Home
last modified time | relevance | path

Searched refs:synchronous (Results 1 – 25 of 139) sorted by relevance

123456

/kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/
Dfsl-sai.txt4 which provides a synchronous audio interface that supports fullduplex
38 - fsl,sai-synchronous-rx: This is a boolean property. If present, indicating
39 that SAI will work in the synchronous mode (sync Tx
61 - If both fsl,sai-asynchronous and fsl,sai-synchronous-rx are absent, the
62 default synchronous mode (sync Rx with Tx) will be used, which means both
65 - fsl,sai-asynchronous and fsl,sai-synchronous-rx are exclusive.
Dfsl,esai.txt44 - fsl,esai-synchronous: This is a boolean property. If present, indicating
45 that ESAI would work in the synchronous mode, which
66 fsl,esai-synchronous;
/kernel/linux/linux-5.10/Documentation/ABI/testing/
Dsysfs-bus-counter-104-quad-831 non-synchronous load mode.
46 non-synchronous or synchronous load mode. Synchronous load mode
50 non-synchronous:
56 synchronous:
Dsysfs-bus-iio-counter-104-quad-877 synchronous load mode. In quadrature clock mode, the channel Y
109 non-synchronous load mode.
117 Configure channel Y counter for non-synchronous or synchronous
121 Non-synchronous:
Dconfigfs-most23 (needed for synchronous and isochrnous data)
78 (needed for synchronous and isochrnous data)
133 (needed for synchronous and isochrnous data)
199 (needed for synchronous and isochrnous data)
Dsysfs-block-bcache97 What: /sys/block/<disk>/bcache/synchronous
101 For a cache, a boolean that allows synchronous mode to be
102 switched on and off. In synchronous mode all writes are ordered
/kernel/linux/linux-5.10/drivers/scsi/pcmcia/
Daha152x_stub.c64 static int synchronous = 1; variable
71 module_param(synchronous, int, 0);
168 s.synchronous = synchronous; in aha152x_config_cs()
/kernel/linux/linux-5.10/Documentation/block/
Dkyber-iosched.rst6 reads and synchronous writes. Kyber will throttle requests in order to meet
15 Target latency for synchronous writes (in nanoseconds).
/kernel/linux/linux-5.10/drivers/gpu/drm/i915/display/
Dintel_fbdev.h19 void intel_fbdev_set_suspend(struct drm_device *dev, int state, bool synchronous);
40 static inline void intel_fbdev_set_suspend(struct drm_device *dev, int state, bool synchronous) in intel_fbdev_set_suspend() argument
/kernel/linux/linux-5.10/drivers/hsi/
DKconfig8 The "High speed synchronous Serial Interface" is
9 synchronous serial interface used mainly to connect
/kernel/linux/linux-5.10/sound/soc/fsl/
Dfsl_sai.c55 return !sai->synchronous[dir] && sai->synchronous[adir]; in fsl_sai_dir_is_synced()
419 } else if (!sai->synchronous[dir]) { in fsl_sai_set_bclk()
597 sai->synchronous[TX] ? FSL_SAI_CR2_SYNC : 0); in fsl_sai_trigger()
599 sai->synchronous[RX] ? FSL_SAI_CR2_SYNC : 0); in fsl_sai_trigger()
1069 sai->synchronous[RX] = true; in fsl_sai_probe()
1070 sai->synchronous[TX] = false; in fsl_sai_probe()
1084 sai->synchronous[RX] = false; in fsl_sai_probe()
1085 sai->synchronous[TX] = true; in fsl_sai_probe()
1088 sai->synchronous[RX] = false; in fsl_sai_probe()
1089 sai->synchronous[TX] = false; in fsl_sai_probe()
Dfsl_esai.c84 bool synchronous; member
269 bool tx = (clk_id <= ESAI_HCKT_EXTAL || esai_priv->synchronous); in fsl_esai_set_dai_sysclk()
304 ecr |= esai_priv->synchronous ? ESAI_ECR_ETI : ESAI_ECR_ERI; in fsl_esai_set_dai_sysclk()
524 ESAI_SAICR_SYNC, esai_priv->synchronous ? in fsl_esai_startup()
559 ret = fsl_esai_set_bclk(dai, esai_priv->synchronous || tx, bclk); in fsl_esai_hw_params()
568 if (!tx && esai_priv->synchronous) in fsl_esai_hw_params()
1042 esai_priv->synchronous = in fsl_esai_probe()
1046 if (esai_priv->synchronous) { in fsl_esai_probe()
Dfsl_ssi.c255 bool synchronous; member
772 tx2 = tx || ssi->synchronous; in fsl_ssi_set_bclk()
833 if (ssi->streams && ssi->synchronous) in fsl_ssi_hw_params()
857 tx2 = tx || ssi->synchronous; in fsl_ssi_hw_params()
988 if (ssi->synchronous || fsl_ssi_is_ac97(ssi)) { in _fsl_ssi_set_dai_fmt()
1439 ssi->synchronous = true; in fsl_ssi_probe_from_dt()
1541 if (ssi->synchronous && !fsl_ssi_is_ac97(ssi)) { in fsl_ssi_probe()
/kernel/linux/linux-5.10/mm/
Dpage_io.c373 int swap_readpage(struct page *page, bool synchronous) in swap_readpage() argument
382 VM_BUG_ON_PAGE(!PageSwapCache(page) && !synchronous, page); in swap_readpage()
435 if (synchronous) { in swap_readpage()
443 while (synchronous) { in swap_readpage()
/kernel/linux/linux-5.10/drivers/staging/most/Documentation/
Ddriver_usage.txt20 another or in a network configuration. As a synchronous network, MOST
132 synchronous and isochrnous data)
165 Setting up synchronous channels to be mapped as an ALSA sound adapter is a two
199 When transceiving synchronous or isochronous data, the number of packets
205 When transmitting synchronous data the allocated channel width needs to be
210 The driver, then, calculates the synchronous threshold as follows:
220 This frame_size is the number of synchronous data within an USB
232 (subbuffer_size * packts_per_xact) bytes for synchronous data need to
/kernel/linux/linux-5.10/Documentation/hid/
Dhid-transport.rst79 The terms "asynchronous" and "synchronous" in this document describe the
81 not perform any synchronous operations like waiting for acknowledgements or
84 On the other hand, synchronous channels can be implemented by the transport
105 - Control Channel (ctrl): The ctrl channel is used for synchronous requests and
111 Outgoing reports are usually sent on the ctrl channel via synchronous
142 channel provides synchronous GET/SET_REPORT requests. Plain reports are only
147 requested report ID on the ctrl channel as a synchronous acknowledgement.
168 A device must answer with a synchronous acknowledgement. However, HID core
173 multiple synchronous SET_REPORT requests.
320 be synchronous. A transport driver must not use ->wait() to complete such
[all …]
/kernel/linux/linux-5.10/drivers/net/ppp/
DKconfig24 synchronous PPP which can be used over digital ISDN lines for
28 synchronous lines, you should say Y (or M) here and to "Support
29 synchronous PPP", below.
159 a modem (not a synchronous or ISDN modem) to contact your ISP, you
170 Say Y (or M) here if you want to be able to use PPP over synchronous
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/memory-controllers/
Domap-gpmc.txt55 - gpmc,sync-clk-ps: Minimum clock period for synchronous mode, in picoseconds
105 - gpmc,wr-access-ns: In synchronous write mode, for single or
128 - gpmc,sync-read Enables synchronous read. Defaults to asynchronous
130 - gpmc,sync-write Enables synchronous writes. Defaults to asynchronous
/kernel/linux/linux-5.10/drivers/scsi/
Daha152x.c446 int synchronous; /* synchronous transferes enabled */ member
548 #define SYNCHRONOUS (HOSTDATA(shpnt)->synchronous)
744 SYNCHRONOUS = setup->synchronous; in aha152x_probe_one()
1734 if (!HOSTDATA(shpnt)->synchronous) in msgi_run()
3051 if ((setup->synchronous < 0) || (setup->synchronous > 1)) in checksetup()
3096 override.synchronous, in aha152x_init()
3117 override.synchronous, in aha152x_init()
3135 setup[setup_count].synchronous = aha152x[5]; in aha152x_init()
3145 setup[setup_count].synchronous = sync[0]; in aha152x_init()
3159 setup[setup_count].synchronous, in aha152x_init()
[all …]
/kernel/linux/linux-5.10/drivers/net/wan/
DKconfig32 operates on low speed synchronous serial links at up to
43 Driver for COSA and SRP synchronous serial boards.
45 These boards allow to connect synchronous serial devices (for example
48 character device, synchronous PPP network device, or the Cisco HDLC
69 - LMC 1000 board allows you to connect synchronous serial devices
109 Relay, synchronous Point-to-Point Protocol (PPP) and X.25.
259 8Mb/s (128K on V.24) using synchronous PPP, Cisco HDLC, raw HDLC,
318 tristate "Intel IXP4xx HSS (synchronous serial port) support"
/kernel/linux/linux-5.10/drivers/siox/
DKconfig5 SIOX stands for Serial Input Output eXtension and is a synchronous
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/serial/
Ddigicolor-usart.txt4 UART. USART also support synchronous serial protocols like SPI and I2S. Use
/kernel/linux/linux-5.10/Documentation/driver-api/
Dxillybus.rst144 Xillybus pipes are configured (on the IP core) to be either synchronous or
145 asynchronous. For a synchronous pipe, write() returns successfully only after
156 has been requested by a read() call. On synchronous pipes, only the amount
159 In summary, for synchronous pipes, data between the host and FPGA is
172 A synchronous pipe can be configured to have the stream's position exposed
216 * synchronous: A non-zero value means that the pipe is synchronous. See
303 the "synchronous" attribute nonzero, since synchronous pipes don't allow data
/kernel/linux/linux-5.10/Documentation/admin-guide/device-mapper/
Ddm-io.rst5 Dm-io provides synchronous and asynchronous I/O services. There are three
64 all of the synchronous versions, is a bitset (instead of a simple error value).
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/
Dintel,ixp4xx-gpio.txt7 the synchronous edge detector is part of the GPIO block, but the

123456