Searched +full:3 +full:d000 (Results 1 – 25 of 189) sorted by relevance
12345678
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/ |
| D | nvidia,tegra20-gpio.txt | 16 bits[3:0] trigger type and level flags: 21 Valid combinations are 1, 2, 3, 4, 8. 26 gpio: gpio@6000d000 {
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/gpio/ |
| D | nvidia,tegra20-gpio.txt | 16 bits[3:0] trigger type and level flags: 21 Valid combinations are 1, 2, 3, 4, 8. 26 gpio: gpio@6000d000 {
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/freescale/ |
| D | qoriq-fman3-0-1g-5.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) 10 fman0_rx_0x0d: port@8d000 {
|
| /kernel/linux/linux-4.19/arch/arm64/boot/dts/freescale/ |
| D | qoriq-fman3-0-1g-5.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) 10 fman0_rx_0x0d: port@8d000 {
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/nvidia/ |
| D | tegra210-p2530.dtsi | 27 i2c@7000d000 { 62 cpu@3 {
|
| D | tegra210-p2180.dtsi | 11 rtc0 = "/i2c@7000d000/pmic@3c"; 34 i2c@7000d000 { 38 pmic: pmic@3c { 323 cpu@3 {
|
| /kernel/linux/linux-5.10/Documentation/translations/zh_CN/ |
| D | oops-tracing.txt | 56 (3)使用Kdump(请参看Documentation/admin-guide/kdump/kdump.rst), 99 7e 04 40 89 42 54 8b 43 04 3b 05 00 f6 52 c0 132 地址解析的完整支持至少应该使用1.3-pl3的sysklogd包。 161 Aug 29 09:51:01 blizard kernel: current->tss.cr3 = 0062d000, %cr3 = 0062d000 197 3:'S'如果oops发生在SMP内核中,运行于没有证明安全运行多处理器的硬件。 当前这种
|
| /kernel/linux/linux-4.19/Documentation/translations/zh_CN/ |
| D | oops-tracing.txt | 56 (3)使用Kdump(请参看Documentation/kdump/kdump.txt), 99 7e 04 40 89 42 54 8b 43 04 3b 05 00 f6 52 c0 132 地址解析的完整支持至少应该使用1.3-pl3的sysklogd包。 161 Aug 29 09:51:01 blizard kernel: current->tss.cr3 = 0062d000, %cr3 = 0062d000 197 3:'S'如果oops发生在SMP内核中,运行于没有证明安全运行多处理器的硬件。 当前这种
|
| /kernel/linux/linux-4.19/arch/arm64/boot/dts/nvidia/ |
| D | tegra210-p2530.dtsi | 27 i2c@7000d000 { 69 cpu@3 {
|
| D | tegra210-p2180.dtsi | 11 rtc0 = "/i2c@7000d000/pmic@3c"; 34 i2c@7000d000 { 38 pmic: pmic@3c { 314 cpu@3 {
|
| /kernel/linux/linux-4.19/arch/arm/boot/dts/ |
| D | bcm28155-ap.dts | 28 uart@3e000000 { 32 i2c@3e016000 { 37 i2c@3e017000 { 42 i2c@3e018000 { 47 i2c@3500d000 { 56 sdio2: sdio@3f190000 { 64 sdio4: sdio@3f1b0000 { 72 pwm: pwm@3e01a000 { 76 usbotg: usb@3f120000 { 82 usbphy: usb-phy@3f130000 {
|
| D | bcm953012hr.dts | 2 * SPDX-License-Identifier: BSD-3-Clause 76 m25p,default-addr-width = <3>; 85 partition@d000 {
|
| D | bcm953012k.dts | 86 m25p,default-addr-width = <3>; 95 partition@d000 {
|
| D | rk3xxx.dtsi | 68 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>; 120 gic: interrupt-controller@1013d000 { 123 #interrupt-cells = <3>; 214 dmas = <&dmac2 3>; 255 i2c0: i2c@2002d000 {
|
| D | imx7d.dtsi | 52 etm@3007d000 { 108 fsl,num-tx-queues=<3>; 109 fsl,num-rx-queues=<3>; 118 #address-cells = <3>; 135 <0 0 0 3 &intc GIC_SPI 123 IRQ_TYPE_LEVEL_HIGH>,
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | bcm28155-ap.dts | 29 uart@3e000000 { 33 i2c@3e016000 { 38 i2c@3e017000 { 43 i2c@3e018000 { 48 i2c@3500d000 { 57 sdio2: sdio@3f190000 { 65 sdio4: sdio@3f1b0000 { 73 pwm: pwm@3e01a000 { 77 usbotg: usb@3f120000 { 83 usbphy: usb-phy@3f130000 {
|
| D | rk3xxx.dtsi | 70 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>; 123 gic: interrupt-controller@1013d000 { 126 #interrupt-cells = <3>; 153 qos_gpu: qos@1012d000 { 257 dmas = <&dmac2 3>; 298 i2c0: i2c@2002d000 {
|
| D | bcm953012hr.dts | 2 * SPDX-License-Identifier: BSD-3-Clause 77 m25p,default-addr-width = <3>; 86 partition@d000 {
|
| D | bcm953012k.dts | 87 m25p,default-addr-width = <3>; 96 partition@d000 {
|
| D | tegra30-cardhu-a04.dts | 16 power-gpios = <&gpio TEGRA_GPIO(D, 3) GPIO_ACTIVE_HIGH>; 96 i2c@7000d000 { 136 cpu@3 {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/thermal/ |
| D | max77620_thermal.txt | 27 i2c@7000d000 { 28 spmic: max77620@3c {
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/thermal/ |
| D | max77620_thermal.txt | 27 i2c@7000d000 { 28 spmic: max77620@3c {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | st,stm32-exti.yaml | 82 exti1: interrupt-controller@5000d000 { 95 interrupts = <1>, <2>, <3>, <6>, <7>, <8>, <9>, <10>, <23>, <40>, <41>, <42>, <62>, <76>;
|
| /kernel/linux/linux-4.19/Documentation/trace/ |
| D | coresight.txt | 148 20010000.etb 20040000.funnel 2201d000.ptm 2203d000.etm 209 20010000.etb 20040000.funnel 2201d000.ptm 2203d000.etm 346 repository [3]. 423 crw------- 1 root root 10, 61 Jan 3 18:11 /dev/20100000.stm 430 [3]. https://github.com/Linaro/perf-opencsd
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/marvell/ |
| D | armada-37xx.dtsi | 90 cpu_misc: system-controller@d000 { 163 <&tbg 3>, <&xtalclk>; 171 <&tbg 3>, <&xtalclk>; 358 interrupts = <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>; 365 usb2_utmi_otg_phy: phy@5d000 { 467 #interrupt-cells = <3>; 483 #address-cells = <3>; 502 <0 0 0 3 &pcie_intc 2>, 503 <0 0 0 4 &pcie_intc 3>;
|
12345678