| /kernel/linux/linux-5.10/drivers/media/usb/gspca/ |
| D | spca500.c | 479 gspca_err(gspca_dev, "reg_r_wait() failed\n"); in spca500_full_reset()
495 gspca_err(gspca_dev, "Set packet size: set interface error\n"); in spca500_synch310()
510 gspca_err(gspca_dev, "Set packet size: set interface error\n"); in spca500_synch310()
535 gspca_err(gspca_dev, "spca50x_setup_qtable failed on init\n"); in spca500_reinit()
631 gspca_err(gspca_dev, "spca50x_setup_qtable failed\n"); in sd_start()
639 gspca_err(gspca_dev, "reg_r_wait() failed\n"); in sd_start()
652 gspca_err(gspca_dev, "failed to enable drop packet\n"); in sd_start()
658 gspca_err(gspca_dev, "spca50x_setup_qtable failed\n"); in sd_start()
667 gspca_err(gspca_dev, "reg_r_wait() failed\n"); in sd_start()
681 gspca_err(gspca_dev, "spca500_full_reset failed\n"); in sd_start()
[all …]
|
| D | touptek.c | 189 gspca_err(gspca_dev, "reply has error %d\n", rc); in val_reply()
193 gspca_err(gspca_dev, "Bad reply size %d\n", rc); in val_reply()
197 gspca_err(gspca_dev, "Bad reply 0x%02x\n", (int)reply[0]); in val_reply()
215 gspca_err(gspca_dev, "Failed reg_w(0x0B, 0xC0, 0x%04X, 0x%04X) w/ rc %d\n", in reg_w()
221 gspca_err(gspca_dev, "Bad reply to reg_w(0x0B, 0xC0, 0x%04X, 0x%04X\n", in reg_w()
248 gspca_err(gspca_dev, "Invalid width %u\n", w); in setexposure()
366 gspca_err(gspca_dev, "bad width %u\n", w); in configure_wh()
386 gspca_err(gspca_dev, "bad width %u\n", w); in configure_wh()
453 gspca_err(gspca_dev, "failed key req\n"); in configure()
470 gspca_err(gspca_dev, "failed to replay packet 176 w/ rc %d\n", in configure()
[all …]
|
| D | stv0680.c | 75 gspca_err(gspca_dev, "last error: %i, command = 0x%x\n", in stv0680_handle_error()
87 gspca_err(gspca_dev, "Get_Camera_Mode failed\n"); in stv0680_get_video_mode()
105 gspca_err(gspca_dev, "Set_Camera_Mode failed\n"); in stv0680_set_video_mode()
111 gspca_err(gspca_dev, "Error setting camera video mode!\n"); in stv0680_set_video_mode()
135 gspca_err(gspca_dev, "STV(e): camera ping failed!!\n"); in sd_config()
145 gspca_err(gspca_dev, "Could not get descriptor 0200\n"); in sd_config()
156 gspca_err(gspca_dev, "Camera supports neither CIF nor QVGA mode\n"); in sd_config()
|
| D | konica.c | 273 gspca_err(gspca_dev, "urb status: %d\n", urb->status); in sd_isoc_irq()
291 gspca_err(gspca_dev, "lost sync on frames\n"); in sd_isoc_irq()
296 gspca_err(gspca_dev, "no packets does not match, data: %d, status: %d\n", in sd_isoc_irq()
305 gspca_err(gspca_dev, "pkt %d data-status %d, status-status %d\n", in sd_isoc_irq()
314 gspca_err(gspca_dev, "bad status packet length %d\n", in sd_isoc_irq()
360 gspca_err(gspca_dev, "usb_submit_urb(data_urb) ret %d\n", in sd_isoc_irq()
365 gspca_err(gspca_dev, "usb_submit_urb(status_urb) ret %d\n", st); in sd_isoc_irq()
|
| D | dtcs033.c | 65 gspca_err(gspca_dev, "usb error request no: %d / %d\n", in reg_reqs()
168 gspca_err(gspca_dev, "usb error in setexposure(gain) sequence\n"); in dtcs033_setexposure()
173 gspca_err(gspca_dev, "usb error in setexposure(time) sequence\n"); in dtcs033_setexposure()
231 gspca_err(gspca_dev, "Could not initialize controls: %d\n", in dtcs033_init_controls()
|
| D | ov519.c | 2032 gspca_err(gspca_dev, "reg_w %02x failed %d\n", index, ret); in reg_w()
2074 gspca_err(gspca_dev, "reg_r %02x failed %d\n", index, ret); in reg_r()
2107 gspca_err(gspca_dev, "reg_r8 %02x failed %d\n", index, ret); in reg_r8()
2168 gspca_err(gspca_dev, "reg_w32 %02x failed %d\n", index, ret); in ov518_reg_w32()
2343 gspca_err(gspca_dev, "ovfx2_i2c_w %02x failed %d\n", reg, ret); in ovfx2_i2c_w()
2369 gspca_err(gspca_dev, "ovfx2_i2c_r %02x failed %d\n", reg, ret); in ovfx2_i2c_r()
2622 gspca_err(gspca_dev, "error hires sensors only supported with ovfx2\n"); in ov_hires_configure()
2657 gspca_err(gspca_dev, "Error unknown sensor type: %02x%02x\n", in ov_hires_configure()
2674 gspca_err(gspca_dev, "Error detecting sensor type\n"); in ov8xx0_configure()
2680 gspca_err(gspca_dev, "Unknown image sensor version: %d\n", in ov8xx0_configure()
[all …]
|
| D | sq905c.c | 206 gspca_err(gspca_dev, "Get version command failed\n"); in sd_config()
212 gspca_err(gspca_dev, "Reading version command failed\n"); in sd_config()
274 gspca_err(gspca_dev, "Start streaming command failed\n"); in sd_start()
|
| D | spca1528.c | 142 gspca_err(gspca_dev, "wait_status_0 timeout\n"); in wait_status_0()
160 gspca_err(gspca_dev, "wait_status_1 timeout\n"); in wait_status_1()
|
| D | conex.c | 64 gspca_err(gspca_dev, "reg_r: buffer overflow\n"); in reg_r()
103 gspca_err(gspca_dev, "reg_w: buffer overflow\n"); in reg_w()
678 gspca_err(gspca_dev, "Damned Errors sending jpeg Table\n"); in cx11646_jpeg()
|
| D | gspca.c | 90 gspca_err(gspca_dev, "Unknown packet received\n"); in int_irq()
104 gspca_err(gspca_dev, "URB error %i, resubmitting\n", in int_irq()
190 gspca_err(gspca_dev, "submit int URB failed with error %i\n", in alloc_and_submit_int_urb()
277 gspca_err(gspca_dev, "urb status: %d\n", urb->status); in fill_frame()
352 gspca_err(gspca_dev, "urb status: %d\n", urb->status); in bulk_irq()
425 gspca_err(gspca_dev, "frame overflow %d > %d\n", in gspca_frame_add()
876 gspca_err(gspca_dev, "alt %d - bandwidth not wide enough, trying again\n", in gspca_init_transfer()
1307 gspca_err(gspca_dev, "buffer too small (%lu < %lu)\n", in gspca_buffer_prepare()
|
| D | sn9c2028.c | 845 gspca_err(gspca_dev, "Camera Stop read failed\n"); in sd_stopN()
851 gspca_err(gspca_dev, "Camera Stop command failed\n"); in sd_stopN()
|
| D | mr97310a.c | 279 gspca_err(gspca_dev, "status is %02x\n", status); in zero_the_pointer()
319 gspca_err(gspca_dev, "Stream Stop failed\n"); in stream_stop()
327 gspca_err(gspca_dev, "LCD Stop failed\n"); in lcd_stop()
|
| D | gspca.h | 35 #define gspca_err(gspca_dev, fmt, ...) \ macro
|
| D | benq.c | 174 gspca_err(gspca_dev, "ISOC bad lengths %d / %d\n", in sd_isoc_irq()
|
| D | cpia1.c | 412 gspca_err(gspca_dev, "Unexpected first byte of command: %x\n", in cpia_usb_transferCmd()
720 gspca_err(gspca_dev, "unexpected state after lo power cmd: %02x\n", in goto_low_power()
750 gspca_err(gspca_dev, "unexpected state after hi power cmd: %02x\n", in goto_high_power()
1443 gspca_err(gspca_dev, "only firmware version 1 is supported (got: %d)\n", in sd_config()
1469 gspca_err(gspca_dev, "unexpected systemstate: %02x\n", in sd_start()
1517 gspca_err(gspca_dev, "fatal_error: %04x, vp_status: %04x\n", in sd_start()
|
| D | spca505.c | 643 gspca_err(gspca_dev, "register read failed err: %d\n", ret); in sd_start()
|
| D | spca508.c | 1303 gspca_err(gspca_dev, "ssi_w busy %02x\n", in ssi_w()
|
| D | etoms.c | 154 gspca_err(gspca_dev, "reg_r: buffer overflow\n"); in reg_r()
263 gspca_err(gspca_dev, "timeout video on/off\n"); in et_video()
|
| D | sq905.c | 376 gspca_err(gspca_dev, "Start streaming command failed\n"); in sd_start()
|
| D | spca501.c | 1772 gspca_err(gspca_dev, "Reg write failed for 0x%02x,0x%02x,0x%02x\n", in write_vector()
|
| D | sunplus.c | 242 gspca_err(gspca_dev, "reg_r: buffer overflow\n"); in reg_r()
246 gspca_err(gspca_dev, "reg_r: zero-length read\n"); in reg_r()
|
| D | jeilinj.c | 256 gspca_err(gspca_dev, "Start streaming command failed\n"); in jlj_start()
|
| /kernel/linux/linux-5.10/drivers/media/usb/gspca/stv06xx/ |
| D | stv06xx.c | 281 gspca_err(gspca_dev, "Couldn't get altsetting\n"); in stv06xx_start()
356 gspca_err(gspca_dev, "set alt 1 err %d\n", ret); in stv06xx_isoc_nego()
422 gspca_err(gspca_dev, "URB packet length is smaller than the specified chunk length\n"); in stv06xx_pkt_scan()
464 gspca_err(gspca_dev, "Chunk length is non-zero on a SOF\n"); in stv06xx_pkt_scan()
477 gspca_err(gspca_dev, "Chunk length is non-zero on a EOF\n"); in stv06xx_pkt_scan()
|
| /kernel/linux/linux-5.10/drivers/media/usb/gspca/gl860/ |
| D | gl860.c | 564 gspca_err(gspca_dev, "zero-length read request\n"); in gl860_RTx()
573 gspca_err(gspca_dev, "short ctrl transfer %d/%d\n", r, len); in gl860_RTx()
|
| /kernel/linux/linux-5.10/drivers/media/usb/gspca/m5602/ |
| D | m5602_core.c | 396 gspca_err(gspca_dev, "ALi m5602 webcam failed\n"); in m5602_configure()
|