Lines Matching +full:imx +full:- +full:pinctrl
1 // SPDX-License-Identifier: GPL-2.0+
10 stdout-path = &uart1;
20 compatible = "fsl,imx-parallel-display";
21 pinctrl-names = "default";
22 pinctrl-0 = <&pinctrl_ipu_disp0>;
24 #address-cells = <1>;
25 #size-cells = <0>;
32 remote-endpoint = <&ipu_di0_disp0>;
40 remote-endpoint = <&panel_in>;
45 gpio-keys {
46 compatible = "gpio-keys";
54 volume-up {
58 wakeup-source;
61 volume-down {
65 wakeup-source;
70 compatible = "gpio-leds";
71 pinctrl-names = "default";
72 pinctrl-0 = <&led_pin_gpio7_7>;
77 linux,default-trigger = "heartbeat";
86 remote-endpoint = <&display_out>;
92 compatible = "simple-bus";
93 #address-cells = <1>;
94 #size-cells = <0>;
97 compatible = "regulator-fixed";
99 regulator-name = "3P2V";
100 regulator-min-microvolt = <3200000>;
101 regulator-max-microvolt = <3200000>;
102 regulator-always-on;
106 compatible = "regulator-fixed";
108 regulator-name = "usb_vbus";
109 regulator-min-microvolt = <5000000>;
110 regulator-max-microvolt = <5000000>;
112 enable-active-high;
117 compatible = "fsl,imx53-qsb-sgtl5000",
118 "fsl,imx-audio-sgtl5000";
119 model = "imx53-qsb-sgtl5000";
120 ssi-controller = <&ssi2>;
121 audio-codec = <&sgtl5000>;
122 audio-routing =
126 mux-int-port = <2>;
127 mux-ext-port = <5>;
133 operating-points = <
143 pinctrl-names = "default";
144 pinctrl-0 = <&pinctrl_esdhc1>;
149 remote-endpoint = <&display0_in>;
157 pinctrl-names = "default";
158 pinctrl-0 = <&pinctrl_esdhc3>;
159 cd-gpios = <&gpio3 11 GPIO_ACTIVE_LOW>;
160 wp-gpios = <&gpio3 12 GPIO_ACTIVE_HIGH>;
161 bus-width = <8>;
166 pinctrl-names = "default";
167 pinctrl-0 = <&pinctrl_hog>;
169 imx53-qsb {
293 pinctrl_vga_sync: vgasync-grp {
311 pinctrl-names = "default";
312 pinctrl-0 = <&pinctrl_vga_sync>;
313 ddc-i2c-bus = <&i2c2>;
314 fsl,tve-mode = "vga";
315 fsl,hsync-pin = <7>; /* IPU DI1 PIN7 via EIM_OE */
316 fsl,vsync-pin = <8>; /* IPU DI1 PIN8 via EIM_RW */
321 pinctrl-names = "default";
322 pinctrl-0 = <&pinctrl_uart1>;
327 pinctrl-names = "default";
328 pinctrl-0 = <&pinctrl_i2c2>;
334 pinctrl-names = "default";
335 pinctrl-0 = <&pinctrl_codec>;
336 #sound-dai-cells = <0>;
337 VDDA-supply = <®_3p2v>;
338 VDDIO-supply = <®_3p2v>;
344 pinctrl-names = "default";
345 pinctrl-0 = <&pinctrl_i2c1>;
355 pinctrl-names = "default";
356 pinctrl-0 = <&pinctrl_audmux>;
361 pinctrl-names = "default";
362 pinctrl-0 = <&pinctrl_fec>;
363 phy-mode = "rmii";
364 phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
377 vbus-supply = <®_usb_vbus>;