Searched full:assuming (Results 1 – 25 of 1623) sorted by relevance
12345678910>>...65
| /kernel/linux/linux-5.10/Documentation/firmware-guide/acpi/ |
| D | gpio-properties.rst | 75 assuming non-active (Polarity = !Pull Bias)
76 Down Low as low, assuming active
77 Down High as low, assuming non-active
78 Up Low as high, assuming non-active
79 Up High as high, assuming active
256 Be aware that gpiod_get_index() in cases 1 and 2, assuming that there
|
| /kernel/linux/linux-5.10/include/linux/ |
| D | numa.h | 33 pr_info_once("Unknown online node for memory at 0x%llx, assuming node 0\n", in memory_add_physaddr_to_nid()
41 pr_info_once("Unknown target node for memory at 0x%llx, assuming node 0\n", in phys_to_target_node()
|
| /kernel/linux/linux-4.19/Documentation/networking/ |
| D | multiqueue.txt | 52 qdiscs. To add the MULTIQ qdisc to your network device, assuming the device
58 the device reports, and bring the qdisc online. Assuming eth0 has 4 Tx
70 skbedit, has been added. Assuming you wanted to route all traffic to a
|
| /kernel/linux/linux-4.19/arch/alpha/kernel/ |
| D | irq_srm.c | 3 * Handle interrupts from the SRM, assuming no additional weirdness.
37 /* Handle interrupts from the SRM, assuming no additional weirdness. */
|
| /kernel/linux/linux-5.10/arch/alpha/kernel/ |
| D | irq_srm.c | 3 * Handle interrupts from the SRM, assuming no additional weirdness.
37 /* Handle interrupts from the SRM, assuming no additional weirdness. */
|
| /kernel/linux/linux-5.10/Documentation/networking/ |
| D | multiqueue.rst | 51 qdiscs. To add the MULTIQ qdisc to your network device, assuming the device
57 the device reports, and bring the qdisc online. Assuming eth0 has 4 Tx
69 skbedit, has been added. Assuming you wanted to route all traffic to a
|
| /kernel/linux/linux-4.19/Documentation/hwmon/ |
| D | ltc2990 | 43 curr1_input Current in mA across V1-V2 assuming a 1mOhm sense resistor
44 curr2_input Current in mA across V3-V4 assuming a 1mOhm sense resistor
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/rtc/ |
| D | ingenic,rtc.yaml | 54 (assuming RTC clock at 32 kHz)
62 (assuming RTC clock at 32 kHz)
|
| /kernel/linux/linux-4.19/Documentation/admin-guide/ |
| D | sysfs-rules.rst | 128 Assuming ``/sys/class/<subsystem>`` and ``/sys/bus/<subsystem>``, or
135 at the same level, never in a hierarchy. Assuming the block subsystem to
146 path as an element. Assuming the existence of the "device"-link for
156 element. Assuming the existence of these links for devices which are
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/ |
| D | sysfs-rules.rst | 128 Assuming ``/sys/class/<subsystem>`` and ``/sys/bus/<subsystem>``, or
135 at the same level, never in a hierarchy. Assuming the block subsystem to
146 path as an element. Assuming the existence of the "device"-link for
156 element. Assuming the existence of these links for devices which are
|
| /kernel/linux/linux-4.19/sound/ |
| D | Kconfig | 80 # here assuming USB is defined before ALSA
86 # here assuming PCMCIA is defined before ALSA
|
| /kernel/linux/linux-5.10/sound/ |
| D | Kconfig | 81 # here assuming USB is defined before ALSA
87 # here assuming PCMCIA is defined before ALSA
|
| /kernel/linux/linux-4.19/drivers/staging/comedi/ |
| D | comedi_pcmcia.c | 19 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
46 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a a
96 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| D | comedi_pci.c | 19 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
35 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
75 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| D | comedi_usb.c | 18 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
34 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| /kernel/linux/linux-5.10/drivers/staging/comedi/ |
| D | comedi_pcmcia.c | 19 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
46 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a a
96 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| D | comedi_pci.c | 19 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
35 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
75 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| D | comedi_usb.c | 18 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
34 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| /kernel/linux/linux-5.10/Documentation/hwmon/ |
| D | ltc2990.rst | 55 curr1_input Current in mA across V1-V2 assuming a 1mOhm sense resistor
56 curr2_input Current in mA across V3-V4 assuming a 1mOhm sense resistor
|
| /kernel/linux/linux-5.10/include/vdso/ |
| D | jiffies.h | 8 /* TICK_NSEC is the time between ticks in nsec assuming SHIFTED_HZ */
|
| /kernel/linux/linux-5.10/drivers/input/misc/ |
| D | cma3000_d0x.c | 185 "Invalid G range specified, assuming 8G\n"); in cma3000_poweron()
313 "Invalid mode specified, assuming Motion Detect\n"); in cma3000_init()
319 "Invalid G range specified, assuming 8G\n"); in cma3000_init()
|
| /kernel/linux/linux-4.19/drivers/input/misc/ |
| D | cma3000_d0x.c | 196 "Invalid G range specified, assuming 8G\n"); in cma3000_poweron()
324 "Invalid mode specified, assuming Motion Detect\n"); in cma3000_init()
330 "Invalid G range specified, assuming 8G\n"); in cma3000_init()
|
| /kernel/linux/linux-4.19/Documentation/i2c/busses/ |
| D | i2c-parport-light | 21 This must be passed if you want SMBus alert support, assuming your adapter
|
| /kernel/linux/linux-5.10/arch/arm/include/asm/ |
| D | kasan.h | 20 * The compiler uses a shadow offset assuming that addresses start
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/amd/amdkfd/ |
| D | kfd_mqd_manager.c | 139 * Assuming 1 SH/SE, 4 SEs: in mqd_symmetrically_map_cu_mask()
146 * Assuming 2 SH/SE, 4 SEs in mqd_symmetrically_map_cu_mask()
|
12345678910>>...65