Searched full:swapping (Results 1 – 25 of 340) sorted by relevance
12345678910>>...14
| /kernel/linux/linux-5.10/drivers/mtd/maps/ |
| D | lantiq-flash.c | 26 * To make PCI work we need to enable the endianness swapping for the address
27 * written to the EBU. This endianness swapping works for PCI correctly but
29 * map. The workaround involves swapping all addresses whilst probing the chip.
30 * Once probing is complete we stop swapping the addresses but swizzle the
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/ |
| D | common-properties.txt | 8 byte swapping, but endianness issues show up frequently in porting drivers to
10 way of handling byte swapping across drivers.
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-class-typec | 8 requesting data role swapping on the port. Swapping is supported
23 power role swap on the port. Swapping is supported as
58 Swapping is supported as synchronous operation, so write(2) to
|
| D | sysfs-kernel-mm-swap | 4 Description: Interface for swapping
|
| D | sysfs-class-usb_role | 14 requesting role swapping with non-USB Type-C ports. With USB
|
| /kernel/linux/linux-5.10/Documentation/vm/ |
| D | frontswap.rst | 82 When a workload starts swapping, performance falls through the floor.
126 memory pressure may result in swapping; frontswap allows those pages
129 of unplanned swapping.
243 choose to accept pages only until host-swapping might be imminent,
244 then force guests to do their own swapping.
|
| /kernel/linux/linux-5.10/arch/mips/mti-malta/ |
| D | malta-init.c | 176 * Setup the North bridge to do Master byte-lane swapping in prom_init()
209 * Setup the North bridge to do Master byte-lane swapping in prom_init()
234 /* Fix up lane swapping. */ in prom_init()
|
| /kernel/linux/linux-5.10/drivers/input/mouse/ |
| D | sentelic.c | 102 /* swapping is required */ in fsp_reg_read()
106 /* swapping isn't necessary */ in fsp_reg_read()
144 /* swapping is required */ in fsp_reg_write()
147 /* swapping isn't necessary */ in fsp_reg_write()
161 /* swapping is required */ in fsp_reg_write()
164 /* swapping isn't necessary */ in fsp_reg_write()
259 /* swapping is required */ in fsp_page_reg_write()
262 /* swapping isn't necessary */ in fsp_page_reg_write()
|
| /kernel/linux/linux-5.10/arch/alpha/include/asm/ |
| D | a.out.h | 10 Worse, we have to notice the start address before swapping to use
|
| /kernel/linux/linux-5.10/drivers/input/touchscreen/ |
| D | of_touchscreen.c | 169 * swapping requested in the passed in touchscreen_properties and store
191 * swapping requested in the passed in touchscreen_properties and then
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mips/cavium/ |
| D | sata-uctl.txt | 13 - control endian swapping for all UAHC registers and DMA accesses
|
| /kernel/linux/linux-5.10/drivers/mtd/chips/ |
| D | Kconfig | 45 prompt "Flash cmd/query data swapping"
52 enabled, means that the CPU will not do any swapping; the chips
|
| /kernel/linux/linux-5.10/arch/sh/include/mach-common/mach/ |
| D | mangle-port.h | 11 * Sane hardware offers swapping of PCI/ISA I/O space accesses in hardware;
|
| /kernel/linux/linux-5.10/drivers/platform/mellanox/ |
| D | Kconfig | 53 request swapping the primary and alternate eMMC boot partition,
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/input/touchscreen/ |
| D | chipone_icn8318.txt | 22 Swapping is done after inverting the axis
|
| D | iqs5xx.txt | 53 - touchscreen-swapped-x-y : See [2]. Swapping is applied relative to that
|
| /kernel/linux/linux-5.10/drivers/usb/typec/ucsi/ |
| D | Kconfig | 11 the ports and support basic operations like role swapping, the driver
|
| /kernel/linux/linux-5.10/include/linux/soc/amlogic/ |
| D | meson-canvas.h | 59 * @endian: byte swapping (swap16, swap32, swap64, swap128)
|
| /kernel/linux/linux-5.10/include/soc/at91/ |
| D | atmel-sfr.h | 19 #define AT91_SFR_UTMISWAP 0x3c /* UTMI DP/DM Pin Swapping Register */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/misc/ |
| D | ifm-csi.txt | 17 - ifm,csi-byte-swap: if this property is present, the byte swapping on
|
| /kernel/linux/linux-5.10/include/linux/ |
| D | smsc911x.h | 46 * this swapping but the driver doesn't currently use them.
|
| /kernel/linux/linux-5.10/arch/mips/include/asm/mach-generic/ |
| D | mangle-port.h | 17 * Sane hardware offers swapping of PCI/ISA I/O space accesses in hardware;
|
| /kernel/linux/linux-5.10/include/uapi/linux/ |
| D | cciss_defs.h | 51 #define LEVEL2LUN 1 /* index into Target(x) structure, due to byte swapping */
|
| /kernel/linux/linux-5.10/arch/parisc/include/uapi/asm/ |
| D | swab.h | 46 ** See Appendix I page 8 , "Endian Byte Swapping".
|
| /kernel/linux/linux-5.10/drivers/vme/boards/ |
| D | vme_vmivme7805.c | 73 /* Enable the vme interface and byte swapping */ in vmic_probe()
|
12345678910>>...14