| /kernel/linux/linux-5.10/drivers/staging/sm750fb/ |
| D | ddk750_sii164.c | 80 * 0 = Input data is falling edge latched (falling
81 * edge latched first in dual edge mode)
82 * 1 = Input data is rising edge latched (rising
83 * edge latched first in dual edge mode)
88 * 0 = Input data is single edge latched
89 * 1 = Input data is dual edge latched
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | tlv320adcx140.yaml | 69 0 - (default) Odd channel is latched on the negative edge and even
70 channel is latched on the the positive edge.
71 1 - Odd channel is latched on the positive edge and even channel is
72 latched on the the negative edge.
|
| /kernel/linux/linux-5.10/arch/x86/kernel/ |
| D | nmi.c | 132 * can be latched at any given time. Walk the whole list in nmi_handle()
384 * Only one NMI can be latched at a time. To handle in default_do_nmi()
388 * while its real NMI is sitting latched. This will cause in default_do_nmi()
435 * 3) latched
447 * first one finishes. We set the state to "latched", and the exit of
452 * rerun the NMI handler again, and restart the 'latched' NMI.
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/broadcom/bnx2x/ |
| D | bnx2x_init.h | 639 /* [28] MCP Latched rom_parity
640 * [29] MCP Latched ump_rx_parity
641 * [30] MCP Latched ump_tx_parity
642 * [31] MCP Latched scpad_parity
761 * [7] clears Latched rom_parity in bnx2x_clear_blocks_parity()
762 * [8] clears Latched ump_rx_parity in bnx2x_clear_blocks_parity()
763 * [9] clears Latched ump_tx_parity in bnx2x_clear_blocks_parity()
764 * [10] clears Latched scpad_parity (both ports) in bnx2x_clear_blocks_parity()
|
| D | bnx2x_reg.h | 1123 interrupt; [21] RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN
1124 Latched attn; [24] RBCU Latched attn; [25] RBCP Latched attn; [26] GRC
1125 Latched timeout attention; [27] GRC Latched reserved access attention;
1126 [28] MCP Latched rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP
1127 Latched ump_tx_parity; [31] MCP Latched scpad_parity; */
1137 RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN Latched attn; [24]
1138 RBCU Latched attn; [25] RBCP Latched attn; [26] GRC Latched timeout
1139 attention; [27] GRC Latched reserved access attention; [28] MCP Latched
1140 rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP Latched
1141 ump_tx_parity; [31] MCP Latched scpad_parity; */
[all …]
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/intel/i40e/ |
| D | i40e_ptp.c | 240 /* Update the jiffies time for any newly latched timestamp. This in i40e_ptp_get_rx_events()
242 * was latched by the hardware. The service task will later determine in i40e_ptp_get_rx_events()
245 * events latched since the last time we checked, and not all events in i40e_ptp_get_rx_events()
246 * currently latched, so that the service task accounting remains in i40e_ptp_get_rx_events()
287 /* Check all the currently latched Rx events and see whether they have in i40e_ptp_rx_hang()
288 * been latched for over a second. It is assumed that any timestamp in i40e_ptp_rx_hang()
291 * clear any timestamp that has been latched for over 1 second. in i40e_ptp_rx_hang()
433 /* Clear the latched event since we're about to read its register */ in i40e_ptp_rx_hwtstamp()
|
| /kernel/linux/linux-5.10/sound/soc/codecs/ |
| D | tas2770.h | 91 /* Latched-Interrupt Reg0 */
95 /* Latched-Interrupt Reg1 */
|
| D | l3.c | 23 * Send one byte of data to the chip. Data is latched into the chip on
|
| /kernel/linux/linux-5.10/drivers/staging/comedi/drivers/ |
| D | amplc_dio200_pci.c | 133 * 9. "Pattern occurred" latched signal, latches HIGH when pattern
135 * 10. "Pattern gone away" latched signal, latches LOW when pattern
139 * 12. Negated "pattern occurred" latched signal, latches LOW when
141 * 13. Negated "pattern gone away" latched signal, latches LOW when
|
| /kernel/linux/linux-5.10/include/linux/mtd/ |
| D | latch-addr-flash.h | 2 * Interface for NOR flash driver whose high address lines are latched
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/input/touchscreen/ |
| D | eeti.txt | 10 latched. This is necessary for platforms that lack
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | brcm,l2-intc.txt | 8 "brcm,l2-intc" for latched interrupt controllers
|
| /kernel/linux/linux-5.10/drivers/pwm/ |
| D | pwm-imx-tpm.c | 9 * - Changes to polarity cannot be latched at the time of the
209 * is latched into hardware when the next period starts. in pwm_imx_tpm_apply_hw()
229 * is latched into hardware when the next period starts. in pwm_imx_tpm_apply_hw()
|
| /kernel/linux/linux-5.10/Documentation/virt/kvm/devices/ |
| D | arm-vgic-v3.rst | 132 GICR_ISPENDR0 registers get/set the value of the latched pending state for
139 to ISPENDR) this state is "latched", and only cleared when either the
143 ISPENDR writes are latched; if the device lowers the line level then the
|
| /kernel/linux/linux-5.10/include/linux/ |
| D | rbtree_latch.h | 3 * Latched RB-trees
18 * implement a latched RB-tree which does allow for unconditional lookups by
|
| /kernel/linux/linux-5.10/include/linux/fsl/ |
| D | guts.h | 165 #define CCSR_GUTS_PMUXCR_SSI1_LA 0x00000000 /* Latched address */
169 #define CCSR_GUTS_PMUXCR_SSI2_LA 0x00000000 /* Latched address */
172 #define CCSR_GUTS_PMUXCR_LA_22_25_LA 0x00000000 /* Latched Address */
|
| /kernel/linux/linux-5.10/drivers/iio/gyro/ |
| D | mpu3050.h | 58 * @irq_latch: latched IRQ, this means that it is a level IRQ
|
| D | bmg160_core.c | 366 * New data interrupt is always non-latched, in bmg160_setup_any_motion_interrupt()
368 * to set latched mode, we will be flooded anyway with INTR in bmg160_setup_any_motion_interrupt()
911 /* Set latched mode interrupt and clear any latched interrupt */ in bmg160_trig_try_reen()
|
| /kernel/linux/linux-5.10/drivers/staging/greybus/ |
| D | audio_apbridgea.h | 17 * - RX data is received/latched on the rising edge of BCLK
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/aquantia/atlantic/ |
| D | aq_hw_utils.c | 57 Counters are normally implemented by HW as latched pairs:
|
| /kernel/linux/linux-5.10/tools/power/cpupower/debug/kernel/ |
| D | cpufreq-test_tsc.c | 40 * source is not latched, so you must read it multiple in read_pmtmr()
|
| /kernel/linux/linux-5.10/arch/arm/mach-integrator/ |
| D | integrator_cp.c | 67 * clear the latched interrupt.
|
| /kernel/linux/linux-5.10/drivers/scsi/aic7xxx/ |
| D | aic79xx_pci.c | 488 /* Silently clear any latched errors. */ in ahd_pci_test_register_access()
809 /* Clear latched errors. So our interrupt deasserts. */ in ahd_pci_intr()
865 /* Clear latched errors. So our interrupt deasserts. */ in ahd_pci_split_intr()
872 /* Clear latched errors. So our interrupt deasserts. */ in ahd_pci_split_intr()
|
| /kernel/linux/linux-5.10/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ |
| D | pmu.c | 143 /* Read the latched number of ALP ticks per 4 ILP ticks */ in si_pmu_measure_alpclk()
|
| /kernel/linux/linux-5.10/drivers/pci/ |
| D | vc.c | 46 * Status clears, hardware has latched the table into VC arbitration logic.
70 * Status clears, hardware has latched the table into port arbitration logic.
|