Lines Matching +full:pwm +full:- +full:outputs

7     Addresses scanned: I2C 0x2c - 0x2f
15 -----------------
30 -----------
37 parameter; this will put it into a more well-behaved state first.
43 The driver also implements up to seven fan control outputs: pwm1-7.  Pwm1-7
44 can be configured to PWM output or Analogue DC output via their associated
45 pwmX_mode. Outputs pwm4 through pwm7 may or may not be present depending on
48 Automatic fan control mode is possible only for fan1-fan3.
50 For all pwmX outputs, a value of 0 means minimum fan speed and a value of
70 bit - alarm on:
71 0  - in0
72 1  - in1
73 2  - temp1
74 3  - temp2
75 4  - temp3
76 5  - fan1
77 6  - fan2
78 7  - fan3
79 8  - in2
80 9  - in3
81 10 - in4
82 11 - in5
83 12 - in6
84 13 - VID change
85 14 - chassis
86 15 - fan7
87 16 - tart1
88 17 - tart2
89 18 - tart3
90 19 - in7
91 20 - in8
92 21 - fan4
93 22 - fan5
94 23 - fan6
108 ----------------
110 	- This driver is only for Winbond W83792D C version device, there
112 	  calculation method to in6-in7(measured value, limits) is a little
115 	- The function of vid and vrm has not been finished, because I'm NOT
117  	- The function of chassis open detection needs more tests.
118 	- If you have ASUS server board and chip was not found: Then you will
123 -----------
126 -----------
128 Works as expected. You just need to specify desired PWM/DC value (fan speed)
129 in appropriate pwm# file.
132 --------------
137 via thermal_cruise# file. The tolerance# file serves to create T +- tolerance
139 remains below the thermal_cruise# +- tolerance# value. Once the temperature
141 specific speed set by pwm# and automatically controlled its PWM duty cycle
144 (1) If the temperature still exceeds the high limit, PWM duty
148 limit (T-tolerance), the fan speed will be fixed at the current speed because
151 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
156 ------------
160 temperature region (sf2_point@_fan# +- tolerance#) it will cause fans to run
166 ----------
168 pwm[1-7] - this file stores PWM duty cycle or DC value (fan speed) in range:
170 pwm[1-3]_enable - this file controls mode of fan/temperature control:
175 pwm[1-7]_mode - Select PWM or DC mode
177             * 1 PWM
178 thermal_cruise[1-3] - Selects the desired temperature for cruise (degC)
179 tolerance[1-3] - Value in degrees of Celsius (degC) for +- T
180 sf2_point[1-4]_fan[1-3] - four temperature points for each fan for Smart Fan II
181 sf2_level[1-3]_fan[1-3] - three PWM/DC levels for each fan for Smart Fan II