Lines Matching refs:STA

64 	* added AKMSuiteSelector into "STA <addr>" control interface data to
226 	  the STA has some more time to configure the key before this frame is
229 	* extended VLAN support (per-STA vif, etc.)
242 	    unassociated STA used that address
300 	* add support for learning STA IPv4/IPv6 addresses and configuring
321 	* expire hostapd STA entry if kernel does not have a matching entry
373 	* fixed STA validation step for WPS ER commands to prevent a potential
476 	* added AP-STA-DISCONNECTED ctrl_iface event
567 	  (do not send QoS frames if the STA did not negotiate use of QoS for
574 	* Delay STA entry removal until Deauth/Disassoc TX status in AP mode.
576 	  Disassociation frames when the STA is in power save sleep. Only
593 	* Add bridge handling for WDS STA interfaces. By default they are
598 	  - Add wds_bridge command for specifying bridge for WDS STA
601 	  - Send AP-STA-DISCONNECTED event when an AP disconnects a station
610 	  Use hostapd_cli ess_disassoc (STA addr) (URL) to send the
611 	  notification to the STA.
613 	  the data connection is not working properly, e.g., due to the STA
737 	* driver_nl80211: fixed STA accounting data collection (TX/RX bytes
941 	  for each STA based on RADIUS Access-Accept attributes); this requires
963 	* added 'hostapd_cli new_sta <addr>' command for adding a new STA into
1085 	* fixed PMKSA caching for the case where STA (re)associates without
1202 	* fixed EAPOL state machine to stop if STA is removed during
1241 	* fixed STA disassociation handler to mark next timeout state to
1243 	  and extra disassociation, if the STA disassociates without
1279 	  not start EAPOL state machines if the STA selected to use WPA-PSK)
1292 	  to the STA before sending a new one
1299 	  - allow different update intervals for each STA
1304 	  STA immediately (e.g., if STA deauthenticates and re-associates
1314 	  previously sent after the kernel entry for the STA (and/or IEEE