Lines Matching full:nodes

54  node may write to those sectors.  This is used when a new nodes
60  Each node has to communicate with other nodes when starting or ending
70  Normally all nodes hold a concurrent-read lock on this device.
75  Messages can be broadcast to all nodes, and the sender waits for all
76  other nodes to acknowledge the message before proceeding.  Only one
87    informs other nodes that the metadata has
94    informs other nodes that a resync is initiated or
104    informs other nodes that a device is being added to
128  The DLM LVB is used to communicate within nodes of the cluster. There
145    acknowledged by all nodes in the cluster. The BAST of the resource
151  1. receive status - all nodes have concurrent-reader lock on "ack"::
231 	  other nodes from writing anywhere on the array.
234  environment when a resync is performed, it needs to tell other nodes
241  other nodes and other nodes remove the corresponding entry from the
253  acknowledged by all other nodes.
258  For adding a new device, it is necessary that all nodes "see" the new
264    3.  Other nodes issue kobject_uevent_env with uuid and slot number
268    5.  Other nodes issue either of the following depending on whether
273    6.  Other nodes drop lock on "no-new-devs" (CR) if device is found
279    10. Other nodes get the information whether a disk is added or not
289 6.1 join(nodes) and leave()
295  Only the first 'nodes' nodes in the cluster can use the array.
301  Range is from 0 to nodes-1.
328  message to all other nodes, otherwise metadata_update_cancel()
362  the array.  It causes a REMOVE message to be send to other nodes.
367  This sends a RE_ADD message to all other nodes and then
376  nodes are using the raid which is achieved by lock all bitmap