Searched refs:ohm (Results 1 – 23 of 23) sorted by relevance
/kernel/linux/linux-5.10/drivers/hwmon/ |
D | ntc_thermistor.c | 29 unsigned int ohm; member 69 { .temp_c = -40, .ohm = 1747920 }, 70 { .temp_c = -35, .ohm = 1245428 }, 71 { .temp_c = -30, .ohm = 898485 }, 72 { .temp_c = -25, .ohm = 655802 }, 73 { .temp_c = -20, .ohm = 483954 }, 74 { .temp_c = -15, .ohm = 360850 }, 75 { .temp_c = -10, .ohm = 271697 }, 76 { .temp_c = -5, .ohm = 206463 }, 77 { .temp_c = 0, .ohm = 158214 }, [all …]
|
/kernel/linux/linux-5.10/arch/arm/boot/dts/ |
D | cros-adc-thermistors.dtsi | 16 pullup-ohm = <47000>; 17 pulldown-ohm = <0>; 23 pullup-ohm = <47000>; 24 pulldown-ohm = <0>; 30 pullup-ohm = <47000>; 31 pulldown-ohm = <0>; 37 pullup-ohm = <47000>; 38 pulldown-ohm = <0>;
|
D | exynos3250-monk.dts | 147 pullup-ohm = <100000>; 148 pulldown-ohm = <100000>; 155 pullup-ohm = <100000>; 156 pulldown-ohm = <100000>;
|
D | exynos3250-rinato.dts | 147 pullup-ohm = <100000>; 148 pulldown-ohm = <100000>; 155 pullup-ohm = <100000>; 156 pulldown-ohm = <100000>;
|
D | exynos4412-midas.dtsi | 310 pullup-ohm = <100000>; /* 100K */ 311 pulldown-ohm = <100000>; /* 100K */ 318 pullup-ohm = <100000>; /* 100K */ 319 pulldown-ohm = <100000>; /* 100K */
|
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/iio/potentiostat/ |
D | lmp91000.txt | 14 - ti,external-tia-resistor: if the property ti,tia-gain-ohm is not defined this 19 - ti,tia-gain-ohm: ohm value of the internal resistor for the transimpedance 22 - ti,rload-ohm: ohm value of the internal resistor load applied to the gas 30 ti,tia-gain-ohm = <7500>;
|
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/hwmon/ |
D | ntc_thermistor.txt | 24 - "pullup-ohm" Pull up resistor value in ohms 25 - "pulldown-ohm" Pull down resistor value in ohms 41 pullup-ohm = <47000>; 42 pulldown-ohm = <0>;
|
/kernel/linux/linux-5.10/drivers/iio/potentiometer/ |
D | max5432.c | 28 unsigned long ohm; member 52 if (unlikely(data->ohm > INT_MAX)) in max5432_read_raw() 55 *val = data->ohm; in max5432_read_raw() 103 data->ohm = (unsigned long)device_get_match_data(dev); in max5432_probe()
|
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/phy/ |
D | rockchip-emmc-phy.txt | 16 - drive-impedance-ohm: Specifies the drive impedance in Ohm. 35 drive-impedance-ohm = <50>;
|
D | mxs-usb-phy.txt | 18 high-speed trimming resistor connected in parallel with the 45 ohm resistor 21 high-speed trimming resistor connected in parallel with the 45 ohm resistor
|
/kernel/linux/linux-5.10/arch/arm64/boot/dts/rockchip/ |
D | rk3399-gru-kevin.dts | 70 pullup-ohm = <25500>; 71 pulldown-ohm = <0>; 79 pullup-ohm = <25500>; 80 pulldown-ohm = <0>;
|
D | rk3399-puma.dtsi | 149 drive-impedance-ohm = <33>;
|
D | rk3399.dtsi | 1484 drive-impedance-ohm = <50>;
|
/kernel/linux/linux-5.10/arch/arm64/boot/dts/ti/ |
D | k3-j7200-common-proc-board.dts | 184 ti,driver-strength-ohm = <50>; 192 ti,driver-strength-ohm = <50>;
|
D | k3-am654-base-board.dts | 312 ti,driver-strength-ohm = <50>; 324 ti,driver-strength-ohm = <50>;
|
D | k3-j721e-common-proc-board.dts | 292 ti,driver-strength-ohm = <50>; 300 ti,driver-strength-ohm = <50>;
|
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/ |
D | property-units.txt | 30 -ohms : ohm
|
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/input/touchscreen/ |
D | tsc2005.txt | 14 in ohm (defaults to 280)
|
/kernel/linux/linux-5.10/arch/arm64/boot/dts/exynos/ |
D | exynos5433-tm2-common.dtsi | 145 pullup-ohm = <100000>; 146 pulldown-ohm = <0>; 153 pullup-ohm = <100000>; 154 pulldown-ohm = <0>; 162 pullup-ohm = <100000>; 163 pulldown-ohm = <0>;
|
/kernel/linux/linux-5.10/Documentation/admin-guide/auxdisplay/ |
D | cfag12864b.rst | 75 Ground (21)---[GND] [GND]---[P1]---(18) Vee - R = Resistor = 22 ohm
|
/kernel/linux/linux-5.10/Documentation/ABI/testing/ |
D | sysfs-bus-iio | 1617 into an ohm value.
|
/kernel/linux/patches/linux-5.10/hispark_taurus_patch/ |
D | hispark_taurus.patch | 49783 + when pin No.25 via 4.7k-ohm to DVDD-RG. 51535 + * USB Trim config:45ohm HS ODT value tuning & FS/LS
|
/kernel/linux/patches/linux-4.19/hispark_taurus_patch/ |
D | hispark_taurus.patch | 319662 + /* set drv strength to 50ohm */ 320307 + /* set drv strength to 50ohm */ 343493 + when pin No.25 via 4.7k-ohm to DVDD-RG. 349779 + * USB Trim config:45ohm HS ODT value tuning & FS/LS 350095 + * USB Trim config:45ohm HS ODT value tuning & FS/LS 352267 + * USB Trim config:45ohm HS ODT value tuning & FS/LS 352961 + * USB Trim config:45ohm HS ODT value tuning & FS/LS
|