| /kernel/linux/linux-4.19/drivers/mtd/nand/raw/ |
| D | nand_micron.c | 22 * Special Micron status bit 3 indicates that the block has been
86 * Configure chip properties from Micron vendor-specific ONFI table
93 struct nand_onfi_vendor_micron *micron = (void *)p->onfi->vendor; in micron_nand_onfi_init() local
95 chip->read_retries = micron->read_retry_options; in micron_nand_onfi_init()
177 struct micron_nand *micron = nand_get_manufacturer_data(chip); in micron_nand_on_die_ecc_setup() local
181 if (micron->ecc.forced) in micron_nand_on_die_ecc_setup()
184 if (micron->ecc.enabled == enable) in micron_nand_on_die_ecc_setup()
192 micron->ecc.enabled = enable; in micron_nand_on_die_ecc_setup()
201 struct micron_nand *micron = nand_get_manufacturer_data(chip); in micron_nand_on_die_ecc_status_4() local
231 ret = nand_read_page_op(chip, page, 0, micron->ecc.rawbuf, in micron_nand_on_die_ecc_status_4()
[all …]
|
| /kernel/linux/linux-5.10/drivers/mtd/nand/raw/ |
| D | nand_micron.c | 14 * Special Micron status bit 3 indicates that the block has been
77 * Configure chip properties from Micron vendor-specific ONFI table
84 struct nand_onfi_vendor_micron *micron = (void *)p->onfi->vendor; in micron_nand_onfi_init() local
86 chip->read_retries = micron->read_retry_options; in micron_nand_onfi_init()
168 struct micron_nand *micron = nand_get_manufacturer_data(chip); in micron_nand_on_die_ecc_setup() local
172 if (micron->ecc.forced) in micron_nand_on_die_ecc_setup()
175 if (micron->ecc.enabled == enable) in micron_nand_on_die_ecc_setup()
183 micron->ecc.enabled = enable; in micron_nand_on_die_ecc_setup()
192 struct micron_nand *micron = nand_get_manufacturer_data(chip); in micron_nand_on_die_ecc_status_4() local
242 ret = nand_read_page_op(chip, page, 0, micron->ecc.rawbuf, in micron_nand_on_die_ecc_status_4()
[all …]
|
| /kernel/linux/linux-4.19/drivers/staging/mt29f_spinand/ |
| D | Kconfig | 2 tristate "SPINAND Device Support for Micron"
5 This enables support for accessing Micron SPI NAND flash
7 If you have Micron SPI NAND chip say yes.
16 Enables Hardware ECC support for Micron SPI NAND.
|
| D | mt29f_spinand.h | 4 * Copyright (c) 2009-2010 Micron Technology, Inc.
15 * Henry Pan <hspan@micron.com>
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/media/i2c/ |
| D | mt9m111.txt | 1 Micron 1.3Mp CMOS Digital Image Sensor
3 The Micron MT9M111 is a CMOS active pixel digital image sensor with an active
8 - compatible: value should be "micron,mt9m111"
19 compatible = "micron,mt9m111";
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/media/i2c/ |
| D | mt9m111.txt | 1 Micron 1.3Mp CMOS Digital Image Sensor
3 The Micron MT9M111 is a CMOS active pixel digital image sensor with an active
8 - compatible: value should be "micron,mt9m111"
25 compatible = "micron,mt9m111";
|
| /kernel/linux/linux-4.19/drivers/media/i2c/soc_camera/ |
| D | Kconfig | 7 This driver supports MT9M001 cameras from Micron, monochrome
16 Micron/Aptina.
30 This driver supports MT9V022 cameras from Micron
|
| /kernel/linux/linux-4.19/drivers/mtd/nand/spi/ |
| D | micron.c | 3 * Copyright (c) 2016-2017 Micron Technology, Inc.
6 * Peter Pan <peterpandong@micron.com>
111 * Micron SPI NAND read ID need a dummy byte, in micron_spinand_detect()
131 .name = "Micron",
|
| /kernel/linux/linux-5.10/drivers/block/mtip32xx/ |
| D | Kconfig | 7 tristate "Block Device Driver for Micron PCIe SSDs"
10 This enables the block driver for Micron PCIe SSDs.
|
| D | Makefile | 3 # Makefile for Block device driver for Micron PCIe SSD
|
| /kernel/linux/linux-4.19/drivers/block/mtip32xx/ |
| D | Kconfig | 7 tristate "Block Device Driver for Micron PCIe SSDs"
10 This enables the block driver for Micron PCIe SSDs.
|
| D | Makefile | 2 # Makefile for Block device driver for Micron PCIe SSD
|
| /kernel/linux/linux-5.10/drivers/staging/media/atomisp/i2c/ |
| D | Kconfig | 45 This is a Video4Linux2 sensor-level driver for the Micron
77 This is a Video4Linux2 sensor-level driver for the Micron
|
| /kernel/linux/linux-5.10/arch/powerpc/platforms/powermac/ |
| D | nvram.c | 41 /* On Core99, nvram is either a sharp, a micron or an AMD flash */
287 DBG("nvram: Sharp/Micron Erasing bank %d...\n", bank); in sm_erase_bank()
294 printk(KERN_ERR "nvram: Sharp/Micron flash erase timeout !\n"); in sm_erase_bank()
305 printk(KERN_ERR "nvram: Sharp/Micron flash erase failed !\n"); in sm_erase_bank()
318 DBG("nvram: Sharp/Micron Writing bank %d...\n", bank); in sm_write_bank()
327 printk(KERN_ERR "nvram: Sharp/Micron flash write timeout !\n"); in sm_write_bank()
339 printk(KERN_ERR "nvram: Sharp/Micron flash write failed !\n"); in sm_write_bank()
|
| /kernel/linux/linux-4.19/arch/powerpc/platforms/powermac/ |
| D | nvram.c | 45 /* On Core99, nvram is either a sharp, a micron or an AMD flash */
286 DBG("nvram: Sharp/Micron Erasing bank %d...\n", bank); in sm_erase_bank()
293 printk(KERN_ERR "nvram: Sharp/Micron flash erase timeout !\n"); in sm_erase_bank()
304 printk(KERN_ERR "nvram: Sharp/Micron flash erase failed !\n"); in sm_erase_bank()
317 DBG("nvram: Sharp/Micron Writing bank %d...\n", bank); in sm_write_bank()
326 printk(KERN_ERR "nvram: Sharp/Micron flash write timeout !\n"); in sm_write_bank()
338 printk(KERN_ERR "nvram: Sharp/Micron flash write failed !\n"); in sm_write_bank()
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/mtd/ |
| D | fsl-quadspi.txt | 53 compatible = "micron,n25q256a", "jedec,spi-nor";
61 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| /kernel/linux/linux-5.10/drivers/media/i2c/ |
| D | Kconfig | 1079 This driver supports MT9M001 cameras from Micron, monochrome
1098 Micron/Aptina
1108 (Micron) mt9p031 5 Mpixel camera.
1117 (Micron) mt0t001 3 Mpixel camera.
1124 (Micron) MT9T111 and MT9T112 3 Mpixel camera.
1130 tristate "Micron mt9v011 sensor support"
1133 This is a Video4Linux2 sensor driver for the Micron
1138 tristate "Micron MT9V032 sensor support"
1145 This is a Video4Linux2 sensor driver for the Micron
1152 This is a Video4Linux2 sensor driver for the Aptina/Micron
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/spi/ |
| D | spi-fsl-qspi.txt | 54 compatible = "micron,n25q256a", "jedec,spi-nor";
62 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| /kernel/linux/linux-4.19/drivers/media/i2c/ |
| D | Kconfig | 830 Micron/Aptina
839 (Micron) mt9p031 5 Mpixel camera.
847 (Micron) mt0t001 3 Mpixel camera.
855 (Micron) MT9T111 and MT9T112 3 Mpixel camera.
861 tristate "Micron mt9v011 sensor support"
865 This is a Video4Linux2 sensor driver for the Micron
870 tristate "Micron MT9V032 sensor support"
876 This is a Video4Linux2 sensor driver for the Micron
884 This is a Video4Linux2 sensor driver for the Aptina/Micron
|
| /kernel/linux/linux-5.10/drivers/mtd/nand/spi/ |
| D | micron.c | 3 * Copyright (c) 2016-2017 Micron Technology, Inc.
6 * Peter Pan <peterpandong@micron.com>
241 .name = "Micron",
|
| /kernel/linux/linux-4.19/arch/arm/boot/dts/ |
| D | imx6sx-sdb.dts | 118 compatible = "micron,n25q256a", "jedec,spi-nor";
126 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | imx6sx-sdb.dts | 114 compatible = "micron,n25q256a", "jedec,spi-nor";
124 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| /kernel/linux/linux-4.19/drivers/media/usb/em28xx/ |
| D | em28xx-camera.c | 25 /* Possible i2c addresses of Micron sensors */
90 * Probes Micron sensors with 8 bit address and 16 bit register width
121 /* Validate chip ID to be sure we have a Micron device */ in em28xx_probe_sensor_micron()
156 "unknown Micron sensor detected: 0x%04x\n", in em28xx_probe_sensor_micron()
|
| /kernel/linux/linux-5.10/drivers/media/usb/em28xx/ |
| D | em28xx-camera.c | 25 /* Possible i2c addresses of Micron sensors */
90 * Probes Micron sensors with 8 bit address and 16 bit register width
121 /* Validate chip ID to be sure we have a Micron device */ in em28xx_probe_sensor_micron()
156 "unknown Micron sensor detected: 0x%04x\n", in em28xx_probe_sensor_micron()
|
| /kernel/linux/linux-4.19/drivers/staging/media/mt9t031/ |
| D | Kconfig | 5 This driver supports MT9T031 cameras from Micron.
|