Lines Matching full:signals

20  * Further, not all signals can be unmuxed, as some expressions depend on
39  * C5 is a multi-signal pin (high and low priority signals). Here we touch
57  * bit in the STRAP register. The ACPI bit configures signals on pins in
78  * selecting the signals on pin E18)
119  * signals, but is used to decent effect with some of the UARTs where not all
120  * signals are required. However, this isn't done consistently - UART1 is
121  * enabled on a per-pin basis, and by contrast, all signals for UART6 are
124  * Further, the high and low priority signals listed in the table above share
125  * a configuration bit. The VPI signals should operate in concert in a single
126  * function, but the UART signals should retain the ability to be configured
129  * defining masks affecting multiple signals per function. The latter approach
131  * interest will stomp on the state of other UART signals when disabling the
145  * pins in the function's group to disable the higher-priority signals such
155  * * Pins provide signals according to functions activated in the mux
162  * * Enabling lower priority signals requires higher priority signals be
165  * * A function represents a set of signals; functions are distinct if they
166  *   do not share a subset of signals (and may be distinct if they are a
169  * * Signals participate in one or more functions or groups
194  *   by deactivating all functions that activate higher priority signals on the
199  * * T5 provides three signals types: VPIDE, NDCD1 and GPIO
472  * A struct capturing the list of expressions enabling signals at each priority
593  * signals available on a pin.