Home
last modified time | relevance | path

Searched full:tx1 (Results 1 – 25 of 105) sorted by relevance

12345

/kernel/linux/linux-5.10/tools/testing/selftests/timers/
Dadjtick.c118 struct timex tx1; in check_tick_adj() local
120 tx1.modes = ADJ_TICK; in check_tick_adj()
121 tx1.modes |= ADJ_OFFSET; in check_tick_adj()
122 tx1.modes |= ADJ_FREQUENCY; in check_tick_adj()
123 tx1.modes |= ADJ_STATUS; in check_tick_adj()
125 tx1.status = STA_PLL; in check_tick_adj()
126 tx1.offset = 0; in check_tick_adj()
127 tx1.freq = 0; in check_tick_adj()
128 tx1.tick = tickval; in check_tick_adj()
130 adjtimex(&tx1); in check_tick_adj()
[all …]
Draw_skew.c96 struct timex tx1, tx2; in main() local
105 tx1.modes = 0; in main()
106 adjtimex(&tx1); in main()
111 if (tx1.offset) in main()
132 ppm = (tx1.freq + tx2.freq) * 1000 / 2; in main()
133 ppm = (long long)tx1.freq * 1000; in main()
138 if (tx1.offset || tx2.offset || in main()
139 tx1.freq != tx2.freq || tx1.tick != tx2.tick) { in main()
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/net/can/
Dsja1000.txt36 <0x08> : TX1 invert
37 <0x10> : TX1 pull-down
38 <0x20> : TX1 pull-up
39 <0x30> : TX1 push-pull
Dcc770.txt35 - bosch,disconnect-tx1-output : see data sheet.
/kernel/linux/linux-5.10/Documentation/driver-api/dmaengine/
Dpxa_dma.rst21 This implies that even if an irq/tasklet is triggered by end of tx1, but
22 at the time of irq/dma tx2 is already finished, tx1->complete() and
146 - a driver submitted an aligned tx1, not chained
148 - a driver submitted an aligned tx2 => tx2 is cold chained to tx1
150 - a driver issued tx1+tx2 => channel is running in aligned mode
172 | tx1 | | tx2 | | tx3 | | tx4 |
/kernel/linux/linux-5.10/drivers/net/ethernet/8390/
Dlib8390.c348 if (ei_local->tx1 == 0) { in __ei_start_xmit()
350 ei_local->tx1 = send_length; in __ei_start_xmit()
360 ei_local->tx1 > 0) in __ei_start_xmit()
362 "idle transmitter, tx1=%d, lasttx=%d, txing=%d\n", in __ei_start_xmit()
363 ei_local->tx1, ei_local->lasttx, ei_local->txing); in __ei_start_xmit()
366 "No Tx buffers free! tx1=%d tx2=%d last=%d\n", in __ei_start_xmit()
367 ei_local->tx1, ei_local->tx2, ei_local->lasttx); in __ei_start_xmit()
389 ei_local->tx1 = -1; in __ei_start_xmit()
398 if (ei_local->tx1 && ei_local->tx2) in __ei_start_xmit()
594 if (ei_local->tx1 < 0) { in ei_tx_intr()
[all …]
Daxnet_cs.c991 if (ei_local->tx1 == 0) in axnet_start_xmit()
994 ei_local->tx1 = send_length; in axnet_start_xmit()
1007 ei_local->tx1 > 0) in axnet_start_xmit()
1009 "idle transmitter, tx1=%d, lasttx=%d, txing=%d\n", in axnet_start_xmit()
1010 ei_local->tx1, ei_local->lasttx, in axnet_start_xmit()
1016 "No Tx buffers free! tx1=%d tx2=%d last=%d\n", in axnet_start_xmit()
1017 ei_local->tx1, ei_local->tx2, in axnet_start_xmit()
1048 ei_local->tx1 = -1; in axnet_start_xmit()
1059 if (ei_local->tx1 && ei_local->tx2) in axnet_start_xmit()
1263 if (ei_local->tx1 < 0) in ei_tx_intr()
[all …]
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/
Dnvidia,tegra210-admaif.yaml58 Should be "tx1", "tx2" ... "tx10" for DMA Tx channel
74 Should be "tx1", "tx2" ... "tx20" for DMA Tx channel
101 dma-names = "rx1", "tx1",
Dfsl,spdif.yaml44 - description: Clock for tx1 and rx1.
/kernel/linux/linux-5.10/include/sound/
Dak4114.h82 #define AK4114_TX1E (1<<7) /* TX1 Output Enable (1 = enable) */
83 #define AK4114_OPS12 (1<<6) /* Output Data Selector for TX1 pin */
84 #define AK4114_OPS11 (1<<5) /* Output Data Selector for TX1 pin */
85 #define AK4114_OPS10 (1<<4) /* Output Data Selector for TX1 pin */
100 #define AK4114_DIT (1<<3) /* TX1 out: 0 = Through Data (RX data), 1 = Transmit Data (DAUX data) */
/kernel/linux/linux-5.10/sound/firewire/dice/
Ddice-alesis.c13 {8, 4, 0}, /* Tx1 = ADAT1. */
19 {16, 4, 0}, /* Tx1 = ADAT1 + ADAT2 (available at low rate). */
/kernel/linux/linux-5.10/arch/x86/crypto/
Dtwofish-x86_64-asm_64-3way.S93 #define g1g2_3(ab, cd, Tx0, Tx1, Tx2, Tx3, Ty0, Ty1, Ty2, Ty3, x, y) \ argument
95 do16bit_ror(32, mov, xor, Tx0, Tx1, RT0, x ## 0, ab ## 0, x ## 0); \
98 do16bit_ror(32, mov, xor, Tx0, Tx1, RT0, x ## 1, ab ## 1, x ## 1); \
101 do16bit_ror(32, mov, xor, Tx0, Tx1, RT0, x ## 2, ab ## 2, x ## 2); \
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/arm/freescale/
Dfsl,scu.txt24 - mbox-names: should include "tx0", "tx1", "tx2", "tx3",
36 Channel 1 must be "tx1" or "rx1".
196 mbox-names = "tx0", "tx1", "tx2", "tx3",
/kernel/linux/linux-5.10/sound/soc/codecs/
Dtwl4030.c471 /* TX1 L/R Analog/Digital microphone selection */
1128 SOC_DOUBLE_R_TLV("TX1 Digital Capture Volume",
1324 TX1 Left/Right: either analog Left/Right or Digimic0
1326 SND_SOC_DAPM_MUX("TX1 Capture Route", SND_SOC_NOPM, 0, 0,
1514 /* TX1 Left capture path */
1515 {"TX1 Capture Route", "Analog", "ADC Physical Left"},
1516 {"TX1 Capture Route", "Digimic0", "Digimic0 Enable"},
1517 /* TX1 Right capture path */
1518 {"TX1 Capture Route", "Analog", "ADC Physical Right"},
1519 {"TX1 Capture Route", "Digimic0", "Digimic0 Enable"},
[all …]
Dmsm8916-wcd-digital.c518 SOC_SINGLE_S8_TLV("TX1 Digital Volume", LPASS_CDC_TX1_VOL_CTL_GAIN,
522 SOC_ENUM("TX1 HPF Cutoff", tx1_hpf_cutoff_enum),
524 SOC_SINGLE("TX1 HPF Switch", LPASS_CDC_TX1_MUX_CTL, 3, 1, 0),
787 SND_SOC_DAPM_AIF_OUT("I2S TX1", NULL, 0, SND_SOC_NOPM, 0, 0),
937 {"AIF1 Capture", NULL, "I2S TX1"},
964 {"I2S TX1", NULL, "CIC1 MUX"},
967 {"I2S TX1", NULL, "TX_I2S_CLK"},
/kernel/linux/linux-5.10/arch/powerpc/boot/dts/
Dtqm8xx.dts76 bosch,disconnect-tx1-output;
88 bosch,disconnect-tx1-output;
/kernel/linux/linux-5.10/include/linux/can/platform/
Dsja1000.h8 #define CDR_RXINPEN 0x20 /* TX1 output is RX irq output */
Dcc770.h22 #define BUSCFG_DT1 0x08 /* Disconnect TX1 Output */
/kernel/linux/linux-5.10/include/linux/platform_data/
Dleds-lm355x.h48 * lm3554-tx1/torch/gpio1
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/net/
Dti,k3-am654-cpsw-nuss.yaml84 - const: tx1
202 dma-names = "tx0", "tx1", "tx2", "tx3", "tx4", "tx5", "tx6", "tx7",
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/usb/
Dam33xx-usb.txt135 "tx1", "tx2", "tx3", "tx4", "tx5", "tx6", "tx7",
181 "tx1", "tx2", "tx3", "tx4", "tx5", "tx6", "tx7",
Dda8xx-usb.txt66 "tx1", "tx2", "tx3", "tx4";
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/spi/
Domap-spi.txt47 dma-names = "tx0", "rx0", "tx1", "rx1";
/kernel/linux/linux-5.10/net/wireless/
DMakefile44 thisf=$$(od -An -v -tx1 < $$f | \
/kernel/linux/linux-5.10/arch/arm/boot/dts/
Domap2.dtsi145 dma-names = "tx0", "rx0", "tx1", "rx1",
155 dma-names = "tx0", "rx0", "tx1", "rx1";

12345