Lines Matching refs:O
28 The RocketPort ISA board requires I/O ports to be configured by the DIP
32 You pass the I/O port to the driver using the following module parameters:
35 I/O port for the first ISA board
37 I/O port for the second ISA board
39 I/O port for the third ISA board
41 I/O port for the fourth ISA board
91 You must assign and configure the I/O addresses used by the ISA Rocketport
96 Setting the I/O address
100 a range of I/O addresses for it to use. The first RocketPort card
101 requires a 68-byte contiguous block of I/O addresses, starting at one
103 0x300h, 0x340h, 0x380h. This I/O address must be reflected in the DIP
107 contiguous block of I/O addresses, starting at one of the following
108 I/O addresses: 0x100h, 0x140h, 0x180h, 0x1C0h, 0x200h, 0x240h, 0x280h,
109 0x2C0h, 0x300h, 0x340h, 0x380h, 0x3C0h. The I/O address used by the
111 software control. The DIP switch settings for the I/O address must be
122 The I/O address range used by any of the RocketPort cards must not
124 RocketPort cards. Below, you will find a list of commonly used I/O
127 identifying what I/O addresses are being used by devices on your
130 Remember, the FIRST RocketPort uses 68 I/O addresses. So, if you set it
142 | Unused| Card | I/O Port Block|
153 DIP Switches I/O Address Range