intel configuration. This would be useful in multi-CPU systems with
69 fan types. We can also support pulse-stretched PWM so that 3-wire fans
76 --
80 Using a 10-bit ADC, the aSC7621 measures the temperature of two remote diode
90 temperature zones. Both high- and low-frequency PWM ranges are supported.
105 - Supports PECI interface and monitors internal and remote thermal diodes
106 - 2-wire, SMBus 2.0 compliant, serial interface
107 - 10-bit ADC
108 - Monitors VCCP, 2.5V, 3.3V, 5.0V, and 12V motherboard/processor supplies
109 - Programmable autonomous fan control based on temperature readings
110 - Noise filtering of temperature reading for fan speed control
111 - 0.25C digital temperature sensor resolution
112 - 3 PWM fan speed control outputs for 2-, 3- or 4-wire fans and up to 4 fan
114 - Enhanced measured temperature to Temperature Zone assignment.
115 - Provides high and low PWM frequency ranges
116 - 3 GPIO pins for custom use
117 - 24-Lead QSOP package
123 the standards defined in "sysfs-interface".
167 temp[1-4]_smoothing_enable
168 temp[1-4]_smoothing_time
180 temp[1-4]_crit
184 temp[5-8]_input
185 temp[5-8]_enable
191 pwm[1-3]_enable
198 4-254 Ignored.
201 pwm[1-3]_auto_channels
202 Bitmap as described in sysctl-interface with the following
220 pwm[1-3]_invert
221 When set, inverts the meaning of pwm[1-3].
225 pwm[1-3]_freq