Searched full:relays (Results 1 – 12 of 12) sorted by relevance
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | axentia,tse850-pcm5142.txt | 8 - axentia,loop1-gpios: gpio specifier that controls loop relays on channel 1.
9 - axentia,loop2-gpios: gpio specifier that controls loop relays on channel 2.
15 loop1 relays
30 loop2 relays
32 The 'loop1' gpio pin controlls two relays, which are either in loop position,
37 In the above, the 'loop1' relays are inactive, thus feeding IN1 to the mixer
38 (if 'add' is active) and feeding the mixer output to OUT1. The 'loop2' relays
|
| /kernel/linux/linux-5.10/sound/soc/atmel/ |
| D | tse850-pcm5142.c | 9 // loop1 relays
24 // loop2 relays
26 // The 'loop1' gpio pin controlls two relays, which are either in loop
31 // In the above, the 'loop1' relays are inactive, thus feeding IN1 to the
33 // 'loop2' relays are active, short-cutting the TSE-850 from channel 2.
271 * regard to the loop1 and loop2 relays that according to this only
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interconnect/ |
| D | qcom,osm-l3.yaml | 15 from CPU/GPU and relays it to the OSM.
|
| /kernel/linux/linux-5.10/drivers/staging/comedi/drivers/ |
| D | aio_iiro_16.c | 201 /* get the initial state of the relays */ in aio_iiro_16_attach()
|
| D | ni_mio_common.c | 1745 /* Allow relays to change */ in ni_load_channelgain_list()
1756 /* Allow relays to change */ in ni_load_channelgain_list()
|
| /kernel/linux/linux-5.10/net/wimax/ |
| D | op-msg.c | 310 * Relays a message from user space to the driver
|
| /kernel/linux/linux-5.10/arch/powerpc/include/asm/ |
| D | eeh.h | 315 * If this macro yields TRUE, the caller relays to eeh_check_failure()
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/nouveau/nvkm/engine/gr/ |
| D | nv50.c | 409 /* DISPATCH: Relays commands to other units and handles NOTIFY, in nv50_gr_trap_handler()
|
| /kernel/linux/linux-5.10/include/linux/ |
| D | ftrace.h | 908 * It relays on ftrace_return_to_handler.
|
| /kernel/linux/linux-5.10/Documentation/networking/ |
| D | ip-sysctl.rst | 706 but your clients and relays, contacting you. While you see
|
| /kernel/linux/linux-5.10/drivers/media/pci/bt8xx/ |
| D | bttv-cards.c | 3196 O1,O2,O3 - alarm outputs (relays)
|
| /kernel/linux/linux-5.10/kernel/ |
| D | workqueue.c | 236 * The externally visible workqueue. It relays the issued work items to
|