| /kernel/linux/linux-5.10/Documentation/spi/ |
| D | spi-lm70llp.rst | 46 D7 9 --> SI/O 5
52 is connected to both pin D7 (as Master Out) and Select (as Master In)
65 transistor Q1 (and also a pullup, and a zener diode to D7); while the
69 and not grounded by the host via D7), the transistor conducts and switches
|
| D | butterfly.rst | 37 MOSI J403.PB2/MOSI pin 9/D7
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | socfpga_cyclone5_socrates.dts | 63 label = "led:green:D7";
|
| D | aspeed-bmc-opp-zaius.dts | 472 pins = "A8", "C7", "B7", "A7", "D7", "B6", "A6", "E7";
485 /*D0-D7*/ "fsi-enable","","","","","led-sys-boot-status","led-attention",
|
| D | aspeed-bmc-opp-nicole.dts | 222 /*D0-D7*/ "fsi-enable","bmc_power_up","sys_pwrok_buf",
|
| D | aspeed-bmc-opp-romulus.dts | 238 /*D0-D7*/ "fsi-enable","","","nic_func_mode0","nic_func_mode1","","","",
|
| D | omap3-beagle-xm.dts | 48 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */
|
| D | aspeed-bmc-facebook-tiogapass.dts | 127 /*D0-D7*/ "BIOS_MRC_DEBUG_MSG_DIS","BOARD_REV_ID0","",
|
| D | omap3-beagle.dts | 44 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */
|
| D | aspeed-bmc-opp-witherspoon.dts | 205 /*D0-D7*/ "fsi-enable","","","","","","","",
|
| D | aspeed-bmc-opp-tacoma.dts | 108 /*D0-D7*/ "","","","","","","","",
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/ti/ |
| D | k3-j7200-som-p0.dtsi | 37 J721E_WKUP_IOPAD(0x30, PIN_OUTPUT, 1) /* (D7) MCU_OSPI0_CSn1.MCU_HYPERBUS0_RESETn */
|
| /kernel/linux/linux-5.10/Documentation/networking/ |
| D | plip.rst | 147 D5,D6,D7 are 7*, 8*, 9*
180 D7->D7 9 - 9
|
| /kernel/linux/linux-5.10/Documentation/i2c/busses/ |
| D | i2c-parport.rst | 89 - Pins 4-9 (D2-D7) could be used as VDD is the driver drives them high.
90 The ADM1032 evaluation board uses D4-D7. Beware that the amount of
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxl-s905x-khadas-vim.dts | 145 "eMMC D4", "eMMC D5", "eMMC D6", "eMMC D7",
|
| D | meson-gxl-s805x-libretech-ac.dts | 247 "eMMC D4", "eMMC D5", "eMMC D6", "eMMC D7",
|
| D | meson-gxl-s905x-libretech-cc.dts | 270 "eMMC D4", "eMMC D5", "eMMC D6", "eMMC D7",
|
| D | meson-gxbb-nanopi-k2.dts | 218 "eMMC D5", "eMMC D6", "eMMC D7", "eMMC Clk",
|
| D | meson-gxbb-odroidc2.dts | 275 "eMMC D5", "eMMC D6", "eMMC D7", "eMMC Clk",
|
| /kernel/linux/linux-5.10/drivers/pinctrl/aspeed/ |
| D | pinctrl-aspeed-g5.c | 1175 #define D7 157 macro
1176 SIG_EXPR_LIST_DECL_SINGLE(D7, GPIOT5, GPIOT5, SIG_DESC_SET(SCUA0, 5));
1177 SIG_EXPR_LIST_DECL_SINGLE(D7, RMII1DASH1, RMII1, RMII1_DESC);
1178 SIG_EXPR_LIST_DECL_SINGLE(D7, RGMII1TXD3, RGMII1);
1179 PIN_DECL_(D7, SIG_EXPR_LIST_PTR(D7, GPIOT5), SIG_EXPR_LIST_PTR(D7, RMII1DASH1),
1180 SIG_EXPR_LIST_PTR(D7, RGMII1TXD3));
1267 FUNC_GROUP_DECL(RGMII1, B4, A4, A3, D6, C5, C4, B5, E9, F9, A5, E7, D7);
1991 ASPEED_PINCTRL_PIN(D7),
2547 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_PULL_DOWN, B5, D7, SCU90, 12),
2548 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_DISABLE, B5, D7, SCU90, 12),
|
| D | pinctrl-aspeed-g4.c | 499 #define D7 60 macro
502 SIG_EXPR_LIST_DECL_DUAL(D7, ROMD12, ROM16, ROM16S);
503 SIG_EXPR_LIST_DECL_SINGLE(D7, NDTR6, NDTR6, UART6_DESC);
504 PIN_DECL_2(D7, GPIOH4, ROMD12, NDTR6);
527 FUNC_GROUP_DECL(UART6, A8, C7, B7, A7, D7, B6, A6, E7);
1855 A8, C7, B7, A7, D7, B6, A6, E7, W21, Y22, U19, R22, P18, P19,
2001 ASPEED_PINCTRL_PIN(D7),
|
| /kernel/linux/linux-5.10/Documentation/xtensa/ |
| D | mmu.rst | 42 80..9F -> 80 -> 80 -> 80 D0..D7 -> 00 -> 00
|
| /kernel/linux/linux-5.10/Documentation/driver-api/iio/ |
| D | buffers.rst | 60 |D11|D10|D9 |D8 |D7 |D6 |D5 |D4 | (HIGH byte, address 0x07)
|
| /kernel/linux/linux-5.10/arch/m68k/fpsp040/ |
| D | binstr.S | 21 | A1. Init d7 to 1. D7 is the byte digit counter, and if 1, the
|
| /kernel/linux/linux-5.10/Documentation/ABI/stable/ |
| D | sysfs-class-tpm | 134 D7 0E 7D CA 41 BF 43 07 65 86 3C 8C 13 7A D0 8B
|