Searched full:indicating (Results 1 – 25 of 1005) sorted by relevance
12345678910>>...41
| /kernel/linux/linux-5.10/drivers/net/ipa/ |
| D | ipa.h | 69 * @available: Bit mask indicating endpoints hardware supports
70 * @filter_map: Bit mask indicating endpoints that support filtering
71 * @initialized: Bit mask indicating endpoints initialized
72 * @set_up: Bit mask indicating endpoints set up
73 * @enabled: Bit mask indicating endpoints enabled
77 * @setup_complete: Flag indicating whether setup stage has completed
119 /* Bit masks indicating endpoint state */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/input/ |
| D | gpio-mouse.txt | 9 - up-gpios: GPIO line phandle to the line indicating "up"
10 - down-gpios: GPIO line phandle to the line indicating "down"
11 - left-gpios: GPIO line phandle to the line indicating "left"
12 - right-gpios: GPIO line phandle to the line indicating "right"
|
| /kernel/linux/linux-5.10/include/linux/phy/ |
| D | phy-dp.h | 61 * Flag indicating, whether or not to enable spread-spectrum clocking.
69 * Flag indicating, whether or not reconfigure link rate and SSC to
78 * Flag indicating, whether or not reconfigure lane count to
87 * Flag indicating, whether or not reconfigure voltage swing
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/hwmon/ |
| D | aspeed-pwm-tacho.txt | 39 integer value in the range 0 to 7 with 0 indicating PWM port A and
40 7 indicating PWM port H.
46 integer value in the range 0 through 15, with 0 indicating
47 Fan tach channel 0 and 15 indicating Fan tach channel 15.
|
| /kernel/linux/linux-5.10/include/drm/ |
| D | drm_fourcc.h | 152 * A boolean indicating whether the format info matches a packed YUV format.
166 * A boolean indicating whether the format info matches a semiplanar YUV format.
180 * A boolean indicating whether the format info matches a planar YUV format.
194 * A boolean indicating whether the format info matches a YUV format with 4:1:0
209 * A boolean indicating whether the format info matches a YUV format with 4:1:1
224 * A boolean indicating whether the format info matches a YUV format with 4:2:0
239 * A boolean indicating whether the format info matches a YUV format with 4:2:2
254 * A boolean indicating whether the format info matches a YUV format with 4:4:4
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-papr-pmem | 6 (RO) Report flags indicating various states of a
30 Indicating that contents of the
33 Indicating that NVDIMM contents cant
|
| /kernel/linux/linux-5.10/arch/parisc/math-emu/ |
| D | fcnvuf.c | 69 * a value in dst_exponent indicating the bit position, in sgl_to_sgl_fcnvuf()
128 * a value in dst_exponent indicating the bit position, in sgl_to_dbl_fcnvuf()
170 * a value in dst_exponent indicating the bit position, in dbl_to_sgl_fcnvuf()
186 * a value in dst_exponent indicating the bit position, in dbl_to_sgl_fcnvuf()
252 * a value in dst_exponent indicating the bit position, in dbl_to_dbl_fcnvuf()
268 * a value in dst_exponent indicating the bit position, in dbl_to_dbl_fcnvuf()
|
| D | fcnvxf.c | 77 * a value in dst_exponent indicating the bit position, in sgl_to_sgl_fcnvxf()
148 * a value in dst_exponent indicating the bit position, in sgl_to_dbl_fcnvxf()
200 * a value in dst_exponent indicating the bit position, in dbl_to_sgl_fcnvxf()
222 * a value in dst_exponent indicating the bit position, in dbl_to_sgl_fcnvxf()
305 * a value in dst_exponent indicating the bit position, in dbl_to_dbl_fcnvxf()
327 * a value in dst_exponent indicating the bit position, in dbl_to_dbl_fcnvxf()
|
| /kernel/linux/linux-5.10/Documentation/virt/kvm/ |
| D | s390-pv.rst | 58 indicating that the contents of CRs 0, 6, or 14 have been changed,
59 indicating different interruption subclasses; and one indicating that
60 PSW bit 13 has been changed, indicating that a machine check
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | imx-audio-spdif.txt | 16 indicating there's a physical S/PDIF out connector
22 function of S/PDIF will be enabled, indicating there
|
| /kernel/linux/linux-5.10/arch/x86/include/asm/ |
| D | iosf_mbi.h | 64 * @port: port indicating subunit being accessed
76 * @port: port indicating subunit being accessed
88 * @port: port indicating subunit being accessed
92 * @mask: mask indicating bits in mdr to be modified
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/memory-controllers/ |
| D | arm,pl172.txt | 23 - clock-ranges: Empty property indicating that child nodes can inherit
37 - ranges: Empty property indicating that child nodes can inherit
40 - clock-ranges: Empty property indicating that child nodes can inherit
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | pixfmt-cnf4.rst | 15 confidence information in range 0-15 with 0 indicating that the sensor was
16 unable to resolve any signal and 15 indicating maximum level of confidence for
|
| /kernel/linux/linux-5.10/include/sound/sof/ |
| D | stream.h | 115 /* flags indicating which time stamps are in sync with each other */
121 /* flags indicating which time stamps are valid */
127 /* flags indicating time stamps are 64bit else 3use low 32bit */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/powerpc/opal/ |
| D | power-mgt.txt | 14 - flags: indicating some aspects of this idle states such as the
80 indicating which psscr fields are set in the corresponding
115 Array of unsigned 64-bit values containing the mask indicating
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/media/ |
| D | si476x.rst | 49 0x04 softmute_int Flag indicating that softmute
128 0x06 bltf Flag indicating if seek command
134 0x10 afcrl Flag indicating if AFC rails
135 0x11 valid Flag indicating if channel is valid
|
| /kernel/linux/linux-5.10/include/uapi/linux/ |
| D | a.out.h | 63 /* Code indicating object file or impure executable. */
65 /* Code indicating pure executable. */
67 /* Code indicating demand-paged executable. */
73 /* Code indicating core file. */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/board/ |
| D | fsl-board.txt | 26 indicating the type of FPGA. Example:
57 indicating the type of FPGA. Example:
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/display/msm/ |
| D | dsi.txt | 40 - qcom,dual-dsi-mode: Boolean value indicating if the DSI controller is
42 - qcom,master-dsi: Boolean value indicating if the DSI controller is driving
44 - qcom,sync-dual-dsi: Boolean value indicating if the DSI controller is
125 - qcom,dsi-phy-regulator-ldo-mode: Boolean value indicating if the LDO mode PHY
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/power/supply/ |
| D | gpio-charger.yaml | 36 description: GPIO indicating the charger presence
40 description: GPIO indicating the charging status
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/arm/bcm/ |
| D | brcm,bcm63138.txt | 25 - resets: phandle to the relevant PMB controller, one integer indicating the internal
26 bus number, and a second integer indicating the address of the CPU in the PMB
|
| /kernel/linux/linux-5.10/arch/powerpc/include/asm/ |
| D | security_features.h | 48 // Features indicating support for Spectre/Meltdown mitigations
74 // Features indicating need for Spectre/Meltdown mitigations
|
| /kernel/linux/linux-5.10/drivers/extcon/ |
| D | extcon.c | 485 * @id: the unique id indicating an external connector
512 * @id: the unique id indicating an external connector
568 * @id: the unique id indicating an external connector
604 * @id: the unique id indicating an external connector
605 * @prop: the property id indicating an extcon property
685 * @id: the unique id indicating an external connector
686 * @prop: the property id indicating an extcon property
777 * @id: the unique id indicating an external connector
778 * @prop: the property id indicating an extcon property
807 * @id: the unique id indicating an external connector
[all …]
|
| /kernel/linux/linux-5.10/arch/powerpc/platforms/ps3/ |
| D | interrupt.c | 159 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
234 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
311 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
380 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
456 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
513 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
570 * @cpu: enum ps3_cpu_binding indicating the cpu the interrupt should be
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/intel/ice/ |
| D | ice_flow.h | 174 u32 hdrs; /* Bitmask indicating protocol headers present */
175 u64 match; /* Bitmask indicating header fields to be matched */
176 u64 range; /* Bitmask indicating header fields matched as ranges */
|
12345678910>>...41