Lines Matching +full:assigned +full:- +full:resolution +full:- +full:bits

42         Margit Schubert-While <margitsw@t-online.de>,
46 -----------
52 The LM85 uses the 2-wire interface compatible with the SMBUS 2.0
54 temperatures and five (5) voltages. It has four (4) 16-bit counters for
87 ----------------
93 for 3-wire and 2-wire mode. For this reason, the 2-wire fan modes are not
102 The ADM1027, ADT7463 and ADT7468 have a 10-bit ADC and can therefore
103 measure temperatures with 0.25 degC resolution. They also provide an offset
112 The ADT7468 has a high-frequency PWM mode, where all PWM outputs are
113 driven by a 22.5 kHz clock. This is a global mode, not per-PWM output,
120 from National (AN-1260) with some additional information about the LM85.
127 fans in a PC or embedded system. The EMC6D101, available in a 24-pin SSOP
128 package, and the EMC6D100, available in a 28-pin SSOP package, are designed
133 zero. EMC6D102 and EMC6D103 feature additional ADC bits thus extending precision
140 -----------------------
163 -------------------
173 * temp#_auto_temp_off - temperature below which fans should be off or spinning very low.
174 * temp#_auto_temp_min - temperature over which fans start to spin.
175 * temp#_auto_temp_max - temperature when fans spin at full speed.
176 * temp#_auto_temp_crit - temperature when all fans will run full speed.
182 configured and assigned to a zone for its control value. Each PWM can be
185 * pwm#_auto_pwm_min - this specifies the PWM value for temp#_auto_temp_off
188 * pwm#_auto_pwm_minctl - this flags selects for temp#_auto_temp_off temperature
199 * pwm#_auto_channels - controls zone that is associated with PWM
204   ------  ------------------------------------------------
211      -1    PWM always 100%  (full on)
212      -2    Manual control (write to 'pwm#' to set)
216 see the LM85 datasheet or Application Note AN-1260. These features
220 The number of pulses-per-rev of the fans can be set, Tach monitoring