Lines Matching +full:stm32 +full:- +full:lptimer +full:- +full:trigger
17 ---help---
33 tristate "Active-semi ACT8945A"
38 Support for the ACT8945A PMIC from Active-semi. This device
39 features three step-down DC/DC converters and four low-dropout
55 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
58 called sun4i-gpadc.
77 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
114 tristate "Atmel HLCDC (High-end LCD Controller)"
151 tristate "X-Powers AC100"
155 If you say Y here you get support for the X-Powers AC100 audio codec
166 tristate "X-Powers AXP series PMICs with I2C"
171 If you say Y here you get support for the X-Powers AXP series power
183 tristate "X-Powers AXP series PMICs with RSB"
187 If you say Y here you get support for the X-Powers AXP series power
209 ---help---
269 ---help---
279 usually found on PXA processors-based platforms. This includes
282 LEDs and battery-charger under the corresponding menus.
354 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
360 This adds support for the DA9150 integrated charger and fuel-gauge
370 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
371 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
418 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
422 mxs-lradc-adc for ADC readings
423 mxs-lradc-ts for touchscreen support
426 called mxs-lradc.
443 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
448 We communicate with the Hi6421 via memory-mapped I/O.
467 handled by the leds-pasic3 and ds1wm drivers.
476 interface to one or more sub-chips.
488 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
524 causes the designware-i2c driver to be builtin for the same reason.
551 causes the designware-i2c driver to be builtin for the same reason.
577 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
586 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
609 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
613 This is the core driver for the Janz CMOD-IO PCI MODULbus
625 This driver is necessary for jz4740-battery and jz4740-hwmon driver.
636 * COMe-bBD#
637 * COMe-bBL6
638 * COMe-bHL6
639 * COMe-bSL6
640 * COMe-bIP#
641 * COMe-bKL6
642 * COMe-bPC2 (ETXexpress-PC)
643 * COMe-bSC# (ETXexpress-SC T#)
644 * COMe-cAL6
645 * COMe-cBL6
646 * COMe-cBT6
647 * COMe-cBW6
648 * COMe-cCT6
649 * COMe-cDC2 (microETXexpress-DC)
650 * COMe-cHL6
651 * COMe-cKL6
652 * COMe-cPC2 (microETXexpress-PC)
653 * COMe-cSL6
654 * COMe-mAL10
655 * COMe-mBT10
656 * COMe-mCT10
657 * COMe-mTT10 (nanoETXexpress-TT)
658 * ETX-OH
661 will be called kempld-core.
673 battery-charger under the corresponding menus.
696 battery-charger under the corresponding menus.
707 MAX77836 Micro-USB ICs with battery charger.
834 The device supports multiple sub-devices like LED, HWMON and WDT.
875 tristate "Nokia Retu and Tahvo multi-function device"
880 Retu and Tahvo are a multi-function devices found on Nokia
891 so that function-specific drivers can bind to them.
926 built-in PM8xxx PMIC chips.
932 module. This will build a module called "pm8xxx-core".
961 series as a module. The module will be called "qcom-spmi-pmic".
964 tristate "RDC R-321x southbridge"
968 Say yes here if you want to have support for the RDC R-321x SoC
982 sub-devices like charger, fuel gauge, flash LED, current source,
994 through i2c interface. The device supports multiple sub-devices
1009 through I2C interface. The device supports multiple sub-devices
1044 radio. This MFD driver connects the radio-si476x V4L2 module
1048 module will be called si476x-core.
1052 ---help---
1063 ---help---
1109 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1119 bool "ST-Ericsson AB3100 Mixed Signal Circuit core functions"
1128 this multi-functional IC. This is needed to use other features
1129 of the AB3100 such as battery-backed RTC, charging control,
1134 tristate "ST-Ericsson AB3100 OTP functions"
1138 Select this to enable the AB3100 Mixed Signal IC OTP (one-time
1143 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1164 bool "ST-Ericsson AB8500 GPADC driver"
1171 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1201 GPIO: stmpe-gpio
1202 Keypad: stmpe-keypad
1203 Touchscreen: stmpe-ts
1328 high-power "white LED driver". This boost converter is
1419 designware-i2c driver to be built-in, for the same reason.
1525 step-down converters, 11 general purpose LDOs, USB OTG Module,
1538 so that function-specific drivers can bind to them.
1540 These multi-function chips are found on many OMAP2 and OMAP3
1554 This driver uses board-specific data to initialize the resources
1584 regulators, Dual slot memory card transceivers, real-time clock
1595 driver connects the radio-wl1273 V4L2 module and the wl1273
1609 backlight or ambient-light-sensor functionality of the device.
1615 ---help---
1620 for in-vehicle infontainment, called Russellville.
1789 The WM8994 is a highly integrated hi-fi CODEC designed for
1803 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
1817 in various ST Microelectronics and ST-Ericsson embedded
1834 tristate "Support for STM32 Low-Power Timer"
1840 Select this option to enable STM32 Low-Power Timer driver
1841 used for PWM, IIO Trigger, IIO Encoder and Counter. Shared
1845 module will be called stm32-lptimer.
1848 tristate "Support for STM32 Timers"
1854 Select this option to enable STM32 timers driver used