Searched refs:FCR (Results 1 – 15 of 15) sorted by relevance
| /kernel/linux/linux-5.10/arch/x86/boot/ |
| D | early_serial_console.c | 16 #define FCR 2 /* FIFO control */ macro
33 outb(0, port + FCR); /* no fifo */ in early_serial_init()
|
| /kernel/linux/linux-5.10/arch/sparc/include/asm/ |
| D | ns87303.h | 17 #define FCR 0x03 macro
|
| D | floppy_64.h | 705 ns87303_modify(config, FCR, 0, FCR_LDE); in sun_floppy_init()
|
| /kernel/liteos_m/arch/xtensa/lx6/gcc/ |
| D | los_arch_macro.h | 50 wur.FCR a3
139 rur.FCR a3
|
| /kernel/linux/linux-5.10/arch/arm/mach-orion5x/ |
| D | tsx09-common.c | 37 writel(0x00, UART1_REG(FCR)); in qnap_tsx09_power_off()
|
| D | terastation_pro2-setup.c | 280 writel(0x07, UART1_REG(FCR)); in tsp2_power_off()
|
| D | kurobox_pro-setup.c | 305 writel(0x07, UART1_REG(FCR)); in kurobox_pro_power_off()
|
| /kernel/linux/linux-5.10/drivers/usb/serial/ |
| D | io_16654.h | 33 #define FCR 2 // ! Fifo Control Register (Write) macro
|
| /kernel/linux/linux-5.10/arch/x86/kernel/ |
| D | early_printk.c | 89 #define FCR 2 /* FIFO control */ macro
136 serial_out(early_serial_base, FCR, 0); /* no fifo */ in early_serial_hw_init()
|
| /kernel/linux/linux-5.10/drivers/power/reset/ |
| D | qnap-poweroff.c | 66 writel(0x00, UART1_REG(FCR)); in qnap_power_off()
|
| /kernel/linux/linux-5.10/drivers/net/hamradio/ |
| D | baycom_ser_fdx.c | 96 #define FCR(iobase) (iobase+2) macro
359 outb(0x01, FCR(iobase)); /* enable FIFOs */ in ser12_check_uart()
406 outb(0, FCR(dev->base_addr)); /* disable FIFOs */ in ser12_open()
|
| D | baycom_ser_hdx.c | 82 #define FCR(iobase) (iobase+2) macro
441 outb(0x01, FCR(iobase)); /* enable FIFOs */ in ser12_check_uart()
474 outb(0, FCR(dev->base_addr)); /* disable FIFOs */ in ser12_open()
|
| D | yam.c | 153 #define FCR(iobase) (iobase+2) macro
471 outb(0x00, FCR(dev->base_addr)); in yam_set_uart()
512 outb(0x01, FCR(iobase)); /* enable FIFOs */ in yam_check_uart()
|
| /kernel/linux/linux-5.10/drivers/mtd/nand/raw/ |
| D | diskonchip.c | 122 #define FCR 510 macro
163 s[i] ^= cd->alpha_to[rs_modnn(cd, tmp + (FCR + i) * j)]; in doc_ecc_decode()
169 syn[i] = rs_modnn(cd, cd->index_of[s[i]] + (NN - FCR - i)); in doc_ecc_decode()
1452 doc->rs_decoder = init_rs(10, 0x409, FCR, 1, NROOTS); in doc_probe()
|
| /kernel/linux/patches/linux-5.10/yangfan_patch/ |
| D | drivers.patch | 62186 * LCR DLAB must be set to enable 64-byte FIFO mode. If the FCR
|