| /kernel/linux/linux-5.10/arch/x86/oprofile/ |
| D | nmi_int.c | 156 kfree(per_cpu(cpu_msrs, i).multiplex); in nmi_shutdown_mux()
157 per_cpu(cpu_msrs, i).multiplex = NULL; in nmi_shutdown_mux()
172 per_cpu(cpu_msrs, i).multiplex = in nmi_setup_mux()
174 if (!per_cpu(cpu_msrs, i).multiplex) in nmi_setup_mux()
184 struct op_msr *multiplex = msrs->multiplex; in nmi_cpu_setup_mux() local
191 multiplex[i].saved = -(u64)counter_config[i].count; in nmi_cpu_setup_mux()
193 multiplex[i].saved = 0; in nmi_cpu_setup_mux()
203 struct op_msr *multiplex = msrs->multiplex; in nmi_cpu_save_mpx_registers() local
209 rdmsrl(counters[i].addr, multiplex[virt].saved); in nmi_cpu_save_mpx_registers()
216 struct op_msr *multiplex = msrs->multiplex; in nmi_cpu_restore_mpx_registers() local
[all …]
|
| D | op_x86_model.h | 26 struct op_msr *multiplex; member
|
| /kernel/linux/linux-5.10/drivers/video/fbdev/ |
| D | s3fb.c | 605 u32 value, mode, hmul, offset_value, screen_size, multiplex, dbytes; in s3fb_set_par() local
754 multiplex = 0; in s3fb_set_par()
809 multiplex = 1; in s3fb_set_par()
826 multiplex = 1; in s3fb_set_par()
854 multiplex = 1; in s3fb_set_par()
884 svga_wseq_mask(par->state.vgabase, 0x15, multiplex ? 0x10 : 0x00, 0x10); in s3fb_set_par()
885 svga_wseq_mask(par->state.vgabase, 0x18, multiplex ? 0x80 : 0x00, 0x80); in s3fb_set_par()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/phy/ |
| D | qcom,usb-8x16-phy.txt | 54 controlled by GPIO to de/multiplex D+/D- USB lines
|
| D | ti,phy-am654-serdes.txt | 42 function. See #phy-cells above to see the multiplex values.
|
| /kernel/linux/linux-5.10/drivers/input/serio/ |
| D | i8042.c | 674 static int i8042_set_mux_mode(bool multiplex, unsigned char *mux_version) in i8042_set_mux_mode() argument
692 param = val = multiplex ? 0x56 : 0xf6; in i8042_set_mux_mode()
695 param = val = multiplex ? 0xa4 : 0xa5; in i8042_set_mux_mode()
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | vidioc-enumstd.rst | 339 multiplex. (NICAM system)
344 DQPSK modulated with a 728 kbit/s sound and data multiplex able to
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/dma/ |
| D | fsl-edma.txt | 3 The eDMA channels have multiplex capability by programmble memory-mapped
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/usb/ |
| D | msm-hsusb.txt | 56 SPDT USB Switch, witch is cotrolled by GPIO to de/multiplex
|
| /kernel/linux/linux-5.10/Documentation/infiniband/ |
| D | opa_vnic.rst | 98 belongs to. On the receive side, this field is used to de-multiplex the
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/memory-controllers/ |
| D | omap-gpmc.txt | 110 - gpmc,wr-data-mux-bus-ns: In address-data multiplex mode, specifies
|
| /kernel/linux/linux-5.10/arch/powerpc/platforms/ |
| D | Kconfig | 81 cpu. This will enable the generic code to multiplex the 4
|
| /kernel/linux/linux-5.10/Documentation/driver-api/ |
| D | pinctl.rst | 23 can control PINs. It may be able to multiplex, bias, set load capacitance,
818 multiplex
822 whether the pin is used for GPIO or not. If you multiplex a GPIO onto a
850 multiplex
857 possible that the GPIO, pin config and pin multiplex registers are placed into
|
| /kernel/linux/linux-5.10/Documentation/networking/ |
| D | gtp.rst | 185 The TEID in the GTP-U header is used to de-multiplex traffic
|
| D | can.rst | 903 To filter for content changes in multiplex message sequences an array of more
909 Up to 257 CAN frames (multiplex filter bit mask CAN frame plus 256 CAN
957 When using CAN FD frames for multiplex filtering the MUX mask is still
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/pinctrl/ |
| D | samsung-pinctrl.txt | 5 and also provides ability to multiplex and configure the output of various
|
| /kernel/linux/linux-5.10/Documentation/hid/ |
| D | hid-transport.rst | 95 multiplex all four on a single physical channel. However, in this document we
|
| /kernel/linux/linux-5.10/Documentation/vm/ |
| D | cleancache.rst | 139 multiplex physical resources across the varying demands of multiple
|
| D | frontswap.rst | 117 multiplex physical resources across the varying demands of multiple
|
| /kernel/linux/linux-5.10/tools/perf/Documentation/ |
| D | perf-script-python.txt | 103 system-wide and multiplex the per-cpu output into a single stream.
|
| /kernel/linux/linux-5.10/Documentation/scsi/ |
| D | ChangeLog.megaraid | 561 multiplex command to low level RAID module(s).
|
| /kernel/linux/linux-5.10/Documentation/virt/uml/ |
| D | user_mode_linux_howto_v2.rst | 448 multiplex connections as each GRE tunnel is terminated directly on
522 no way to multiplex connections as each L2TPv3 tunnel is terminated
|
| /kernel/linux/linux-5.10/Documentation/powerpc/ |
| D | hvcs.rst | 436 Q: How do I multiplex a console that I grab through hvcs so that other
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/ |
| D | devices.txt | 46 master multiplex (/dev/ptmx) to acquire a PTY on
156 2 = /dev/ptmx PTY master multiplex
173 they are redirected through the parport multiplex layer.
|
| /kernel/linux/linux-5.10/Documentation/driver-api/gpio/ |
| D | legacy.rst | 158 that board setup code probably needs to multiplex that pin as a GPIO,
|