Home
last modified time | relevance | path

Searched +full:double +full:- +full:inverters (Results 1 – 4 of 4) sorted by relevance

/kernel/linux/linux-5.10/Documentation/devicetree/bindings/pinctrl/
Dpincfg-node.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
4 $id: http://devicetree.org/schemas/pinctrl/pincfg-node.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
21 bias-disable:
25 bias-high-impedance:
27 description: high impedance mode ("third-state", "floating")
29 bias-bus-hold:
33 bias-pull-up:
[all …]
/kernel/linux/linux-5.10/include/linux/pinctrl/
Dpinconf-generic.h1 /* SPDX-License-Identifier: GPL-2.0-only */
5 * Copyright (C) 2011 ST-Ericsson SA
6 * Written on behalf of Linaro for ST-Ericsson
21 * enum pin_config_param - possible pin configuration parameters
28 * transition from say pull-up to pull-down implies that you disable
29 * pull-up in the process, this setting disables all biasing.
31 * mode, also know as "third-state" (tristate) or "high-Z" or "floating".
37 * impedance to GROUND). If the argument is != 0 pull-down is enabled,
38 * if it is 0, pull-down is total, i.e. the pin is connected to GROUND.
48 * impedance to VDD). If the argument is != 0 pull-up is enabled,
[all …]
/kernel/linux/linux-4.19/include/linux/pinctrl/
Dpinconf-generic.h4 * Copyright (C) 2011 ST-Ericsson SA
5 * Written on behalf of Linaro for ST-Ericsson
16 * enum pin_config_param - possible pin configuration parameters
23 * transition from say pull-up to pull-down implies that you disable
24 * pull-up in the process, this setting disables all biasing.
26 * mode, also know as "third-state" (tristate) or "high-Z" or "floating".
32 * impedance to GROUND). If the argument is != 0 pull-down is enabled,
33 * if it is 0, pull-down is total, i.e. the pin is connected to GROUND.
43 * impedance to VDD). If the argument is != 0 pull-up is enabled,
44 * if it is 0, pull-up is total, i.e. the pin is connected to VDD.
[all …]
/kernel/linux/linux-4.19/Documentation/devicetree/bindings/pinctrl/
Dpinctrl-bindings.txt4 such as pull-up/down, tri-state, drive-strength etc are designated as pin
15 need to reconfigure pins at run-time, for example to tri-state pins when the
47 pinctrl-0: List of phandles, each pointing at a pin configuration
65 pinctrl-1: List of phandles, each pointing at a pin configuration
68 pinctrl-n: List of phandles, each pointing at a pin configuration
70 pinctrl-names: The list of names to assign states. List entry 0 defines the
78 pinctrl-names = "active", "idle";
79 pinctrl-0 = <&state_0_node_a>;
80 pinctrl-1 = <&state_1_node_a &state_1_node_b>;
85 pinctrl-0 = <&state_0_node_a>;
[all …]