Home
last modified time | relevance | path

Searched full:four (Results 1 – 25 of 2469) sorted by relevance

12345678910>>...99

/kernel/linux/linux-5.10/Documentation/filesystems/spufs/
Dspufs.rst87 If a count smaller than four is requested, read returns -1 and
90 When data has been read successfully, four bytes are placed in
91 the data buffer and the value four is returned.
101 If a count smaller than four is requested, read returns -1 and
109 When data has been read successfully, four bytes are placed in
110 the data buffer and the value four is returned.
122 four is requested, write returns -1 and sets errno to EINVAL. If there
130 fully, four bytes are placed in the data buffer and the value four is
146 If a count smaller than four is requested, read returns -1 and
147 sets errno to EINVAL. Otherwise, a four byte value is placed in
[all …]
/kernel/linux/linux-4.19/Documentation/filesystems/
Dspufs.txt77 If a count smaller than four is requested, read returns -1 and
80 When data has been read successfully, four bytes are placed in
81 the data buffer and the value four is returned.
91 If a count smaller than four is requested, read returns -1 and
99 When data has been read successfully, four bytes are placed in
100 the data buffer and the value four is returned.
112 four is requested, write returns -1 and sets errno to EINVAL. If there
120 fully, four bytes are placed in the data buffer and the value four is
138 If a count smaller than four is requested, read returns -1 and
139 sets errno to EINVAL. Otherwise, a four byte value is placed in
[all …]
/kernel/linux/linux-4.19/Documentation/hwmon/
Dntc_thermistor30 and four circuit models with an option not to use any of the four models.
32 The four circuit models provided are:
84 When one of the four circuit models is used, read_uV, pullup_uV, pullup_ohm,
85 pulldown_ohm, and connect should be provided. When none of the four models
Dlm8329 will be reported instead of four.
60 are sufficient, and there is no need for a four temperatures sensor
80 all four sensors. There is no hysteresis mechanism as found on most
/kernel/linux/linux-4.19/Documentation/networking/
Dila.txt30 independent of its location. ILA identifiers are sixty-four
35 locators are sixty-four bit prefixes.
44 four bits) and an identifier (lower sixty-four bits).
50 An IPv6 address composed of a locator (upper sixty-four
51 bits) and an identifier (low order sixty-four bits). ILA
176 unstructured sixty-four bit value.
187 still sixty-four bits.
240 ILA router) or an ILA address (egress ILA router). LOC is the sixty-four
241 bit locator (with format W:X:Y:Z) that overwrites the upper sixty-four
254 sixty-four bits of the destination address. MODE and TYPE have the
/kernel/linux/linux-5.10/Documentation/hwmon/
Dntc_thermistor.rst37 and four circuit models with an option not to use any of the four models.
44 The four circuit models provided are:
94 When one of the four circuit models is used, read_uV, pullup_uV, pullup_ohm,
95 pulldown_ohm, and connect should be provided. When none of the four models
Dlm83.rst37 will be reported instead of four.
72 are sufficient, and there is no need for a four temperatures sensor
92 all four sensors. There is no hysteresis mechanism as found on most
/kernel/linux/linux-5.10/lib/
Dtest_stackinit.c73 .four = 0, \
79 .four = arg->four, \
87 var.four = 0
200 unsigned long four; member
209 unsigned long four; member
218 u8 four __aligned(64);
225 char four; member
234 unsigned long four; member
/kernel/linux/linux-5.10/Documentation/networking/
Dila.rst35 independent of its location. ILA identifiers are sixty-four
41 locators are sixty-four bit prefixes.
50 four bits) and an identifier (lower sixty-four bits).
56 An IPv6 address composed of a locator (upper sixty-four
57 bits) and an identifier (low order sixty-four bits). ILA
185 unstructured sixty-four bit value::
196 still sixty-four bits::
249 ILA router) or an ILA address (egress ILA router). LOC is the sixty-four
250 bit locator (with format W:X:Y:Z) that overwrites the upper sixty-four
263 sixty-four bits of the destination address. MODE and TYPE have the
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/timer/
Dsamsung,exynos4210-mct.yaml16 four preset counter values. The CPU local timers are 32-bit free running
41 interrupts should be specified after the four global timer interrupts
72 // in addition to four global timer interrupts.
111 // In this example, the IP contains four local timers, but using
131 // In this example, the IP contains four local timers, but using
/kernel/linux/linux-4.19/Documentation/devicetree/bindings/timer/
Dsamsung,exynos4210-mct.txt6 four preset counter values. The CPU local timers are 32-bit free running
21 should be specified after the four global timer interrupts have been
41 in addition to four global timer interrupts.
73 Example 3: In this example, the IP contains four local timers, but using
/kernel/linux/linux-5.10/Documentation/sound/cards/
Dimg-spdif-in.rst24 This control is used to attempt acquisition of up to four different sample
31 four sample rates set here.
33 If less than four rates are required, the same rate can be specified more than
/kernel/linux/linux-4.19/Documentation/devicetree/bindings/media/
Dimx.txt32 gasket demultiplexes the four virtual channel streams from the host
33 controller's 32-bit output image bus onto four 16-bit parallel busses
48 bus sink endpoint nodes and correspond to the four
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/media/
Dimx.txt32 gasket demultiplexes the four virtual channel streams from the host
33 controller's 32-bit output image bus onto four 16-bit parallel busses
48 bus sink endpoint nodes and correspond to the four
/kernel/linux/linux-4.19/Documentation/sound/cards/
Dimg-spdif-in.rst24 This control is used to attempt acquisition of up to four different sample
31 four sample rates set here.
33 If less than four rates are required, the same rate can be specified more than
/kernel/linux/linux-4.19/lib/zlib_inflate/
Dinftrees.h20 pointer, the low four bits of op is the number of index bits of
21 that table. For a length or distance, the low four bits of op
26 the current table to the next table. Each entry is four bytes. */
/kernel/linux/linux-5.10/lib/zlib_inflate/
Dinftrees.h20 pointer, the low four bits of op is the number of index bits of
21 that table. For a length or distance, the low four bits of op
26 the current table to the next table. Each entry is four bytes. */
/kernel/linux/linux-5.10/Documentation/ABI/testing/
Dsysfs-class-chromeos-driver-cros-ec-lightbar37 The values written to this file are sets of four integers,
39 to select a single segment, or 4 to set all four segments
43 more than one set of four integers.
/kernel/linux/linux-4.19/Documentation/media/uapi/v4l/
Dpixfmt-yuv410.rst24 belongs to 16 pixels, a four-by-four square of the image. Following the
30 have ¼ as many pad bytes after their rows. In other words, four Cx rows
/kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/
Dpixfmt-yuv410.rst24 belongs to 16 pixels, a four-by-four square of the image. Following the
30 have ¼ as many pad bytes after their rows. In other words, four Cx rows
/kernel/linux/linux-5.10/net/rxrpc/
Dsysctl.c14 static const unsigned int four = 4; variable
91 .extra1 = (void *)&four,
119 .extra2 = (void *)&four,
/kernel/linux/linux-5.10/tools/testing/selftests/bpf/progs/
Dtest_sockmap_kern.h237 int *bytes, zero = 0, one = 1, two = 2, three = 3, four = 4, five = 5; in bpf_prog4() local
254 start_pop = bpf_map_lookup_elem(&sock_bytes, &four); in bpf_prog4()
264 int zero = 0, one = 1, two = 2, three = 3, four = 4, five = 5, key = 0; in bpf_prog6() local
285 start_pop = bpf_map_lookup_elem(&sock_bytes, &four); in bpf_prog6()
341 int zero = 0, one = 1, two = 2, three = 3, four = 4, five = 5; in bpf_prog10() local
357 start_pop = bpf_map_lookup_elem(&sock_bytes, &four); in bpf_prog10()
/kernel/linux/linux-4.19/tools/bpf/
DMakefile27 FEATURE_TESTS = libbfd disassembler-four-args
28 FEATURE_DISPLAY = libbfd disassembler-four-args
46 ifeq ($(feature-disassembler-four-args), 1)
/kernel/linux/linux-4.19/arch/sparc/kernel/
Dvisemul.c19 /* 000111011 - four 16-bit packs */
25 /* 000111101 - four 16-bit packs */
28 /* 001001101 - four 16-bit expands */
55 /* 000101000 - four 16-bit compare; set rd if src1 > src2 */
61 /* 000100000 - four 16-bit compare; set rd if src1 <= src2 */
67 /* 000100010 - four 16-bit compare; set rd if src1 != src2 */
73 /* 000101010 - four 16-bit compare; set rd if src1 == src2 */
91 /* 000000100 - Four 16-bit edge boundary processing */
94 /* 000000101 - Four 16-bit edge boundary processing, no CC */
97 /* 000000110 - Four 16-bit edge boundary processing, little-endian */
[all …]
/kernel/linux/linux-5.10/arch/sparc/kernel/
Dvisemul.c19 /* 000111011 - four 16-bit packs */
25 /* 000111101 - four 16-bit packs */
28 /* 001001101 - four 16-bit expands */
55 /* 000101000 - four 16-bit compare; set rd if src1 > src2 */
61 /* 000100000 - four 16-bit compare; set rd if src1 <= src2 */
67 /* 000100010 - four 16-bit compare; set rd if src1 != src2 */
73 /* 000101010 - four 16-bit compare; set rd if src1 == src2 */
91 /* 000000100 - Four 16-bit edge boundary processing */
94 /* 000000101 - Four 16-bit edge boundary processing, no CC */
97 /* 000000110 - Four 16-bit edge boundary processing, little-endian */
[all …]

12345678910>>...99