Searched full:applicable (Results 1 – 25 of 1277) sorted by relevance
12345678910>>...52
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/timer/ |
| D | ti,timer.txt | 11 ti,omap2420-timer (applicable to OMAP24xx devices)
12 ti,omap3430-timer (applicable to OMAP3xxx/44xx devices)
13 ti,omap4430-timer (applicable to OMAP44xx devices)
14 ti,omap5430-timer (applicable to OMAP543x devices)
15 ti,am335x-timer (applicable to AM335x devices)
16 ti,am335x-timer-1ms (applicable to AM335x devices)
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-dv.rst | 47 read-only control is applicable to DVI-D, HDMI and DisplayPort
56 that pad will be 0. This read-only control is applicable to DVI-D
65 is applicable to VGA, DVI-A/D, HDMI and DisplayPort connectors.
74 This control is applicable to HDMI connectors.
88 the number of bits per component. This control is applicable to VGA,
132 will be 0. This read-only control is applicable to DVI-D, HDMI and
147 the number of bits per component. This control is applicable to VGA,
|
| D | ext-ctrls-codec.rst | 14 These controls are applicable to all codecs and not just MPEG. The
591 Constant quality level control. This control is applicable when
680 Applicable to the decoder, all codecs.
684 Information. Applicable to the H264 encoder.
693 defined in the table E-1 in the standard. Applicable to the H264
743 Applicable to the H264 encoder.
747 Applicable to the H264 encoder.
756 Applicable to the H264 encoder. Possible values are:
813 The level information for the MPEG2 elementary stream. Applicable to
839 The level information for the MPEG4 elementary stream. Applicable to
[all …]
|
| D | dev-event.rst | 42 3. Where applicable, certain event types can ensure that the payload of
47 subscribe to whether this is applicable for that event or not.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-max77620.txt | 68 This is applicable if FPS source is
75 This is applicable if FPS source is
88 This is applicable if suspend state
96 This is applicable if suspend state
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/net/ |
| D | ti,dp83867.yaml | 63 for applicable values. The CLK_OUT pin can also be disabled by this
70 for applicable values. Required only if interface type is
77 for applicable values. Required only if interface type is
106 Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h for applicable
|
| /kernel/linux/linux-5.10/include/linux/mfd/syscon/ |
| D | atmel-smc.h | 81 * @setup: NCS/NWE/NRD setup timings (not applicable to at91rm9200)
82 * @pulse: NCS/NWE/NRD pulse timings (not applicable to at91rm9200)
83 * @cycle: NWE/NRD cycle timings (not applicable to at91rm9200)
84 * @timings: advanced NAND related timings (only applicable to HSMC)
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/ |
| D | tps65090.txt | 17 - ti,enable-ext-control: This is applicable for DCDC1, DCDC2 and DCDC3.
19 - dcdc-ext-control-gpios: This is applicable for DCDC1, DCDC2 and DCDC3.
24 - ti,overcurrent-wait: This is applicable to FET registers, which have a
|
| D | regulator-max77620.txt | 66 This is applicable if FPS source is
73 This is applicable if FPS source is
86 This is applicable if suspend state
94 This is applicable if suspend state
|
| /kernel/linux/linux-5.10/include/uapi/linux/ |
| D | virtio_mem.h | 136 * Request processed successfully, applicable for
144 * Request denied - e.g. trying to plug more than requested, applicable for
149 * Request cannot be processed right now, try again later, applicable for
156 * Error in request (e.g. addresses/alignment), applicable for
|
| /kernel/linux/linux-5.10/arch/m68k/fpsp040/ |
| D | README | 10 To the maximum extent permitted by applicable law,
17 To the maximum extent permitted by applicable law,
|
| /kernel/linux/linux-5.10/include/linux/ |
| D | pldmfw.h | 39 /* Bitmap of components applicable to this record */
145 * component to firmware. Called once for each applicable component.
148 * Called once for each applicable component, after all component tables have
|
| /kernel/liteos_m/arch/include/ |
| D | los_interrupt.h | 92 * applicable for a Cortex-A7 platform is [32,95].</li>
97 * @param hwiNum [IN] Type#HWI_HANDLE_T: hardware interrupt number. The value range applicable
121 * applicable for a Cortex-A7 platform is [32,95].</li>
126 …* @param hwiNum [IN] Type#HWI_HANDLE_T: hardware interrupt number. The value range applicable f…
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/phy/ |
| D | qcom,qusb2-phy.yaml | 115 See dt-bindings/phy/phy-qcom-qusb2.h for applicable values.
125 See dt-bindings/phy/phy-qcom-qusb2.h for applicable values.
136 See dt-bindings/phy/phy-qcom-qusb2.h for applicable values.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mfd/ |
| D | tps65086.txt | 25 - ti,regulator-step-size-25mv : This is applicable for buck[1-6], set this
28 - ti,regulator-decay : This is applicable for buck[1-6], set this if
|
| /kernel/linux/linux-5.10/tools/perf/pmu-events/arch/x86/broadwellx/ |
| D | floating-point.json | 5 … "BriefDescription": "Number of transitions from AVX-256 to legacy SSE when penalty applicable.",
9 …his event counts the number of transitions from AVX-256 to legacy SSE when penalty is applicable.",
16 "BriefDescription": "Number of transitions from SSE to AVX-256 when penalty applicable.",
20 …his event counts the number of transitions from legacy SSE to AVX-256 when penalty is applicable.",
|
| /kernel/linux/linux-5.10/tools/perf/pmu-events/arch/x86/broadwellde/ |
| D | floating-point.json | 5 … "BriefDescription": "Number of transitions from AVX-256 to legacy SSE when penalty applicable.",
9 …his event counts the number of transitions from AVX-256 to legacy SSE when penalty is applicable.",
16 "BriefDescription": "Number of transitions from SSE to AVX-256 when penalty applicable.",
20 …his event counts the number of transitions from legacy SSE to AVX-256 when penalty is applicable.",
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/clock/ |
| D | samsung,s3c64xx-clock.txt | 4 within the SoC. The clock binding described here is applicable to all SoCs in
20 on a particular S3C64xx SoC and this is specified where applicable.
|
| /kernel/linux/linux-5.10/kernel/trace/ |
| D | trace_dynevent.c | 237 * applicable. Before the argument is added, the @check_arg function,
277 * followed by a separator, if applicable. This can be used to add
281 * followed by an operator, if applicable, followd by the rhs string,
282 * followed finally by a separator, if applicable. Before the
404 * whitespace, all followed by a separator, if applicable. After the
|
| /kernel/linux/linux-5.10/Documentation/crypto/ |
| D | intro.rst | 57 following phases that are reflected in the API calls applicable to such
62 2. Execution of all intended cipher operations applicable for the handle
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/device-mapper/ |
| D | writecache.rst | 46 applicable only to persistent memory - use the FUA flag
50 applicable only to persistent memory - don't use the FUA
|
| /kernel/linux/linux-5.10/tools/perf/pmu-events/arch/x86/broadwell/ |
| D | floating-point.json | 4 …vent that counts the number of transitions from AVX-256 to legacy SSE when penalty is applicable.",
11 …ption": "Number of transitions from AVX-256 to legacy SSE when penalty applicable (Precise Event)",
16 …vent that counts the number of transitions from legacy SSE to AVX-256 when penalty is applicable.",
23 …ption": "Number of transitions from legacy SSE to AVX-256 when penalty applicable (Precise Event)",
|
| /kernel/linux/linux-5.10/tools/perf/pmu-events/arch/x86/haswell/ |
| D | floating-point.json | 11 … "BriefDescription": "Number of transitions from AVX-256 to legacy SSE when penalty applicable",
23 … "BriefDescription": "Number of transitions from legacy SSE to AVX-256 when penalty applicable",
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/hsi/ |
| D | omap-ssi.txt | 31 ti,omap3-ssi-port (applicable to OMAP34xx devices)
32 ti,omap4-hsi-port (applicable to OMAP44xx devices)
|
| /kernel/linux/linux-5.10/Documentation/power/ |
| D | power_supply_class.rst | 10 It defines core set of attributes, which should be applicable to (almost)
15 the attributes provided are believed to be universally applicable to any
21 if it will be found that some attribute is applicable to many power supply
265 it is useful. Of course, if the attribute in question applicable to
|
12345678910>>...52