Searched +full:1 +full:c00000 (Results 1 – 25 of 192) sorted by relevance
12345678
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mtd/ |
| D | ingenic,nand.yaml | 28 minItems: 1
44 maxItems: 1
48 maxItems: 1
63 #size-cells = <1>;
64 ranges = <1 0 0x1b000000 0x1000000>,
73 nand-controller@1 {
75 reg = <1 0 0x1000000>;
77 #address-cells = <1>;
91 nand@1 {
92 reg = <1>;
[all …]
|
| /kernel/linux/linux-4.19/arch/mips/boot/dts/ingenic/ |
| D | ci20.dts | 92 nandc: nand-controller@1 {
94 reg = <1 0 0x1000000>;
96 #address-cells = <1>;
114 nand@1 {
115 reg = <1>;
145 partition@c00000 {
150 partition@4c00000 {
165 reg = <6 0 1 /* addr */
166 6 2 1>; /* data */
231 groups = "mmc0-1bit-e", "mmc0-4bit-e";
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/display/exynos/ |
| D | samsung-fimd.txt | 41 - display-timings: timing settings for FIMD, as described in document [1].
53 If not specified, the default value(1) will be used.
63 | cs-setup+1 | : : :
66 | wr-setup+1 | | wr-hold+1 |
69 | wr-active+1|
77 1 - for CAMIF1 input,
82 [1]: Documentation/devicetree/bindings/display/panel/display-timing.txt
89 fimd@11c00000 {
94 interrupts = <11 0>, <11 1>, <11 2>;
103 fimd@11c00000 {
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/display/exynos/ |
| D | samsung-fimd.txt | 41 - display-timings: timing settings for FIMD, as described in document [1].
53 If not specified, the default value(1) will be used.
63 | cs-setup+1 | : : :
66 | wr-setup+1 | | wr-hold+1 |
69 | wr-active+1|
77 1 - for CAMIF1 input,
82 [1]: Documentation/devicetree/bindings/display/panel/display-timing.txt
89 fimd@11c00000 {
94 interrupts = <11 0>, <11 1>, <11 2>;
103 fimd@11c00000 {
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | socfpga_arria10_socdk_nand.dts | 14 #address-cells = <1>;
15 #size-cells = <1>;
21 partition@1c00000 {
|
| D | openbmc-flash-layout.dtsi | 5 #address-cells = <1>;
6 #size-cells = <1>;
28 rwfs@1c00000 {
|
| D | facebook-bmc-flash-layout.dtsi | 6 #address-cells = <1>;
7 #size-cells = <1>;
28 data0@1c00000 {
|
| D | da850-enbw-cmc.dts | 15 soc@1c00000 {
|
| D | qcom-msm8660-surf.dts | 19 gsbi@19c00000 {
56 MATRIX_KEY(0, 1, KEY_UP)
59 MATRIX_KEY(1, 0, KEY_FN_F2)
60 MATRIX_KEY(1, 1, KEY_RIGHT)
61 MATRIX_KEY(1, 2, KEY_DOWN)
62 MATRIX_KEY(1, 3, KEY_VOLUMEDOWN)
65 MATRIX_KEY(4, 1, KEY_UP)
70 MATRIX_KEY(5, 1, KEY_RIGHT)
|
| /kernel/linux/linux-4.19/arch/arm/boot/dts/ |
| D | openbmc-flash-layout.dtsi | 5 #address-cells = <1>;
6 #size-cells = <1>;
28 rwfs@1c00000 {
|
| D | da850-enbw-cmc.dts | 19 soc@1c00000 {
|
| D | qcom-msm8660-surf.dts | 19 gsbi@19c00000 {
56 MATRIX_KEY(0, 1, KEY_UP)
59 MATRIX_KEY(1, 0, KEY_FN_F2)
60 MATRIX_KEY(1, 1, KEY_RIGHT)
61 MATRIX_KEY(1, 2, KEY_DOWN)
62 MATRIX_KEY(1, 3, KEY_VOLUMEDOWN)
65 MATRIX_KEY(4, 1, KEY_UP)
70 MATRIX_KEY(5, 1, KEY_RIGHT)
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/misc/ |
| D | allwinner,syscon.txt | 17 syscon: syscon@1c00000 {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/rng/ |
| D | xiphera,xip8001b-trng.yaml | 20 maxItems: 1
30 rng@43c00000 {
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/dma/ |
| D | zxdma.txt | 7 - #dma-cells: see dma.txt, should be 1, para number
16 dma: dma-controller@09c00000{
21 #dma-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/dma/ |
| D | zxdma.txt | 7 - #dma-cells: see dma.txt, should be 1, para number
16 dma: dma-controller@09c00000{
21 #dma-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mfd/ |
| D | xylon,logicvc.yaml | 27 maxItems: 1
30 const: 1
33 const: 1
57 logicvc: logicvc@43c00000 {
|
| D | syscon.yaml | 60 maxItems: 1
67 enum: [1, 2, 4, 8]
70 maxItems: 1
82 syscon: syscon@1c00000 {
91 hwlocks = <&hwlock1 1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/ |
| D | xylon,logicvc-gpio.yaml | 35 maxItems: 1
43 minItems: 1
56 logicvc: logicvc@43c00000 {
60 #address-cells = <1>;
61 #size-cells = <1>;
|
| /kernel/linux/linux-4.19/arch/arm64/boot/dts/nvidia/ |
| D | tegra186-p3310.dtsi | 42 #address-cells = <1>;
54 memory-controller@2c00000 {
115 hsp@3c00000 {
136 cpu@1 {
202 drive-push-pull = <1>;
214 drive-push-pull = <1>;
247 in-ldo0-1-supply = <&vdd_5v0_sys>;
354 #address-cells = <1>;
368 vdd_1v8_ap: regulator@1 {
370 reg = <1>;
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mailbox/ |
| D | ti,secure-proxy.txt | 20 - #mbox-cells Shall be 1 and shall refer to the transfer path
31 secure_proxy: mailbox@32c00000 {
33 #mbox-cells = <1>;
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/mailbox/ |
| D | ti,secure-proxy.txt | 20 - #mbox-cells Shall be 1 and shall refer to the transfer path
31 secure_proxy: mailbox@32c00000 {
33 #mbox-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/remoteproc/ |
| D | wkup_m3_rproc.txt | 35 l4_wkup: l4_wkup@44c00000 {
38 #address-cells = <1>;
39 #size-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/soc/ti/ |
| D | wkup_m3_ipc.txt | 35 l4_wkup: l4_wkup@44c00000 {
41 #address-cells = <1>;
42 #size-cells = <1>;
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/remoteproc/ |
| D | wkup_m3_rproc.txt | 35 l4_wkup: l4_wkup@44c00000 {
38 #address-cells = <1>;
39 #size-cells = <1>;
|
12345678