Searched full:microsecond (Results 1 – 25 of 105) sorted by relevance
12345
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/ |
| D | richtek,rtmv20-regulator.yaml | 38 load current pulse delay in microsecond after strobe pin pulse high.
45 Load current pulse width in microsecond after strobe pin pulse high.
52 Fsin1 pulse high delay in microsecond after vsync signal pulse high.
59 Fsin1 pulse high width in microsecond after vsync signal pulse high.
66 Fsin2 pulse high delay in microsecond after vsync signal pulse high.
73 Fsin2 pulse high width in microsecond after vsync signal pulse high.
79 description: Eye safety function pulse width limit in microsecond.
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/amd/display/include/ |
| D | ddc_service_types.h | 72 /* Maximum additional audio delay in microsecond (us) */
74 /* Audio latency value in microsecond (us) */
76 /* Interlace video latency value in microsecond (us) */
78 /* Progressive video latency value in microsecond (us) */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/input/rmi4/ |
| D | rmi_spi.txt | 21 - spi-rx-delay-us: microsecond delay after a read transfer.
22 - spi-tx-delay-us: microsecond delay after a write transfer.
|
| /kernel/linux/linux-5.10/arch/x86/include/asm/ |
| D | i8259.h | 38 * must be at least one microsecond, so be safe here: in inb_pic()
50 * must be at least one microsecond, so be safe here: in outb_pic()
|
| /kernel/liteos_a/kernel/include/ |
| D | los_tick.h | 138 * @brief spinning-delay in microsecond (us).
141 * This API is used to delay in microsecond.
145 * @param #UINT32 microsecond needs to delay.
|
| /kernel/liteos_m/kal/posix/include/ |
| D | rtc_time_hook.h | 55 * output: UINT64 *usec, pointer to get the time, value is counted in microsecond(us)
61 * input: UINT64 *usec, the time to be set counted in microsecond(us)
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/thermal/ |
| D | thermal-idle.yaml | 36 The idle duration in microsecond the device should cool down.
40 The exit latency constraint in microsecond for the injected idle state
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/rc/ |
| D | lirc-get-rec-resolution.rst | 36 signals can only be reported in 50 microsecond steps.
|
| /kernel/linux/linux-5.10/lib/ |
| D | Kconfig.kcsan | 114 For tasks, the microsecond delay after setting up a watchpoint.
120 For interrupts, the microsecond delay after setting up a watchpoint.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/ |
| D | property-units.txt | 18 -us : microsecond
|
| /kernel/liteos_a/kernel/base/include/ |
| D | los_oom.h | 54 UINT32 checkInterval; /* microsecond */
|
| D | los_sys_pri.h | 76 * Number of nanoseconds in one microsecond.
|
| /kernel/linux/linux-5.10/drivers/iio/light/ |
| D | cm3232.c | 127 * @val2: pointer of int to load the integration time (microsecond).
156 * @val2: integration time in microsecond.
|
| /kernel/linux/linux-5.10/include/linux/soc/mediatek/ |
| D | mtk-cmdq.h | 32 u32 timeout_ms; /* in unit of microsecond */
54 * @timeout: timeout of a pkt execution by GCE, in unit of microsecond, set
|
| /kernel/linux/linux-5.10/drivers/scsi/isci/ |
| D | probe_roms.h | 126 * activity in increments of a microsecond, it can be in increments of
143 * outbound traffic in increments of a microsecond.
|
| /kernel/liteos_m/kernel/src/ |
| D | los_tick.c | 369 Description : cycle convert to Microsecond
371 Output : usHi ---------- High 32 Microsecond
372 usLo ---------- Low 32 Microsecond
|
| /kernel/linux/linux-5.10/drivers/staging/comedi/drivers/ |
| D | comedi_test.c | 315 /* round convert_arg to nearest microsecond */ in waveform_ai_cmdtest()
330 /* round scan_begin_arg to nearest microsecond */ in waveform_ai_cmdtest()
572 /* round scan_begin_arg to nearest microsecond */ in waveform_ao_cmdtest()
730 "%s: %u microvolt, %u microsecond waveform attached\n", in waveform_common_attach()
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/amd/display/dc/ |
| D | dc_ddc_types.h | 62 /* delay, in 100-microsecond units */
|
| /kernel/linux/linux-5.10/arch/arm/mach-tegra/ |
| D | sleep.h | 42 /* waits until the microsecond counter (base) is > rn */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/ |
| D | gpio-eic-sprd.txt | 24 (microsecond resolution) to generate interrupts by level or edge trigger.
|
| /kernel/linux/linux-5.10/Documentation/trace/ |
| D | hwlat_detector.rst | 22 you are trying to keep event service latencies down in the microsecond range.
|
| /kernel/linux/linux-5.10/arch/m68k/include/asm/ |
| D | delay.h | 98 * per microsecond
|
| /kernel/linux/linux-5.10/drivers/scsi/ufs/ |
| D | ufshcd-dwc.c | 37 * provide 1 microsecond tick to unipro layer.
|
| /kernel/linux/linux-5.10/drivers/staging/rtl8188eu/include/ |
| D | hal_intf.h | 96 /* Unit in microsecond. 0 means disable this function. */
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/nouveau/nvkm/subdev/pmu/fuc/ |
| D | kernel.fuc | 277 // calculate the number of ticks in the specified microsecond delay
304 // calculate the number of ticks in the specified microsecond delay
|
12345