Home
last modified time | relevance | path

Searched +full:bd71847 +full:- +full:pmic (Results 1 – 11 of 11) sorted by relevance

/kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/
Drohm,bd71847-regulator.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71847-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: ROHM BD71847 and BD71850 Power Management Integrated Circuit regulators
10 - Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
13 List of regulators provided by this controller. BD71847 regulators node
14 should be sub node of the BD71847 MFD node. See BD71847 MFD bindings at
15 Documentation/devicetree/bindings/mfd/rohm,bd71847-pmic.yaml
20 Note that if BD71847 starts at RUN state you probably want to use
[all …]
/kernel/linux/linux-5.10/Documentation/devicetree/bindings/mfd/
Drohm,bd71847-pmic.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/mfd/rohm,bd71847-pmic.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: ROHM BD71847 and BD71850 Power Management Integrated Circuit bindings
10 - Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
14 single-core, dual-core, and quad-core SoCs such as NXP-i.MX 8M. It is
18 …/www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applica…
19 …//www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applic…
24 - rohm,bd71847
[all …]
/kernel/linux/linux-5.10/drivers/mfd/
Drohm-bd718x7.c1 // SPDX-License-Identifier: GPL-2.0-or-later
5 // ROHM BD71837MWV and BD71847MWV PMIC driver
8 // https://www.rohm.com/datasheet/BD71837MWV/bd71837mwv-e
14 #include <linux/mfd/rohm-bd718x7.h>
23 .gpio = -1,
30 .name = "bd718xx-pwrkey",
35 .name = "gpio-keys",
39 { .name = "bd71837-clk", },
40 { .name = "bd71837-pmic", },
45 .name = "gpio-keys",
[all …]
/kernel/linux/linux-5.10/drivers/regulator/
Dbd718x7-regulator.c1 // SPDX-License-Identifier: GPL-2.0
3 // bd71837-regulator.c ROHM BD71837MWV/BD71847MWV regulator driver
9 #include <linux/mfd/rohm-bd718x7.h>
50 * controlled by software - or by PMIC internal HW state machine. Whether
51 * regulator should be under SW or HW control can be defined from device-tree.
95 dev_dbg(&rdev->dev, "Buck[%d] Set Ramp = %d\n", id + 1, in bd718xx_buck1234_set_ramp_delay()
112 dev_err(&rdev->dev, in bd718xx_buck1234_set_ramp_delay()
114 rdev->desc->name, ramp_delay); in bd718xx_buck1234_set_ramp_delay()
117 return regmap_update_bits(rdev->regmap, BD718XX_REG_BUCK1_CTRL + id, in bd718xx_buck1234_set_ramp_delay()
122 * We assume PMIC is in RUN state because SW running and able to query the
[all …]
/kernel/linux/linux-5.10/arch/arm64/boot/dts/freescale/
Dimx8mn-ddr4-evk.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
9 #include "imx8mn-evk.dtsi"
13 compatible = "fsl,imx8mn-ddr4-evk", "fsl,imx8mn";
17 cpu-supply = <&buck2_reg>;
21 cpu-supply = <&buck2_reg>;
25 cpu-supply = <&buck2_reg>;
29 cpu-supply = <&buck2_reg>;
33 operating-points-v2 = <&ddrc_opp_table>;
35 ddrc_opp_table: opp-table {
[all …]
Dimx8mm-beacon-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
8 compatible = "mmc-pwrseq-simple";
9 pinctrl-names = "default";
10 pinctrl-0 = <&pinctrl_usdhc1_gpio>;
11 reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
13 clock-names = "ext_clock";
14 post-power-on-delay-ms = <80>;
24 cpu-supply = <&buck2_reg>;
28 operating-points-v2 = <&ddrc_opp_table>;
30 ddrc_opp_table: opp-table {
[all …]
Dimx8mm-evk.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
8 #include <dt-bindings/usb/pd.h>
13 stdout-path = &uart2;
22 compatible = "gpio-leds";
23 pinctrl-names = "default";
24 pinctrl-0 = <&pinctrl_gpio_led>;
29 default-state = "on";
33 reg_usdhc2_vmmc: regulator-usdhc2 {
34 compatible = "regulator-fixed";
[all …]
Dimx8mm-var-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
10 model = "Variscite VAR-SOM-MX8MM module";
11 compatible = "variscite,var-som-mx8mm", "fsl,imx8mm";
14 stdout-path = &uart4;
22 reg_eth_phy: regulator-eth-phy {
23 compatible = "regulator-fixed";
24 pinctrl-names = "default";
25 pinctrl-0 = <&pinctrl_reg_eth_phy>;
26 regulator-name = "eth_phy_pwr";
27 regulator-min-microvolt = <3300000>;
[all …]
Dimx8mn-var-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4 * Copyright 2019-2020 Variscite Ltd.
11 model = "Variscite VAR-SOM-MX8MN module";
12 compatible = "variscite,var-som-mx8mn", "fsl,imx8mn";
15 stdout-path = &uart4;
23 reg_eth_phy: regulator-eth-phy {
24 compatible = "regulator-fixed";
25 pinctrl-names = "default";
26 pinctrl-0 = <&pinctrl_reg_eth_phy>;
27 regulator-name = "eth_phy_pwr";
[all …]
/kernel/linux/linux-5.10/drivers/clk/
DKconfig1 # SPDX-License-Identifier: GPL-2.0
76 These multi-function devices have two fixed-rate oscillators, clocked at 32KHz each.
85 This driver supports the hi655x PMIC clock. This
86 multi-function device has one fixed-rate oscillator, clocked
117 be pre-programmed to support other configurations and features not yet
166 This driver supports TI CDCE706 programmable 3-PLL clock synthesizer.
176 For example, the CDCE925 contains two PLLs with spread-spectrum
186 tristate "Clock driver for CS2000 Fractional-N Clock Synthesizer & Clock Multiplier"
229 clock. These multi-function devices have two (S2MPS14) or three
230 (S2MPS11, S5M8767) fixed-rate oscillators, clocked at 32KHz each.
[all …]
/kernel/linux/patches/linux-5.10/imx8mm_patch/patches/
D0001_linux_arch.patch7 Change-Id: I8c7b42f8858212fb4b2d56a871d3f4d5afc73954
9 diff --git a/arch/arm64/Kconfig b/arch/arm64/Kconfig
11 --- a/arch/arm64/Kconfig
13 @@ -183,7 +183,6 @@ config ARM64
17 - select HOLES_IN_ZONE
21 @@ -1023,6 +1022,9 @@ config NEED_PER_CPU_EMBED_FIRST_CHUNK
31 @@ -1148,7 +1150,7 @@ config XEN
35 - int
40 @@ -1182,15 +1184,6 @@ config UNMAP_KERNEL_AT_EL0
44 -config MITIGATE_SPECTRE_BRANCH_HISTORY
[all …]