| /kernel/linux/linux-5.10/drivers/gpio/ |
| D | gpio-davinci.c | 194 struct davinci_gpio_controller *chips; in davinci_gpio_probe() local
230 chips = devm_kzalloc(dev, sizeof(*chips), GFP_KERNEL); in davinci_gpio_probe()
231 if (!chips) in davinci_gpio_probe()
239 chips->irqs[i] = platform_get_irq(pdev, i); in davinci_gpio_probe()
240 if (chips->irqs[i] < 0) in davinci_gpio_probe()
241 return dev_err_probe(dev, chips->irqs[i], "IRQ not populated\n"); in davinci_gpio_probe()
244 chips->chip.label = dev_name(dev); in davinci_gpio_probe()
246 chips->chip.direction_input = davinci_direction_in; in davinci_gpio_probe()
247 chips->chip.get = davinci_gpio_get; in davinci_gpio_probe()
248 chips->chip.direction_output = davinci_direction_out; in davinci_gpio_probe()
[all …]
|
| /kernel/linux/linux-5.10/drivers/mtd/chips/ |
| D | Kconfig | 6 tristate "Detect flash chips by Common Flash Interface (CFI) probe"
18 tristate "Detect non-CFI AMD/JEDEC-compatible flash chips"
22 This option enables JEDEC-style probing of flash chips which are not
24 CFI-targeted flash drivers for any chips which are identified which
26 covers most AMD/Fujitsu-compatible chips and also non-CFI
27 Intel chips.
37 chips, or if you wish to reduce the size of the kernel by including
38 support for only specific arrangements of flash chips, say 'Y'. This
50 data bits when writing the 'magic' commands to the chips. Saying
52 enabled, means that the CPU will not do any swapping; the chips
[all …]
|
| D | cfi_cmdset_0002.c | 714 cfi->chips[i].word_write_time = 1<<cfi->cfiq->WordWriteTimeoutTyp; in cfi_cmdset_0002()
715 cfi->chips[i].buffer_write_time = 1<<cfi->cfiq->BufWriteTimeoutTyp; in cfi_cmdset_0002()
716 cfi->chips[i].erase_time = 1<<cfi->cfiq->BlockEraseTimeoutTyp; in cfi_cmdset_0002()
725 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0002()
729 cfi->chips[i].buffer_write_time_max = 0; in cfi_cmdset_0002()
731 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0002()
732 max(cfi->chips[i].buffer_write_time_max, 2000); in cfi_cmdset_0002()
734 cfi->chips[i].ref_point_counter = 0; in cfi_cmdset_0002()
735 init_waitqueue_head(&(cfi->chips[i].wq)); in cfi_cmdset_0002()
1261 ret = do_read_onechip(map, &cfi->chips[chipnum], ofs, thislen, buf); in cfi_amdstd_read()
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/bus/ |
| D | brcm,gisb-arb.txt | 6 "brcm,bcm7278-gisb-arb" for V7 28nm chips
7 "brcm,gisb-arb" or "brcm,bcm7445-gisb-arb" for other 28nm chips
8 "brcm,bcm7435-gisb-arb" for newer 40nm chips
9 "brcm,bcm7400-gisb-arb" for older 40nm chips and all 65nm chips
10 "brcm,bcm7038-gisb-arb" for 130nm chips
|
| /kernel/linux/linux-5.10/drivers/net/wireless/ralink/rt2x00/ |
| D | Kconfig | 29 Supported chips: RT2460.
41 Supported chips: RT2560.
56 Supported chips: RT2561, RT2561S & RT2661.
73 Supported chips: RT2760, RT2790, RT2860, RT2880, RT2890, RT3052,
86 Supported chips: RT3390
94 Supported chips: RT3060, RT3062, RT3562, RT3592
103 Supported chips: RT5390
111 Supported chips: RT3290
121 Supported chips: RT2571 & RT2572.
134 Supported chips: RT2571W, RT2573 & RT2671.
[all …]
|
| /kernel/linux/linux-5.10/drivers/mtd/lpddr/ |
| D | Kconfig | 6 tristate "Support for LPDDR flash chips"
10 flash chips. Synonymous with Mobile-DDR. It is a new standard for
15 tristate "Detect flash chips by QINFO probe"
17 Device Information for LPDDR chips is offered through the Overlay
25 tristate "Support for LPDDR2-NVM flash chips"
|
| /kernel/linux/linux-5.10/drivers/i2c/muxes/ |
| D | i2c-mux-pca954x.c | 94 static const struct chip_desc chips[] = { variable
197 { .compatible = "nxp,pca9540", .data = &chips[pca_9540] },
198 { .compatible = "nxp,pca9542", .data = &chips[pca_9542] },
199 { .compatible = "nxp,pca9543", .data = &chips[pca_9543] },
200 { .compatible = "nxp,pca9544", .data = &chips[pca_9544] },
201 { .compatible = "nxp,pca9545", .data = &chips[pca_9545] },
202 { .compatible = "nxp,pca9546", .data = &chips[pca_9546] },
203 { .compatible = "nxp,pca9547", .data = &chips[pca_9547] },
204 { .compatible = "nxp,pca9548", .data = &chips[pca_9548] },
205 { .compatible = "nxp,pca9846", .data = &chips[pca_9846] },
[all …]
|
| /kernel/linux/linux-5.10/sound/usb/6fire/ |
| D | chip.c | 34 static struct sfire_chip *chips[SNDRV_CARDS] = SNDRV_DEFAULT_PTR; variable
95 if (chips[i]) in usb6fire_chip_probe()
96 chips[i]->intf_count++; in usb6fire_chip_probe()
97 usb_set_intfdata(intf, chips[i]); in usb6fire_chip_probe()
135 chips[regidx] = chip; in usb6fire_chip_probe()
180 chips[chip->regidx] = NULL; in usb6fire_chip_disconnect()
|
| /kernel/linux/linux-5.10/drivers/cpufreq/ |
| D | powernv-cpufreq.c | 141 } *chips; variable
980 chips[i].restore = true; in powernv_cpufreq_occ_msg()
981 schedule_work(&chips[i].throttle); in powernv_cpufreq_occ_msg()
988 if (chips[i].id == omsg.chip) in powernv_cpufreq_occ_msg()
993 chips[i].throttle_reason = omsg.throttle_status; in powernv_cpufreq_occ_msg()
994 chips[i].reason[omsg.throttle_status]++; in powernv_cpufreq_occ_msg()
998 chips[i].restore = true; in powernv_cpufreq_occ_msg()
1000 schedule_work(&chips[i].throttle); in powernv_cpufreq_occ_msg()
1079 chips = kcalloc(nr_chips, sizeof(struct chip), GFP_KERNEL); in init_chip_info()
1080 if (!chips) { in init_chip_info()
[all …]
|
| /kernel/linux/linux-5.10/drivers/iio/potentiometer/ |
| D | Kconfig | 35 potentiometer chips.
46 chips.
57 chips.
68 digital potentiometer chips.
86 digital potentiometer chips.
100 digital potentiometer chips.
112 digital potentiometer chips.
124 digital potentiometer chips.
|
| /kernel/linux/linux-5.10/Documentation/hwmon/ |
| D | tmp421.rst | 4 Supported chips:
54 TMP423, TMP441, and TMP442 temperature sensor chips. These chips
57 in degrees Celsius. The chips are wired over I2C/SMBus and specified
61 The chips support only temperature measurement. The driver exports
|
| D | thmc50.rst | 4 Supported chips:
38 List of adapter,address pairs to force chips into ADM1022 mode with
39 second remote temperature. This does not work for original THMC50 chips.
57 The THMC50 is usually used in combination with LM78-like chips, to measure
88 The driver was tested on Compaq AP550 with two ADM1022 chips (one works
|
| D | tmp401.rst | 4 Supported chips:
63 TMP431, TMP432, TMP435, and TMP461 chips. These chips implement one or two
73 The TMP411 and TMP431 chips are compatible with TMP401. TMP411 provides
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/gpio/ |
| D | gpio-mockup.rst | 7 chips for testing purposes. The lines exposed by these chips can be accessed
11 Creating simulated chips using module params
26 The line above creates three chips. The first one will expose 8 lines,
28 to 405 while for two first chips it will be assigned automatically.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | ccf.txt | 12 Example chips: T4240, B4860
15 Example chips: P5040, P5020, P4080, P3041, P2041
20 used for both CCF version 1 chips and CCF version 2
21 chips. It should be specified after either
|
| /kernel/linux/linux-5.10/drivers/memory/tegra/ |
| D | Kconfig | 16 Tegra20 chips. The EMC controls the external DRAM on the board.
26 Tegra30 chips. The EMC controls the external DRAM on the board.
36 Tegra124 chips. The EMC controls the external DRAM on the board.
50 Tegra210 chips. The EMC controls the external DRAM on the board.
|
| /kernel/linux/linux-5.10/drivers/mtd/maps/ |
| D | Kconfig | 7 bool "Support non-linear mappings of flash chips"
10 paged mappings of flash chips.
17 ROM driver code to communicate with chips which are mapped
19 the physical address and size of the flash chips on your
42 This is the physical memory location at which the flash chips
52 This is the total length of the mapping of the flash chips on
54 physical memory map between the chips, this could be larger
74 and RAM driver code to communicate with chips which are mapped
135 in which user-programmable flash chips are connected on the
158 which user-programmable flash chips are connected on various
[all …]
|
| /kernel/linux/linux-5.10/drivers/net/dsa/mv88e6xxx/ |
| D | Kconfig | 10 Ethernet switch chips, except 88E6060.
20 It is required on most chips. If the chip you compile the support for
31 chips that support it.
|
| /kernel/linux/linux-5.10/sound/soc/bcm/ |
| D | Kconfig | 13 tristate "SoC platform audio for Broadcom Cygnus chips"
17 Cygnus chips (bcm958300, bcm958305, bcm911360)
26 DSL/PON chips (bcm63158, bcm63178)
|
| /kernel/linux/linux-5.10/drivers/nfc/st-nci/ |
| D | Kconfig | 5 STMicroelectronics NFC NCI chips core driver. It implements the chipset
15 STMicroelectronics NFC NCI chips family.
27 STMicroelectronics NFC NCI chips family.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/ |
| D | gpio-max3191x.txt | 17 Number of chips in the daisy-chain (default is 1).
21 (if all chips are wired to the same pin).
30 - maxim,modesel-8bit: Boolean whether the modesel pin of the chips is
39 (in 16-bit mode). Use this if the chips are powered
|
| /kernel/linux/linux-5.10/drivers/mtd/nand/raw/ |
| D | oxnas_nand.c | 34 struct nand_chip *chips[OXNAS_NAND_MAX_CHIPS]; member
147 oxnas->chips[oxnas->nchips++] = chip; in oxnas_nand_probe()
166 chip = oxnas->chips[i]; in oxnas_nand_probe()
183 chip = oxnas->chips[i]; in oxnas_nand_remove()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mtd/ |
| D | cypress,hyperflash.txt | 1 Bindings for HyperFlash NOR flash chips compliant with Cypress HyperBus
5 - compatible : "cypress,hyperflash", "cfi-flash" for HyperFlash NOR chips
|
| D | jedec,spi-nor.txt | 1 * SPI NOR flash: ST M25Pxx (and similar) serial flash chips
51 designate quirky versions of flash chips that do not support the
69 all chips and support for it can not be detected at runtime.
70 Refer to your chips' datasheet to check if this is supported
|
| /kernel/linux/linux-5.10/drivers/net/dsa/ |
| D | Kconfig | 17 switch chips.
41 Ethernet switch chips.
68 switch chips.
80 chips, currently only RTL8366RB.
88 switch chips.
|