/kernel/linux/linux-5.10/drivers/net/wireless/ath/ath9k/ |
D | ar9003_eeprom.c | 39 #define CTL(_tpower, _flag) ((_tpower) | ((_flag) << 6)) macro 284 { { CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 0) } }, 285 { { CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 0) } }, 286 { { CTL(60, 1), CTL(60, 0), CTL(60, 0), CTL(60, 1) } }, 288 { { CTL(60, 1), CTL(60, 0), CTL(60, 0), CTL(60, 0) } }, 289 { { CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 0) } }, 290 { { CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 0) } }, 292 { { CTL(60, 0), CTL(60, 1), CTL(60, 1), CTL(60, 0) } }, 293 { { CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 0) } }, 294 { { CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 0) } }, [all …]
|
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/net/ |
D | micrel-ksz90x1.txt | 49 - rxdv-skew-ps : Skew control of RX CTL pad 51 - txen-skew-ps : Skew control of TX CTL pad 77 - rxdv-skew-ps : Skew control of RX CTL pad 78 - txen-skew-ps : Skew control of TX CTL pad 110 - rxdv-skew-psec : Skew control of RX CTL pad 111 - txen-skew-psec : Skew control of TX CTL pad
|
/kernel/linux/linux-5.10/sound/pci/lola/ |
D | lola_pcm.c | 64 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_start() 75 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_stop() 88 val = lola_dsd_read(chip, str->dsd, CTL); in wait_for_srst_clear() 163 lola_dsd_write(chip, str->dsd, CTL, LOLA_DSD_CTL_SRUN | in lola_sync_pause() 175 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_reset() 179 lola_dsd_write(chip, str->dsd, CTL, LOLA_DSD_CTL_SRST); in lola_stream_reset() 443 lola_dsd_write(chip, str->dsd, CTL, in lola_setup_controller()
|
D | lola_proc.c | 186 lola_dsd_read(chip, i, CTL)); in lola_proc_regs_read()
|
/kernel/linux/linux-5.10/drivers/char/xilinx_hwicap/ |
D | xilinx_hwicap.c | 126 .CTL = 5, 151 .CTL = 5, 176 .CTL = 5, 201 .CTL = 5,
|
D | xilinx_hwicap.h | 130 u32 CTL; member
|
/kernel/linux/linux-5.10/drivers/net/wan/ |
D | hd64570.h | 63 #define CTL 0x11 /* Control */ macro
|
D | c101.c | 193 sca_out(0, MSCI1_OFFSET + CTL, port); /* RTS uses ch#2 output */ in c101_open() 216 sca_out(CTL_NORTS, MSCI1_OFFSET + CTL, port); in c101_close()
|
D | hd64572.h | 64 #define CTL 0x130 /* Control reg */ macro
|
D | hd64572.c | 453 sca_out(CTL_IDLE | CTL_URCT | CTL_URSKP, msci + CTL, card); in sca_open()
|
D | hd64570.c | 488 sca_out(CTL_IDLE, msci + CTL, card); in sca_open()
|
/kernel/linux/linux-5.10/sound/soc/qcom/ |
D | lpass-lpaif-reg.h | 142 #define LPAIF_DMACTL_REG(v, chan, dir, dai_id) __LPAIF_DMA_REG(v, chan, dir, CTL, dai_id)
|
/kernel/linux/linux-5.10/Documentation/ABI/testing/ |
D | sysfs-bus-coresight-devices-etb10 | 66 is read directly from HW register CTL, 0x020.
|
D | sysfs-bus-coresight-devices-tmc | 54 is read directly from HW register CTL, 0x020.
|
/kernel/linux/linux-5.10/drivers/media/dvb-frontends/ |
D | bcm3510_priv.h | 29 u8 CTL :8; member
|
D | bcm3510.c | 745 v.TSTCTL_2e.CTL = 0; in bcm3510_init_cold()
|
/kernel/linux/linux-5.10/drivers/tty/ |
D | synclinkmp.c | 326 #define CTL 0x31 macro 1510 RegValue = read_reg(info, CTL); in set_break() 1515 write_reg(info, CTL, RegValue); in set_break() 4478 write_reg(info, CTL, RegValue); in async_mode() 4683 write_reg(info, CTL, RegValue); in hdlc_mode() 4753 RegValue = read_reg(info, CTL); in set_signals() 4758 write_reg(info, CTL, RegValue); in set_signals()
|
/kernel/linux/linux-5.10/drivers/usb/gadget/udc/ |
D | atmel_usba_udc.c | 1435 epctrl = usba_ep_readl(ep, CTL); in usba_control_irq() 1622 epctrl = usba_ep_readl(ep, CTL); in usba_ep_irq() 1660 epctrl = usba_ep_readl(ep, CTL); in usba_ep_irq()
|
/kernel/linux/linux-5.10/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
D | fwsignal.c | 981 brcmf_dbg(CTL, "rssi %d\n", rssi); in brcmf_fws_rssi_indicate() 1590 brcmf_dbg(CTL, "received: seq %d, timestamp %d\n", data[1], in brcmf_fws_dbg_seqnum_check()
|
D | sdio.c | 3260 brcmf_dbg(CTL, "resumed on rxctl frame, got %d expected %d\n", in brcmf_sdio_bus_rxctl() 3266 brcmf_dbg(CTL, "cancelled\n"); in brcmf_sdio_bus_rxctl() 3269 brcmf_dbg(CTL, "resumed for unknown reason?\n"); in brcmf_sdio_bus_rxctl()
|
/kernel/linux/patches/linux-5.10/imx8mm_patch/patches/drivers/ |
D | 0016_linux_drivers_crypto.patch | 6149 + struct caam_ctl_state state; /* State of the CTL during PM */
|
/kernel/linux/patches/linux-5.10/imx8mm_patch/patches/ |
D | 0005_linux_include.patch | 2997 +#define IMX8MQ_RESET_PCIE_CTRL_APPS_CLK_REQ 53 /* i.MX8M PCIe CTL CLK REQ */ 2998 +#define IMX8MQ_RESET_PCIE2_CTRL_APPS_CLK_REQ 54 /* i.MX8M PCIe CTL CLK REQ */
|