Lines Matching full:zero

13 /* If TRY_DIRECT_IO is non-zero, the driver tries to transfer data directly
15    buffer is used. If TRY_DIRECT_IO is zero, driver buffer is always used. */
19    to the user program if ST_NOWAIT is non-zero. This helps if the SCSI
26    because of buffered reads. Should be set to zero to support also drives
31 /* If ST_RECOVERED_WRITE_FATAL is non-zero, recovered errors while writing
40    Must be non-zero. */
59 /* If ST_TWO_FM is non-zero, the driver writes two filemarks after a
64 /* If ST_BUFFER_WRITES is non-zero, writes in fixed block mode are
69 /* If ST_ASYNC_WRITES is non-zero, the SCSI write command may be started
74 /* If ST_READ_AHEAD is non-zero, blocks are read ahead in fixed block
78 /* If ST_AUTO_LOCK is non-zero, the drive door is locked at the first
83 /* If ST_FAST_MTEOM is non-zero, the MTEOM ioctl is done using the
91    is zero. */
94 /* If ST_SYSV is non-zero, the tape behaves according to the SYS V semantics.
98 /* If ST_SILI is non-zero, the SILI bit is set when reading in variable block