Searched +full:select +full:- +full:utmi +full:- +full:as +full:- +full:pipe +full:- +full:clk (Results 1 – 7 of 7) sorted by relevance
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/usb/ |
| D | qcom,dwc3.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Manu Gautam <mgautam@codeaurora.org>
15 - enum:
16 - qcom,msm8996-dwc3
17 - qcom,msm8998-dwc3
18 - qcom,sc7180-dwc3
19 - qcom,sdm845-dwc3
20 - const: qcom,dwc3
[all …]
|
| /kernel/linux/linux-5.10/drivers/usb/dwc3/ |
| D | dwc3-qcom.c | 1 // SPDX-License-Identifier: GPL-2.0
4 * Inspired by dwc3-of-simple.c
10 #include <linux/clk.h>
71 struct clk **clks;
121 dwc3_qcom_setbits(qcom->qscratch_base, QSCRATCH_SS_PHY_CTRL, in dwc3_qcom_vbus_overrride_enable()
123 dwc3_qcom_setbits(qcom->qscratch_base, QSCRATCH_HS_PHY_CTRL, in dwc3_qcom_vbus_overrride_enable()
126 dwc3_qcom_clrbits(qcom->qscratch_base, QSCRATCH_SS_PHY_CTRL, in dwc3_qcom_vbus_overrride_enable()
128 dwc3_qcom_clrbits(qcom->qscratch_base, QSCRATCH_HS_PHY_CTRL, in dwc3_qcom_vbus_overrride_enable()
140 qcom->mode = event ? USB_DR_MODE_PERIPHERAL : USB_DR_MODE_HOST; in dwc3_qcom_vbus_notifier()
152 qcom->mode = event ? USB_DR_MODE_HOST : USB_DR_MODE_PERIPHERAL; in dwc3_qcom_host_notifier()
[all …]
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/qcom/ |
| D | sdm845-cheza.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/input/input.h>
10 #include <dt-bindings/regulator/qcom,rpmh-regulator.h>
26 stdout-path = "serial0:115200n8";
30 compatible = "pwm-backlight";
32 enable-gpios = <&tlmm 37 GPIO_ACTIVE_HIGH>;
33 power-supply = <&ppvar_sys>;
34 pinctrl-names = "default";
35 pinctrl-0 = <&ap_edp_bklten>;
[all …]
|
| /kernel/linux/linux-5.10/drivers/usb/gadget/udc/ |
| D | fsl_udc_core.c | 1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright (C) 2004-2007,2011-2012 Freescale Semiconductor, Inc.
10 * Freescale high-speed USB SOC DR module device controller driver.
12 * The driver is previously named as mpc_udc. Based on bare board
35 #include <linux/dma-mapping.h>
49 #define DRIVER_DESC "Freescale High-Speed USB SOC Device Controller driver"
55 static const char driver_name[] = "fsl-usb2-udc";
83 * registers should set pdata->big_endian_mmio flag.
85 * This also applies to controller-to-cpu accessors for the USB descriptors,
87 * have BE USB descriptors should set pdata->big_endian_desc flag.
[all …]
|
| /kernel/linux/patches/linux-5.10/yangfan_patch/ |
| D | drivers.patch | 6 Change-Id: I9825adaa8537a316db8a1831e759a74223b9e428
7 ---
9 drivers/block/nbd.c | 6 -
11 drivers/clk/Kconfig | 7 +
12 drivers/clk/clk.c | 2 +-
13 drivers/clk/rockchip/Kconfig | 42 +-
14 drivers/clk/rockchip/Makefile | 2 +
15 drivers/clk/rockchip/clk-cpu.c | 92 +-
16 drivers/clk/rockchip/clk-ddr.c | 171 +-
17 drivers/clk/rockchip/clk-half-divider.c | 35 +-
[all …]
|
| /kernel/linux/patches/linux-5.10/hispark_taurus_patch/ |
| D | hispark_taurus.patch | 1 diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
3 --- a/arch/arm/Kconfig
5 @@ -322,7 +322,7 @@ config ARCH_MULTIPLATFORM
6 select ARCH_SELECT_MEMORY_MODEL
7 select ARM_HAS_SG_CHAIN
8 select ARM_PATCH_PHYS_VIRT
9 - select AUTO_ZRELADDR
10 + #select AUTO_ZRELADDR
11 select TIMER_OF
12 select COMMON_CLK
[all …]
|
| /kernel/linux/patches/linux-4.19/hispark_taurus_patch/ |
| D | hispark_taurus.patch | 1 diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
3 --- a/arch/arm/Kconfig
5 @@ -330,7 +330,7 @@ config ARCH_MULTIPLATFORM
7 select ARM_HAS_SG_CHAIN
8 select ARM_PATCH_PHYS_VIRT
9 - select AUTO_ZRELADDR
10 + #select AUTO_ZRELADDR
11 select TIMER_OF
12 select COMMON_CLK
13 select GENERIC_CLOCKEVENTS
[all …]
|