Lines Matching refs:flash

8 flash layout set at production time. Some may use on-flash table that describes
13 method is used for a given flash device. To describe the method there should be
14 a subnode of the flash device that is named 'partitions'. It must have a
30 Partitions can be represented by sub-nodes of a flash device. This can be used
31 on platforms which have strong conventions about which portions of a flash are
32 used for what purposes, but which don't use an on-flash partition table such
35 The partition table should be a subnode of the flash node and should be named
40 For backwards compatibility partitions as direct subnodes of the flash device are
46 flash device. There are two valid values for both:
53 - reg : The partition's offset and size within the flash
59   partition should only be mounted read-only. This is usually used for flash
71 flash@0 {
89 flash@1 {
103 flash@2 {
123 flash@3 {