| /kernel/linux/linux-5.10/Documentation/devicetree/ |
| D | overlay-notes.rst | 34 ocp: ocp {
47 &ocp {
68 ocp: ocp {
85 If the base DT was not compiled with the -@ option then the "&ocp" label
96 &{/ocp} {
|
| /kernel/linux/linux-5.10/include/linux/ssb/ |
| D | ssb_driver_gige.h | 17 #define SSB_GIGE_SHIM_FLUSHSTAT 0x0C00 /* PCI to OCP: Flush status control (32bit) */
18 #define SSB_GIGE_SHIM_FLUSHRDA 0x0C04 /* PCI to OCP: Flush read address (32bit) */
19 #define SSB_GIGE_SHIM_FLUSHTO 0x0C08 /* PCI to OCP: Flush timeout counter (32bit) */
20 #define SSB_GIGE_SHIM_BARRIER 0x0C0C /* PCI to OCP: Barrier register (32bit) */
21 #define SSB_GIGE_SHIM_MAOCPSI 0x0C10 /* PCI to OCP: MaocpSI Control (32bit) */
22 #define SSB_GIGE_SHIM_SIOCPMA 0x0C14 /* PCI to OCP: SiocpMa Control (32bit) */
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | qcom-pm8941.dtsi | 163 interrupt-names = "ocp-5vs1", "ocp-5vs2";
176 qcom,ocp-max-retries = <10>;
177 qcom,ocp-retry-delay = <30>;
186 qcom,ocp-max-retries = <10>;
187 qcom,ocp-retry-delay = <30>;
|
| D | omap34xx.dtsi | 81 ocp@68000000 {
154 * On omap34xx the OCP registers do not seem to be accessible
156 * "OCP bypass mode", or maybe there is OCP_SYSCONFIG that is
158 * revision register instead of the unreadable OCP revision
|
| D | am3517.dtsi | 54 ocp@68000000 {
128 * On am3517 the OCP registers do not seem to be accessible
130 * "OCP bypass mode", or maybe there is OCP_SYSCONFIG that is
132 * revision register instead of the unreadable OCP revision
|
| D | omap2430.dtsi | 16 ocp {
182 interrupts = <64>, /* OCP compliant interrupt */
199 interrupts = <16>, /* OCP compliant interrupt */
215 interrupts = <17>, /* OCP compliant interrupt */
231 interrupts = <18>, /* OCP compliant interrupt */
247 interrupts = <19>, /* OCP compliant interrupt */
|
| D | omap443x.dtsi | 35 ocp {
47 ocp {
|
| /kernel/linux/linux-4.19/include/linux/ssb/ |
| D | ssb_driver_gige.h | 17 #define SSB_GIGE_SHIM_FLUSHSTAT 0x0C00 /* PCI to OCP: Flush status control (32bit) */
18 #define SSB_GIGE_SHIM_FLUSHRDA 0x0C04 /* PCI to OCP: Flush read address (32bit) */
19 #define SSB_GIGE_SHIM_FLUSHTO 0x0C08 /* PCI to OCP: Flush timeout counter (32bit) */
20 #define SSB_GIGE_SHIM_BARRIER 0x0C0C /* PCI to OCP: Barrier register (32bit) */
21 #define SSB_GIGE_SHIM_MAOCPSI 0x0C10 /* PCI to OCP: MaocpSI Control (32bit) */
22 #define SSB_GIGE_SHIM_SIOCPMA 0x0C14 /* PCI to OCP: SiocpMa Control (32bit) */
|
| /kernel/linux/linux-5.10/drivers/net/slip/ |
| D | slhc.c | 221 * ocp is a place to put a copy if necessary.
223 * change it to ocp.
228 unsigned char *ocp, unsigned char **cpp, int compress_cid) in slhc_compress() argument
452 cp = ocp; in slhc_compress()
453 *cpp = ocp; in slhc_compress()
458 cp = ocp; in slhc_compress()
459 *cpp = ocp; in slhc_compress()
468 ocp[0] |= SL_TYPE_COMPRESSED_TCP; in slhc_compress()
469 return isize - hlen + deltaS + (cp - ocp); in slhc_compress()
484 memcpy(ocp, icp, isize); in slhc_compress()
[all …]
|
| /kernel/linux/linux-4.19/drivers/net/slip/ |
| D | slhc.c | 221 * ocp is a place to put a copy if necessary.
223 * change it to ocp.
228 unsigned char *ocp, unsigned char **cpp, int compress_cid) in slhc_compress() argument
452 cp = ocp; in slhc_compress()
453 *cpp = ocp; in slhc_compress()
458 cp = ocp; in slhc_compress()
459 *cpp = ocp; in slhc_compress()
468 ocp[0] |= SL_TYPE_COMPRESSED_TCP; in slhc_compress()
469 return isize - hlen + deltaS + (cp - ocp); in slhc_compress()
484 memcpy(ocp, icp, isize); in slhc_compress()
[all …]
|
| /kernel/linux/linux-4.19/Documentation/devicetree/ |
| D | overlay-notes.txt | 30 ocp: ocp {
44 target = <&ocp>;
68 ocp: ocp {
|
| /kernel/linux/linux-4.19/arch/arm/boot/dts/ |
| D | omap2430.dtsi | 16 ocp {
169 interrupts = <64>, /* OCP compliant interrupt */
186 interrupts = <16>, /* OCP compliant interrupt */
202 interrupts = <17>, /* OCP compliant interrupt */
218 interrupts = <18>, /* OCP compliant interrupt */
234 interrupts = <19>, /* OCP compliant interrupt */
|
| D | qcom-pm8941.dtsi | 196 interrupt-names = "ocp-5vs1", "ocp-5vs2";
209 qcom,ocp-max-retries = <10>;
210 qcom,ocp-retry-delay = <30>;
|
| D | omap443x.dtsi | 35 ocp {
45 ocp {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/power/supply/ |
| D | bq25980.yaml | 49 ti,sc-ocp-limit-microamp:
62 ti,bypass-ocp-limit-microamp:
108 ti,sc-ocp-limit-microamp = <2000000>;
|
| /kernel/linux/linux-4.19/arch/arm/mach-omap2/ |
| D | omap_hwmod.h | 51 * OCP SYSCONFIG bit shifts/masks TYPE1. These are for IPs compliant
68 * OCP SYSCONFIG bit shifts/masks TYPE2. These are for IPs compliant
81 * OCP SYSCONFIG bit shifts/masks TYPE3.
89 /* OCP SYSSTATUS bit shifts/masks */
226 * struct omap_hwmod_ocp_if - OCP interface data
227 * @master: struct omap_hwmod that initiates OCP transactions on this link
228 * @slave: struct omap_hwmod that responds to OCP transactions on this link
233 * @width: OCP data width
235 * @flags: OCP interface flags (see OCPIF_* macros above)
552 * @response_lat: device OCP response latency (in interface clock cycles)
[all …]
|
| /kernel/linux/linux-5.10/arch/arm/mach-omap2/ |
| D | omap_hwmod.h | 47 * OCP SYSCONFIG bit shifts/masks TYPE1. These are for IPs compliant
64 * OCP SYSCONFIG bit shifts/masks TYPE2. These are for IPs compliant
77 * OCP SYSCONFIG bit shifts/masks TYPE3.
85 /* OCP SYSSTATUS bit shifts/masks */
222 * struct omap_hwmod_ocp_if - OCP interface data
223 * @master: struct omap_hwmod that initiates OCP transactions on this link
224 * @slave: struct omap_hwmod that responds to OCP transactions on this link
229 * @width: OCP data width
231 * @flags: OCP interface flags (see OCPIF_* macros above)
550 * @response_lat: device OCP response latency (in interface clock cycles)
[all …]
|
| /kernel/linux/linux-5.10/arch/mips/lantiq/xway/ |
| D | clk.c | 152 /* OCP ratio 1 */ in ltq_vr9_fpi_hz()
156 /* OCP ratio 2 */ in ltq_vr9_fpi_hz()
160 /* OCP ratio 2.5 */ in ltq_vr9_fpi_hz()
164 /* OCP ratio 3 */ in ltq_vr9_fpi_hz()
|
| /kernel/linux/linux-4.19/arch/mips/lantiq/xway/ |
| D | clk.c | 154 /* OCP ratio 1 */ in ltq_vr9_fpi_hz()
158 /* OCP ratio 2 */ in ltq_vr9_fpi_hz()
162 /* OCP ratio 2.5 */ in ltq_vr9_fpi_hz()
166 /* OCP ratio 3 */ in ltq_vr9_fpi_hz()
|
| /kernel/linux/linux-4.19/fs/freevxfs/ |
| D | vxfs_olt.c | 108 struct vxfs_oltcommon *ocp = in vxfs_read_olt() local
111 switch (fs32_to_cpu(infp, ocp->olt_type)) { in vxfs_read_olt()
120 oaddr += fs32_to_cpu(infp, ocp->olt_size); in vxfs_read_olt()
|
| /kernel/linux/linux-5.10/fs/freevxfs/ |
| D | vxfs_olt.c | 108 struct vxfs_oltcommon *ocp = in vxfs_read_olt() local
111 switch (fs32_to_cpu(infp, ocp->olt_type)) { in vxfs_read_olt()
120 oaddr += fs32_to_cpu(infp, ocp->olt_size); in vxfs_read_olt()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | omap-mcbsp.txt | 14 <OCP compliant irq>,
28 interrupts = <0 17 0x4>, /* OCP compliant interrupt */
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/sound/ |
| D | omap-mcbsp.txt | 14 <OCP compliant irq>,
28 interrupts = <0 17 0x4>, /* OCP compliant interrupt */
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/regulator/ |
| D | qcom,spmi-regulator.txt | 16 Definition: List of OCP interrupts.
23 Supported values are "ocp-<regulator_name>", where
162 - qcom,ocp-max-retries:
169 - qcom,ocp-retry-delay:
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/ |
| D | qcom,spmi-regulator.txt | 22 Definition: List of OCP interrupts.
29 Supported values are "ocp-<regulator_name>", where
240 - qcom,ocp-max-retries:
247 - qcom,ocp-retry-delay:
|