| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | exynos4412-odroidu3.dts | 3 * Hardkernel's Exynos4412 based ODROID-U3 board device tree source
7 * Device tree source file for Hardkernel's ODROID-U3 board which is based
16 model = "Hardkernel ODROID-U3 board based on Exynos4412";
109 model = "Odroid-U3";
|
| D | exynos4412-odroid-common.dtsi | 3 * Common definition for Hardkernel's Exynos4412 based ODROID-X/X2/U2/U3 boards
413 * Only U3 uses it, so let it define the
485 * X2 and U3.
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-usb-lvstest | 39 Write to this node to issue "U3 entry" for Link Layer
46 Write to this node to issue "U3 exit" for Link Layer
|
| /kernel/linux/linux-5.10/drivers/char/agp/ |
| D | Kconfig | 140 tristate "Apple UniNorth & U3 AGP support"
144 UniNorth or U3 (Apple G5) bridge.
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/ti/ |
| D | k3-j7200-common-proc-board.dts | 55 J721E_IOPAD(0xdc, PIN_INPUT_PULLUP, 3) /* (U3) ECAP0_IN_APWM_OUT.I2C1_SCL */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/phy/ |
| D | phy-mtk-xsphy.txt | 18 - reg : offset and length of register shared by multiple U3 ports,
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/marvell/ |
| D | cn9132-db.dts | 125 /* SLM-1521-V2 - U3 */
|
| D | cn9130-db.dts | 195 /* SLM-1521-V2 - U3 */
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/media/ |
| D | em28xx-cardlist.rst | 202 - Compro, VideoMate U3
|
| /kernel/linux/linux-5.10/drivers/pinctrl/aspeed/ |
| D | pinctrl-aspeed-g4.c | 708 #define U3 90 macro
717 SIG_EXPR_LIST_ALIAS(U3, VPIODD, VPI);
718 SIG_EXPR_LIST_DECL_SINGLE(U3, NDSR1, NDSR1, U3_DESC);
719 PIN_DECL_2(U3, GPIOL2, VPIODD, NDSR1);
720 FUNC_GROUP_DECL(NDSR1, U3);
1032 FUNC_GROUP_DECL(VPI18, T5, U3, V1, U4, V2, V3, W2, Y1, V4, W3, Y2, AA1, V5,
1034 FUNC_GROUP_DECL(VPI24, T5, U3, V1, U4, V2, V3, W2, Y1, V4, W3, Y2, AA1, V5,
1037 FUNC_GROUP_DECL(VPI30, T5, U3, V1, U4, V2, W1, U5, V3, W2, Y1, V4, W3, Y2, AA1,
2097 ASPEED_PINCTRL_PIN(U3),
|
| D | pinctrl-aspeed-g5.c | 828 #define U3 107 macro
832 SIG_EXPR_LIST_DECL_DUAL(U3, VPIG3, VPI24, VPIRSVD);
833 SIG_EXPR_LIST_DECL_SINGLE(U3, PWM3, PWM3, U3_DESC, COND2);
834 PIN_DECL_2(U3, GPION3, VPIG3, PWM3);
835 FUNC_GROUP_DECL(PWM3, U3);
930 U3, W3, AA3, Y3, T4, U5, U4, AB3, Y4, AA4, W4, V4, W5, AA5,
2102 ASPEED_PINCTRL_PIN(U3),
|
| /kernel/linux/linux-5.10/arch/m68k/ifpsp060/src/ |
| D | ilsp.S | 375 mov.w %d6,%d4 # insert lower word (U3)
380 # add.l %d6, %d4 # (U1U2 - V1q) + U3
383 bls.b lddadjd1 # is V2q > (U1U2-V1q) + U3 ?
|
| /kernel/linux/linux-5.10/drivers/scsi/aic7xxx/ |
| D | aic7xxx.reg | 356 field CRCVALERR 0x08 /* CRC doesn't match (U3 only) */
357 field CRCENDERR 0x04 /* No terminal CRC packet (U3 only) */
358 field CRCREQERR 0x02 /* Illegal CRC packet req (U3 only) */
359 field DUAL_EDGE_ERR 0x01 /* Incorrect data phase (U3 only) */
|
| /kernel/linux/linux-5.10/Documentation/driver-api/usb/ |
| D | dwc3.rst | 211 ``U2``, ``U3``, ``SS.Disabled``, ``RX.Detect``, ``SS.Inactive``,
|
| /kernel/linux/patches/linux-5.10/yangfan_patch/ |
| D | include.patch | 3234 + * <14:12> :: U3/CLd power
3235 + * <11> :: U3 to U0 transition mode (0b == direct, 1b == through U3S)
3248 +/* U3/CLd Power*/
|
| /kernel/linux/linux-5.10/Documentation/networking/ |
| D | arcnet-hardware.rst | 1048 | U3 SW 1 JP0 ###| Phone Jacks
1071 U3: Boot-ROM Socket
|
| /kernel/linux/patches/linux-5.10/imx8mm_patch/patches/drivers/ |
| D | 0034_linux_drivers_usb_vfio_wdt_tty_uio.patch | 5566 - * Initiate remote wakeup if the link state is in U3 when
|
| /kernel/linux/patches/linux-4.19/hispark_taurus_patch/ |
| D | hispark_taurus.patch | 350578 + /* config U3 Controller release */
350696 + /* U3 vcc reset */
351999 + /* config U3 Controller release */
352115 + /* U3 vcc reset */
352682 + /* config U3 Controller USB3_0 PHY OUTPUT */
|