Searched full:ib1 (Results 1 – 15 of 15) sorted by relevance
10 * named "IB1" or "IB2" (Interface Board 1 & 2 respectively.) They14 * - The IB1 is a passive board where the display connector defines a128 * found on the Versatile AB IB1 connector or the Versatile151 * found on the Versatile AB IB1 connector or the Versatile
24 to an IB1 interface board for a touchscreen-type use case or an IB2
29 #define GFX_10_1__SRCID__CP_IB1_INTERRUPT_PKT 177 // B1 CP_INTERRUPT pkt in IB1
31 #define GFX_9_0__SRCID__CP_IB1_INTERRUPT_PKT 177 /* B1 CP_INTERRUPT pkt in IB1 */
46 that are run from RB instead of IB1. This essentially gives
523 * RxEq and DDS in tables used by IBC in IB1.2 mode in qib_sd7220_init()957 * Set the "negotiation" values for SERDES. These are used by the IB1.21188 * Set the Tx values normally modified by IBC in IB1.2 mode to default1211 * Set the Rx values normally modified by IBC in IB1.2 mode to default
282 #define QIB_IB_CFG_LINKLATENCY 8 /* Link Latency (IB1.2 only) */
2974 * only works for single port if IB1 != pidx1 in unknown_7322_gpio_intr()8362 /* used for IB1 or IB2, only one in use */8374 /* used when both IB1 and IB2 are in use */8386 /* used when only IB1 is in use */8410 /* used when both IB1 and IB2 are in use */
2451 * If we turn off IB1.2, need to preset SerDes defaults, in qib_7220_set_ib_cfg()3491 * Required for older non-IB1.2 DDR switches. Newer in try_7220_autoneg()
330 /* CP ROQ queue sizes (bytes) - RB:16, ST:16, IB1:32, IB2:64 */ in a3xx_hw_init()
1052 …"gpu fault ring %d fence %x status %8.8X rb %4.4x/%4.4x ib1 %16.16llX/%4.4x ib2 %16.16llX/%4.4x\n", in a6xx_fault_detect_irq()
1060 …DRM_DEV_ERROR(dev->dev, "gpu fault ring %d fence %x status %8.8X rb %4.4x/%4.4x ib1 %16.16llX/%4.4… in a5xx_fault_detect_irq()
4086 * 177 - CP_INT IB14291 case 177: /* CP_INT in IB1 */ in r600_irq_process()
4858 case 177: /* CP_INT in IB1 */ in evergreen_irq_process()
597 #define HFI1_IB_CFG_LINKLATENCY 8 /* Link Latency (IB1.2 only) */