Searched +full:1 +full:c00000 (Results 1 – 25 of 110) sorted by relevance
12345
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mtd/ |
| D | ingenic,nand.yaml | 28 minItems: 1
44 maxItems: 1
48 maxItems: 1
63 #size-cells = <1>;
64 ranges = <1 0 0x1b000000 0x1000000>,
73 nand-controller@1 {
75 reg = <1 0 0x1000000>;
77 #address-cells = <1>;
91 nand@1 {
92 reg = <1>;
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/display/exynos/ |
| D | samsung-fimd.txt | 41 - display-timings: timing settings for FIMD, as described in document [1].
53 If not specified, the default value(1) will be used.
63 | cs-setup+1 | : : :
66 | wr-setup+1 | | wr-hold+1 |
69 | wr-active+1|
77 1 - for CAMIF1 input,
82 [1]: Documentation/devicetree/bindings/display/panel/display-timing.txt
89 fimd@11c00000 {
94 interrupts = <11 0>, <11 1>, <11 2>;
103 fimd@11c00000 {
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | socfpga_arria10_socdk_nand.dts | 14 #address-cells = <1>;
15 #size-cells = <1>;
21 partition@1c00000 {
|
| D | openbmc-flash-layout.dtsi | 5 #address-cells = <1>;
6 #size-cells = <1>;
28 rwfs@1c00000 {
|
| D | facebook-bmc-flash-layout.dtsi | 6 #address-cells = <1>;
7 #size-cells = <1>;
28 data0@1c00000 {
|
| D | da850-enbw-cmc.dts | 15 soc@1c00000 {
|
| D | qcom-msm8660-surf.dts | 19 gsbi@19c00000 {
56 MATRIX_KEY(0, 1, KEY_UP)
59 MATRIX_KEY(1, 0, KEY_FN_F2)
60 MATRIX_KEY(1, 1, KEY_RIGHT)
61 MATRIX_KEY(1, 2, KEY_DOWN)
62 MATRIX_KEY(1, 3, KEY_VOLUMEDOWN)
65 MATRIX_KEY(4, 1, KEY_UP)
70 MATRIX_KEY(5, 1, KEY_RIGHT)
|
| D | imx1-apf9328.dts | 53 #address-cells = <1>;
54 #size-cells = <1>;
57 eth: eth@4,c00000 {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/rng/ |
| D | xiphera,xip8001b-trng.yaml | 20 maxItems: 1
30 rng@43c00000 {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/dma/ |
| D | zxdma.txt | 7 - #dma-cells: see dma.txt, should be 1, para number
16 dma: dma-controller@09c00000{
21 #dma-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mfd/ |
| D | xylon,logicvc.yaml | 27 maxItems: 1
30 const: 1
33 const: 1
57 logicvc: logicvc@43c00000 {
|
| D | syscon.yaml | 60 maxItems: 1
67 enum: [1, 2, 4, 8]
70 maxItems: 1
82 syscon: syscon@1c00000 {
91 hwlocks = <&hwlock1 1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/ |
| D | xylon,logicvc-gpio.yaml | 35 maxItems: 1
43 minItems: 1
56 logicvc: logicvc@43c00000 {
60 #address-cells = <1>;
61 #size-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mailbox/ |
| D | ti,secure-proxy.txt | 20 - #mbox-cells Shall be 1 and shall refer to the transfer path
31 secure_proxy: mailbox@32c00000 {
33 #mbox-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/remoteproc/ |
| D | wkup_m3_rproc.txt | 35 l4_wkup: l4_wkup@44c00000 {
38 #address-cells = <1>;
39 #size-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/soc/ti/ |
| D | wkup_m3_ipc.txt | 35 l4_wkup: l4_wkup@44c00000 {
41 #address-cells = <1>;
42 #size-cells = <1>;
|
| /kernel/linux/linux-5.10/arch/microblaze/boot/dts/ |
| D | system.dts | 18 #address-cells = <1>;
19 #size-cells = <1>;
35 #address-cells = <1>;
119 #address-cells = <1>;
120 #size-cells = <1>;
129 xlnx,include-datawidth-matching-1 = <0x0>;
159 xlnx,synch-mem-1 = <0x0>;
163 xlnx,synch-pipedelay-1 = <0x2>;
167 xlnx,tavdv-ps-mem-1 = <0x3a98>;
171 xlnx,tcedv-ps-mem-1 = <0x3a98>;
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/display/ |
| D | arm,komeda.txt | 11 - #address-cells: Must be 1
41 dp0: display@c00000 {
42 #address-cells = <1>;
49 iommus = <&smmu 0>, <&smmu 1>, <&smmu 2>, <&smmu 3>,
65 dp0_pipe1: pipeline@1 {
68 reg = <1>;
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/nvidia/ |
| D | tegra186-p3310.dtsi | 44 #address-cells = <1>;
59 memory-controller@2c00000 {
73 #address-cells = <1>;
82 channel@1 {
98 #address-cells = <1>;
107 channel@1 {
160 hsp@3c00000 {
198 cpu@1 {
265 drive-push-pull = <1>;
277 drive-push-pull = <1>;
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/media/ |
| D | qcom,msm8996-venus.yaml | 22 maxItems: 1
25 maxItems: 1
28 maxItems: 1
44 maxItems: 1
54 maxItems: 1
61 maxItems: 1
79 maxItems: 1
86 maxItems: 1
105 maxItems: 1
129 video-codec@c00000 {
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/iommu/ |
| D | qcom,iommu.txt | 23 - #address-cells : must be 1.
25 - #size-cells : must be 1.
27 - #iommu-cells : Must be 1. Index identifies the context-bank #.
53 apps_iommu: iommu@1e20000 {
54 #address-cells = <1>;
55 #size-cells = <1>;
56 #iommu-cells = <1>;
80 gpu_iommu: iommu@1f08000 {
81 #address-cells = <1>;
82 #size-cells = <1>;
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/bus/ |
| D | socionext,uniphier-system-bus.yaml | 28 maxItems: 1
37 const: 1
61 "^.*@[1-5],[1-9a-f][0-9a-f]+$":
82 system-bus@58c00000 {
86 #size-cells = <1>;
87 ranges = <1 0x00000000 0x42000000 0x02000000>,
90 ethernet@1,1f00000 {
92 reg = <1 0x01f00000 0x1000>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/memory-controllers/ |
| D | nvidia,tegra186-mc.yaml | 36 maxItems: 1
39 maxItems: 1
68 maxItems: 1
71 maxItems: 1
104 memory-controller@2c00000 {
134 #clock-cells = <1>;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/net/ |
| D | xilinx_axienet.txt | 4 Also called AXI 1G/2.5G Ethernet Subsystem, the xilinx axi ethernet IP core
38 1 to enable partial TX checksum offload,
56 axi_ethernet_eth: ethernet@40c00000 {
60 interrupts = <2 0 1>;
69 #address-cells = <1>;
73 reg = <1>;
|
| /kernel/linux/linux-5.10/arch/mips/boot/dts/ingenic/ |
| D | ci20.dts | 59 gpios = <&gpc 1 GPIO_ACTIVE_HIGH>;
84 wlan0_power: fixedregulator@1 {
118 brcmf: wifi@1 {
302 nandc: nand-controller@1 {
304 reg = <1 0 0x1000000>;
306 #address-cells = <1>;
324 nand@1 {
325 reg = <1>;
355 partition@c00000 {
360 partition@4c00000 {
[all …]
|
12345