Lines Matching +full:wakeup +full:- +full:gpios
2 * Copyright (C) 2013 Texas Instruments Incorporated - http://www.ti.com/
8 /dts-v1/;
10 #include <dt-bindings/input/input.h>
12 #include "omap-gpmc-smsc911x.dtsi"
16 compatible = "ti,omap3-ldp", "ti,omap3";
25 cpu0-supply = <&vcc>;
30 compatible = "gpio-keys";
31 pinctrl-names = "default";
32 pinctrl-0 = <&gpio_key_pins>;
36 gpios = <&gpio4 5 GPIO_ACTIVE_LOW>; /* gpio101 */
38 wakeup-source;
43 gpios = <&gpio4 6 GPIO_ACTIVE_LOW>; /* gpio102 */
45 wakeup-source;
50 gpios = <&gpio4 7 GPIO_ACTIVE_LOW>; /* gpio103 */
52 wakeup-source;
57 gpios = <&gpio4 8 GPIO_ACTIVE_LOW>; /* gpio104 */
59 wakeup-source;
64 gpios = <&gpio4 9 GPIO_ACTIVE_LOW>; /* gpio105 */
66 wakeup-source;
71 gpios = <&gpio4 10 GPIO_ACTIVE_LOW>; /* gpio106 */
73 wakeup-source;
78 gpios = <&gpio4 11 GPIO_ACTIVE_LOW>; /* gpio107 */
80 wakeup-source;
85 gpios = <&gpio4 12 GPIO_ACTIVE_LOW>; /* gpio108 */
87 wakeup-source;
92 gpios = <&gpio4 13 GPIO_ACTIVE_LOW>; /* gpio109 */
94 wakeup-source;
104 compatible = "ti,omap2-nand";
106 interrupt-parent = <&gpmc>;
109 linux,mtd-name= "micron,nand";
110 nand-bus-width = <16>;
111 gpmc,device-width = <2>;
112 ti,nand-ecc-opt = "bch8";
114 gpmc,sync-clk-ps = <0>;
115 gpmc,cs-on-ns = <0>;
116 gpmc,cs-rd-off-ns = <44>;
117 gpmc,cs-wr-off-ns = <44>;
118 gpmc,adv-on-ns = <6>;
119 gpmc,adv-rd-off-ns = <34>;
120 gpmc,adv-wr-off-ns = <44>;
121 gpmc,we-off-ns = <40>;
122 gpmc,oe-off-ns = <54>;
123 gpmc,access-ns = <64>;
124 gpmc,rd-cycle-ns = <82>;
125 gpmc,wr-cycle-ns = <82>;
126 gpmc,wr-access-ns = <40>;
127 gpmc,wr-data-mux-bus-ns = <0>;
129 #address-cells = <1>;
130 #size-cells = <1>;
133 label = "X-Loader";
137 label = "U-Boot";
155 interrupt-parent = <&gpio5>;
162 clock-frequency = <2600000>;
167 interrupt-parent = <&intc>;
170 compatible = "ti,twl4030-power-idle";
178 #include "omap3-panel-sharp-ls037v7dw01.dtsi"
181 gpios = <&twl_gpio 7 GPIO_ACTIVE_HIGH>;
185 clock-frequency = <400000>;
189 clock-frequency = <400000>;
194 regulator-always-on;
198 enable-gpios = <&twl_gpio 15 GPIO_ACTIVE_HIGH>; /* lcd INI */
199 reset-gpios = <&gpio2 23 GPIO_ACTIVE_HIGH>; /* gpio55, lcd RESB */
200 mode-gpios = <&gpio2 24 GPIO_ACTIVE_HIGH>; /* gpio56, lcd MO */
205 interrupt-parent = <&gpio2>;
207 pendown-gpio = <&gpio2 22 GPIO_ACTIVE_HIGH>;
213 compatible = "ti,omap3-pre-es3-hsmmc";
214 vmmc-supply = <&vmmc1>;
215 bus-width = <4>;
216 pinctrl-names = "default";
217 pinctrl-0 = <&mmc1_pins>;
230 pinctrl-single,pins = <
244 pinctrl-single,pins = <
261 pinctrl-single,pins = <
293 interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
297 pinctrl-names = "default";
298 pinctrl-0 = <&musb_pins>;
299 interface-type = <0>;
300 usb-phy = <&usb2_phy>;
307 regulator-name = "vcc";