| /kernel/linux/linux-4.19/scripts/coccinelle/free/ |
| D | iounmap.cocci | 18 @iom@
51 p1 << iom.p1;
52 p2 << iom.p2;
53 p3 << iom.p3;
61 p1 << iom.p1;
62 p2 << iom.p2;
63 p3 << iom.p3;
|
| /kernel/linux/linux-5.10/scripts/coccinelle/free/ |
| D | iounmap.cocci | 19 @iom@
52 p1 << iom.p1;
53 p2 << iom.p2;
54 p3 << iom.p3;
62 p1 << iom.p1;
63 p2 << iom.p2;
64 p3 << iom.p3;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/arm/marvell/ |
| D | marvell,kirkwood.txt | 45 "iom,iconnect"
46 "iom,iconnect-1.1"
47 "iom,ix2-200"
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/arm/marvell/ |
| D | marvell,kirkwood.txt | 45 "iom,iconnect"
46 "iom,iconnect-1.1"
47 "iom,ix2-200"
|
| /kernel/linux/linux-5.10/drivers/isdn/hardware/mISDN/ |
| D | hfc_pci.h | 22 /* GCI/IOM bus monitor registers */
28 /* GCI/IOM bus timeslot registers */
38 /* GCI/IOM bus data registers */
44 /* GCI/IOM bus configuration registers */
|
| D | ipac.h | 262 /* IOM: Timeslot, DPS, CDA */
280 /* IOM: Contol, Sync transfer, Monitor */
|
| D | hfcpci.c | 261 * STIO1 is used as output for data, B1+B2 from ST->IOM+HFC in reset_hfcpci()
262 * STIO2 is used as data input, B1+B2 from IOM->ST in reset_hfcpci()
264 * The IOM slots are always enabled in reset_hfcpci()
1816 hc->hw.trm |= 0x80; /* enable IOM-loop */ in channel_ctrl()
1820 hc->hw.trm &= 0x7f; /* disable IOM-loop */ in channel_ctrl()
1858 hc->hw.trm &= 0x7f; /* disable IOM-loop */ in channel_ctrl()
|
| /kernel/linux/linux-4.19/drivers/isdn/hardware/mISDN/ |
| D | hfc_pci.h | 36 /* GCI/IOM bus monitor registers */
42 /* GCI/IOM bus timeslot registers */
52 /* GCI/IOM bus data registers */
58 /* GCI/IOM bus configuration registers */
|
| D | ipac.h | 275 /* IOM: Timeslot, DPS, CDA */
293 /* IOM: Contol, Sync transfer, Monitor */
|
| D | hfcpci.c | 274 * STIO1 is used as output for data, B1+B2 from ST->IOM+HFC in reset_hfcpci()
275 * STIO2 is used as data input, B1+B2 from IOM->ST in reset_hfcpci()
277 * The IOM slots are always enabled in reset_hfcpci()
1832 hc->hw.trm |= 0x80; /* enable IOM-loop */ in channel_ctrl()
1836 hc->hw.trm &= 0x7f; /* disable IOM-loop */ in channel_ctrl()
1874 hc->hw.trm &= 0x7f; /* disable IOM-loop */ in channel_ctrl()
|
| /kernel/linux/linux-4.19/drivers/isdn/hisax/ |
| D | hfc_sx.h | 21 /* GCI/IOM bus monitor registers */
29 /* GCI/IOM bus timeslot registers */
40 /* GCI/IOM bus data registers */
47 /* GCI/IOM bus configuration registers */
|
| D | hfc_pci.h | 28 /* GCI/IOM bus monitor registers */
36 /* GCI/IOM bus timeslot registers */
47 /* GCI/IOM bus data registers */
54 /* GCI/IOM bus configuration registers */
|
| D | ipacx.h | 59 /* IOM: Timeslot, DPS, CDA */
77 /* IOM: Contol, Sync transfer, Monitor */
|
| D | isac.c | 533 /* IOM 1 Mode */ in ISAC_l1hw()
542 /* IOM 2 Mode */ in ISAC_l1hw()
631 /* IOM 1 Mode */ in initisac()
638 /* IOM 2 Mode */ in initisac()
|
| D | icc.c | 530 /* IOM 1 Mode */ in ICC_l1hw()
539 /* IOM 2 Mode */ in ICC_l1hw()
628 /* IOM 1 Mode */ in initicc()
635 /* IOM 2 Mode */ in initicc()
|
| D | hscx.c | 62 /* Switch IOM 1 SSI */ in modehscx()
|
| D | hisax_isac.c | 784 /* IOM 1 Mode */ in isac_setup()
791 /* IOM 2 Mode */ in isac_setup()
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | kirkwood-iconnect.dts | 9 compatible = "iom,iconnect-1.1", "iom,iconnect", "marvell,kirkwood-88f6281", "marvell,kirkwood";
|
| D | kirkwood-iomega_ix2_200.dts | 9 compatible = "iom,ix2-200", "marvell,kirkwood-88f6281", "marvell,kirkwood";
|
| /kernel/linux/linux-4.19/arch/arm/boot/dts/ |
| D | kirkwood-iconnect.dts | 9 compatible = "iom,iconnect-1.1", "iom,iconnect", "marvell,kirkwood-88f6281", "marvell,kirkwood";
|
| D | kirkwood-iomega_ix2_200.dts | 9 compatible = "iom,ix2-200", "marvell,kirkwood-88f6281", "marvell,kirkwood";
|
| /kernel/linux/linux-4.19/drivers/pinctrl/ |
| D | pinctrl-rockchip.c | 3237 struct rockchip_iomux *iom = &bank->iomux[j]; in rockchip_pinctrl_get_soc_data() local
3245 if (iom->offset >= 0) { in rockchip_pinctrl_get_soc_data()
3246 if (iom->type & IOMUX_SOURCE_PMU) in rockchip_pinctrl_get_soc_data()
3247 pmu_offs = iom->offset; in rockchip_pinctrl_get_soc_data()
3249 grf_offs = iom->offset; in rockchip_pinctrl_get_soc_data()
3251 iom->offset = (iom->type & IOMUX_SOURCE_PMU) ? in rockchip_pinctrl_get_soc_data()
3257 if (iom->type & IOMUX_SOURCE_PMU) in rockchip_pinctrl_get_soc_data()
3262 drv->offset = (iom->type & IOMUX_SOURCE_PMU) ? in rockchip_pinctrl_get_soc_data()
3267 i, j, iom->offset, drv->offset); in rockchip_pinctrl_get_soc_data()
3273 inc = (iom->type & (IOMUX_WIDTH_4BIT | in rockchip_pinctrl_get_soc_data()
[all …]
|
| /kernel/linux/linux-5.10/drivers/pinctrl/ |
| D | pinctrl-rockchip.c | 3612 struct rockchip_iomux *iom = &bank->iomux[j]; in rockchip_pinctrl_get_soc_data() local
3620 if (iom->offset >= 0) { in rockchip_pinctrl_get_soc_data()
3621 if (iom->type & IOMUX_SOURCE_PMU) in rockchip_pinctrl_get_soc_data()
3622 pmu_offs = iom->offset; in rockchip_pinctrl_get_soc_data()
3624 grf_offs = iom->offset; in rockchip_pinctrl_get_soc_data()
3626 iom->offset = (iom->type & IOMUX_SOURCE_PMU) ? in rockchip_pinctrl_get_soc_data()
3632 if (iom->type & IOMUX_SOURCE_PMU) in rockchip_pinctrl_get_soc_data()
3637 drv->offset = (iom->type & IOMUX_SOURCE_PMU) ? in rockchip_pinctrl_get_soc_data()
3642 i, j, iom->offset, drv->offset); in rockchip_pinctrl_get_soc_data()
3648 inc = (iom->type & (IOMUX_WIDTH_4BIT | in rockchip_pinctrl_get_soc_data()
[all …]
|
| /kernel/linux/linux-5.10/drivers/usb/typec/mux/ |
| D | intel_pmc_mux.c | 84 * Input Output Manager (IOM) PORT STATUS
600 /* The IOM microcontroller has a limitation of max 4 ports. */ in pmc_usb_probe()
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/ |
| D | vendor-prefixes.txt | 183 iom Iomega Corporation
|