| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/ |
| D | tps65132-regulator.txt | 17 -active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
19 the enable signal goes low. This GPIO is used to actively discharge
20 the delay mechanism. Requires specification of ti,active-discharge-time-us
21 -ti,active-discharge-time-us: how long the active discharge gpio should be
22 asserted for during active discharge, in microseconds.
43 regulator-active-discharge = <0>;
|
| D | tps62360-regulator.txt | 12 - ti,enable-vout-discharge: Enable output discharge. This is boolean value.
43 ti,enable-vout-discharge;
|
| D | max8973-regulator.txt | 24 -maxim,enable-active-discharge: boolean: enable active discharge.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/power/supply/ |
| D | da9150-fg.txt | 8 - dlg,warn-soc-level: Battery discharge level (%) where warning event raised.
10 - dlg,crit-soc-level: Battery discharge level (%) where critical event raised.
|
| D | axp20x_battery.txt | 11 The supported devices can read the battery voltage, charge and discharge
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/display/ |
| D | repaper.txt | 10 - discharge-gpios: Discharge control
47 discharge-gpios = <&gpio 15 0>;
|
| /kernel/linux/linux-5.10/include/sound/ |
| D | wm2200.h | 39 unsigned int discharge:1; /** Actively discharge */ member
|
| D | da7218.h | 80 bool discharge; member
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/tiny/ |
| D | repaper.c | 72 struct gpio_desc *discharge; member
645 gpiod_set_value_cansleep(epd->discharge, 1); in power_off()
647 gpiod_set_value_cansleep(epd->discharge, 0); in power_off()
668 gpiod_set_value_cansleep(epd->discharge, 0); in repaper_pipe_enable()
1020 epd->discharge = devm_gpiod_get(dev, "discharge", GPIOD_OUT_LOW); in repaper_probe()
1021 if (IS_ERR(epd->discharge)) { in repaper_probe()
1022 ret = PTR_ERR(epd->discharge); in repaper_probe()
|
| /kernel/linux/linux-5.10/include/linux/mfd/arizona/ |
| D | pdata.h | 61 unsigned int discharge:1; /** Actively discharge */ member
|
| /kernel/linux/linux-5.10/arch/arm/mach-pxa/ |
| D | sharpsl_pm.h | 18 void (*discharge)(int); member
|
| D | corgi_pm.c | 164 .discharge = corgi_discharge,
|
| D | spitz_pm.c | 199 .discharge = spitz_discharge,
|
| D | sharpsl_pm.c | 526 sharpsl_pm.machinfo->discharge(1); in sharpsl_check_battery_voltage()
541 sharpsl_pm.machinfo->discharge(0); in sharpsl_check_battery_voltage()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | da7218.txt | 64 - dlg,discharge : Boolean flag, auto discharge of Mic Bias on jack removal
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | stm32mp15xx-dhcor-som.dtsi | 148 regulator-active-discharge = <1>;
154 regulator-active-discharge = <1>;
|
| D | stm32mp15xx-osd32.dtsi | 182 regulator-active-discharge = <1>;
188 regulator-active-discharge = <1>;
|
| D | stm32mp157a-stinger96.dtsi | 219 regulator-active-discharge = <1>;
225 regulator-active-discharge = <1>;
|
| D | tegra30-asus-nexus7-grouper-ti-pmic.dtsi | 137 ti,enable-vout-discharge;
|
| D | stm32mp157c-odyssey-som.dtsi | 213 regulator-active-discharge = <1>;
|
| D | stm32mp157c-ed1.dts | 273 regulator-active-discharge = <1>;
|
| D | stm32mp15xx-dhcom-som.dtsi | 274 regulator-active-discharge = <1>;
|
| D | ste-ux500-samsung-golden.dts | 333 /* ESD (electrostatic discharge) detection interrupt */
|
| /kernel/linux/linux-5.10/drivers/power/supply/ |
| D | axp288_fuel_gauge.c | 391 int ret, discharge; in fuel_gauge_get_current() local
394 ret = iio_read_channel_raw(info->iio_channel[BAT_D_CURR], &discharge); in fuel_gauge_get_current()
398 if (discharge > 0) { in fuel_gauge_get_current()
399 *cur = -1 * discharge; in fuel_gauge_get_current()
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-platform-dptf | 96 (RO) The battery discharge current capability obtained from battery fuel gauge in
|