Lines Matching +full:uniphier +full:- +full:system +full:- +full:bus
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
111 supports spi-mem interface.
178 With a few GPIO pins, your system can bitbang the SPI protocol.
181 this code to manage the per-word or per-transfer accesses to the
211 Flash over 1/2/4-bit wide bus. Enable this option if you have a
219 This enables dedicated general purpose SPI/Microwire1-compatible
220 master mode interface (SSI1) for CLPS711X-based CPUs.
230 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
234 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
252 tristate "Memory-mapped io interface driver for DW SPI core"
256 tristate "Baikal-T1 SPI driver for DW SPI core"
261 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
264 part of the Baikal-T1 System Boot Controller has got a very
266 chip-select and Tx/Rx FIFO with just 8 words depth available.
267 The later one is normally connected to an external SPI-nor flash
271 bool "Directly mapped Baikal-T1 Boot SPI flash support"
275 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
277 reading/writing data from/to it. Note that the system APB bus
280 time-critical tasks (like the SPI memory operations implemented
286 tristate "Diolan DLN-2 USB SPI adapter"
293 will be called spi-dln2.
313 The external bus unit (EBU) found on the FALC-ON SoC has SPI
322 This enables support for the driver for FSI bus attached SPI
340 supports the high-level SPI memory interface.
358 supports the high-level SPI memory interface.
361 tristate "GPIO-based bitbanging SPI Master"
365 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
367 slaves connected to a bus using this driver are configured as usual,
391 tristate "J-Core SPI Master"
394 This enables support for the SPI master controller in the J-Core
407 tristate "ICP DAS LP-8841 SPI Controller for RTC"
411 DS-1302 real time clock.
414 LP-8x4x industrial computer.
417 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
493 This selects the MediaTek(R) SPI bus driver.
522 supports spi-mem interface.
610 controller. If you have an embedded system with an AMBA(R)
611 bus and a PL022 controller, say Y or M here.
650 tristate "Renesas RPC-IF SPI driver"
653 SPI driver for Renesas R-Car Gen3 RPC-IF.
673 for serial peripheral interface (SPI) mini-core. SPI in master
686 yes to this option, support will be included for the built-in SPI
690 will be called spi-geni-qcom.
700 bool "S3C24XX driver with FIQ pseudo-DMA"
705 DMA by using the fast-interrupt request framework, This allows
706 the driver to get DMA-like performance when there are either
801 supports spi-mem interface.
804 tristate "STMicroelectronics SPI SSC-based driver"
829 that use the de-facto standard SPI protocol.
831 It also supports the new dual-bit and quad-bit SPI protocol.
882 SPI driver for the Topcliff PCH (Platform Controller Hub) SPI bus
895 tristate "Socionext UniPhier SPI Controller"
899 This enables a driver for the Socionext UniPhier SoC SCSSI SPI controller.
901 UniPhier SoCs have SCSSI and MCSSI SPI controllers.
902 Every UniPhier SoC has SCSSI which supports single channel.
903 Older UniPhier Pro4/Pro5 also has MCSSI which support multiple channels.
909 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
912 Support for the SPI-I2C bridge found on the Analog Devices
913 AD-FMCOMMS1-EBZ board.
983 select one or more specific mux-controller drivers.
1030 If your system has a slave-capable SPI controller, you can enable
1042 tristate "SPI slave handler controlling system state"
1044 SPI slave handler to allow remote control of system reboot, power