Searched full:routed (Results 1 – 25 of 338) sorted by relevance
12345678910>>...14
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/leds/ |
| D | leds-bcm6328.txt | 207 /* USB link/activity routed to USB LED */
213 /* INET activity routed to INET LED */
219 /* EPHY0 link routed to EPHY0 LED */
225 /* EPHY1 link routed to EPHY1 LED */
231 /* EPHY2 link routed to EPHY2 LED */
237 /* EPHY3 link routed to EPHY3 LED */
259 /* USB/INET link/activity routed to USB LED */
265 /* EPHY0/1/2/3 link routed to EPHY0 LED */
287 /* USB link/act and INET act routed to USB LED */
293 /* EPHY3 link routed to EPHY0 LED */
[all …]
|
| /kernel/linux/linux-5.10/include/linux/bcma/ |
| D | bcma_driver_mips.h | 6 /* which sbflags get routed to mips interrupt 1 */
9 /* which sbflags get routed to mips interrupt 2 */
12 /* which sbflags get routed to mips interrupt 3 */
15 /* which sbflags get routed to mips interrupt 4 */
|
| /kernel/linux/linux-5.10/Documentation/networking/devlink/ |
| D | devlink-trap.rst | 180 routed and they have a unicast destination IP and a multicast destination
185 routed and their destination IP is the loopback address (i.e., 127.0.0.0/8
190 routed and their source IP is multicast (i.e., 224.0.0.0/8 and ff::/8)
194 routed and their source IP is the loopback address (i.e., 127.0.0.0/8 and ::1/128)
198 routed and their IP header is corrupted: wrong checksum, wrong IP version
203 routed and their source IP is limited broadcast (i.e., 255.255.255.255/32)
207 be routed and their IPv6 multicast destination IP has a reserved scope
212 be routed and their IPv6 multicast destination IP has an interface-local scope
216 - Traps packets that should have been routed by the device, but were bigger
237 supposed to be routed. For example, IGMP queries can be flooded by the
[all …]
|
| D | mlxsw.rst | 73 routed from a disabled router interface (RIF). This can happen during
79 routed through a disabled router interface (RIF). This can happen during
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-pci-drivers-ehci_hcd | 10 high-speed device is plugged in, the connection is routed
12 is plugged in, the connection is routed to the companion
17 connection to be routed to the companion controller.
19 file causes connections on that port to be routed to the
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/connector/ |
| D | usb-connector.yaml | 179 # Micro-USB connector with HS lines routed via controller (MUIC).
189 # USB-C connector attached to CC controller (s2mm005), HS lines routed
191 # DisplayPort video lines are routed to the connector via SS mux in USB3 PHY.
242 # with SS 2:1 MUX. HS lines routed to SoC, SS lines routed to the MUX and
281 # Micro-USB connector with HS lines routed via controller (MUIC) and MHL
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | armada-385-turris-omnia.dts | 161 /* routed to PCIe0/mSATA connector (CN7A) */
169 /* routed to PCIe1/USB2 connector (CN61A) */
177 /* routed to PCIe2 connector (CN62A) */
185 /* routed to SFP+ */
345 /* MISO, MOSI, SCLK and CS1 are routed to pin header CN11 */
|
| D | imx31-lite.dts | 145 /* Routed to the extension board */
151 /* Routed to the extension board */
|
| /kernel/linux/linux-5.10/arch/mips/pci/ |
| D | fixup-sni.c | 30 * Device 0: PCI EISA Bridge (directly routed)
31 * Device 1: NCR53c810 SCSI (directly routed)
32 * Device 2: PCnet32 Ethernet (directly routed)
33 * Device 3: VGA (routed to INTB)
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/media/ |
| D | imx.rst | 150 containing each virtual channel that are routed to CSIs or video
153 On i.MX6 solo/dual-lite, all four virtual channel buses are routed to
157 On i.MX6 Quad, virtual channel 0 is routed to IPU1-CSI0 (after selected
159 and IPU2-CSI0, respectively, and virtual channel 3 is routed to
194 When the direct source pad is routed to the ipuX_ic_prp entity, frames
198 When the direct source pad is routed to the ipuX_vdic entity, the VDIC
204 source pad is routed to a capture device node, with a node name of the
315 routed to a capture device node, with a node name of the format
330 pad from ipuX_ic_prp, and a single source pad. The source pad is routed
427 routed as follows: vc0 to the IPU1 CSI0 mux, vc1 directly to IPU1 CSI1,
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | interrupts.txt | 13 which the interrupts are routed; see section 2 below for details.
20 interrupts are routed and contains a single phandle referring to the interrupt
116 interrupts routed to them, so that they can wakeup the SoC from suspend. These
|
| D | riscv,cpu-intc.txt | 7 Every interrupt is ultimately routed through a hart's HLIC before it
15 interrupts connect all other device interrupts to the HLIC, which are routed
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mailbox/ |
| D | omap-mailbox.txt | 11 interrupt lines. An output interrupt line is routed to an interrupt controller
25 routed to different processor sub-systems on DRA7xx as they are routed through
29 all these clusters are multiplexed and routed to different processor subsystems
|
| /kernel/linux/linux-5.10/include/sound/ |
| D | seq_virmidi.h | 55 * ATTACH = input/output events from midi device are routed to the
60 * DISPATCH = input/output events are routed to subscribers.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/thermal/ |
| D | ti_soc_thermal.txt | 20 the talert signal is routed to;
23 line the tshut signal is routed to. The informed GPIO will
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/clock/ |
| D | lpc1850-ccu.txt | 22 Shall contain a list of phandles for the base clocks routed
26 Shall contain a list of names for the base clock routed
|
| /kernel/linux/linux-5.10/arch/arm/mach-mmp/ |
| D | regs-icu.h | 34 * IRQ0/FIQ0 is routed to SP IRQ/FIQ.
35 * IRQ1 is routed to PJ4 IRQ, and IRQ2 is routes to PJ4 FIQ.
|
| /kernel/linux/linux-5.10/Documentation/ia64/ |
| D | irq-redir.rst | 59 The IRQ is routed to the CPU with lowest XTP register value, the
65 manner. IRQs will be routed only to the selected target CPUs. Check
|
| /kernel/linux/linux-5.10/net/can/ |
| D | Kconfig | 51 msg sending and can optionally modify routed CAN frames on the fly.
52 CAN frames can be routed between CAN network interfaces (one hop).
|
| /kernel/linux/linux-5.10/include/uapi/linux/ |
| D | atmbr2684.h | 20 #define BR2684_FLAG_ROUTED (1<<16) /* payload is routed, not bridged */
44 * Is this VC bridged or routed?
|
| /kernel/linux/linux-5.10/net/bridge/netfilter/ |
| D | ebtable_broute.c | 22 * EBT_DROP means the frame will be routed
75 * skb should be routed, not bridged. in ebt_broute()
|
| /kernel/linux/linux-5.10/arch/powerpc/boot/dts/ |
| D | mpc5121ads.dts | 74 * all irqs but touch screen are routed to irq0 (ipic 48)
75 * touch screen is statically routed to irq1 (ipic 17)
|
| /kernel/linux/linux-5.10/Documentation/networking/ |
| D | ipvs-sysctl.rst | 261 realservers so that they are routed as if they originate from the
262 director. Otherwise they are routed as if they are forwarded by the
266 of a packet originating from a director is routed differently to a
|
| /kernel/linux/linux-5.10/Documentation/sound/hd-audio/ |
| D | controls.rst | 71 When this enum control is enabled, the headphone output is routed
119 When this enum control is enabled, the headphone output is routed
|
| /kernel/linux/linux-5.10/Documentation/sound/cards/ |
| D | cmipci.rst | 31 disabled. Otherwise no signal will be routed to the rear speakers.
50 playback should be routed there as default. If not, there is a
178 SPDIF input is routed to DAC.
|
12345678910>>...14