Home
last modified time | relevance | path

Searched +full:30 +full:a00000 (Results 1 – 25 of 27) sorted by relevance

12

/kernel/linux/linux-5.10/Documentation/devicetree/bindings/display/bridge/
Dnwl-dsi.yaml174 dsi@30a00000 {
/kernel/linux/linux-5.10/arch/arm/boot/dts/
Dpxa3xx.dtsi20 (gpio <= 98) ? (0x0418 + 4 * (gpio - 30)) : \
277 ssp4: ssp@41a00000 {
285 timer@40a00000 {
Dox810se.dtsi279 uart3: serial@a00000 {
283 interrupts = <30>;
Dkirkwood-l-50.dts88 rtc@30 {
361 partition@7a00000 {
Dimx7s.dtsi968 flexcan1: can@30a00000 {
979 flexcan2: can@30a10000 {
990 i2c1: i2c@30a20000 {
1000 i2c2: i2c@30a30000 {
1010 i2c3: i2c@30a40000 {
1020 i2c4: i2c@30a50000 {
1030 uart4: serial@30a60000 {
1041 uart5: serial@30a70000 {
1045 interrupts = <GIC_SPI 30 IRQ_TYPE_LEVEL_HIGH>;
1052 uart6: serial@30a80000 {
[all …]
Dat91sam9263.dtsi100 atmel,external-irqs = <30 31>;
185 <AT91_PIOC 30 AT91_PERIPH_A AT91_PINCTRL_PULL_UP
268 AT91_PIOE 30 AT91_PERIPH_A AT91_PINCTRL_NONE>; /* PE30 periph A */
766 usb0: ohci@a00000 {
Dprima2.dtsi130 interrupts = <30>;
287 clocks = <&clks 30>;
766 rom-interface@57a00000 {
Ddm816x.dtsi216 target-module@49a00000 {
559 dmas = <&edma 30 0 &edma 31 0>;
662 #dma-channels = <30>;
Dsama5d4.dtsi132 L2: cache-controller@a00000 {
350 sda-gpios = <&pioA 30 GPIO_ACTIVE_HIGH>;
373 scl-gpios = <&pioE 30 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
418 scl-gpios = <&pioB 30 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
522 interrupts = <30 IRQ_TYPE_LEVEL_HIGH 5>;
532 clocks = <&pmc PMC_TYPE_PERIPHERAL 30>;
891 <AT91_PIOC 30 AT91_PERIPH_A AT91_PINCTRL_NONE>;
1000 <AT91_PIOE 30 AT91_PERIPH_A AT91_PINCTRL_NONE>;
1017 <AT91_PIOA 30 AT91_PERIPH_A AT91_PINCTRL_NONE
1023 <AT91_PIOA 30 AT91_PERIPH_GPIO AT91_PINCTRL_NONE
[all …]
Ddm814x.dtsi170 #dma-channels = <30>;
363 dmas = <&edma 30 0 &edma 31 0>;
629 target-module@49a00000 {
Dam33xx.dtsi284 target-module@49a00000 {
459 #dma-channels = <30>;
Datlas6.dtsi119 interrupts = <30>;
734 rom-interface@57a00000 {
Dsama5d2.dtsi146 L2: cache-controller@a00000 {
313 AT91_XDMAC_DT_PERID(30))>;
1022 interrupts = <30 IRQ_TYPE_LEVEL_HIGH 7>;
1032 clocks = <&pmc PMC_TYPE_PERIPHERAL 30>;
Dsun9i-a80.dtsi342 ehci0: usb@a00000 {
1011 drive-strength = <30>;
1019 drive-strength = <30>;
1029 drive-strength = <30>;
Dqcom-apq8064.dtsi1197 &gfx3d 30
1229 &gfx3d1 30
1412 hdmi: hdmi-tx@4a00000 {
/kernel/linux/linux-5.10/arch/mips/boot/dts/ingenic/
Dci20.dts295 interrupts = <30 IRQ_TYPE_LEVEL_LOW>;
350 partition@a00000 {
/kernel/linux/linux-5.10/arch/arm64/boot/dts/freescale/
Dimx8mq.dtsi368 gpio-ranges = <&iomuxc 0 10 30>;
420 gpio-ranges = <&iomuxc 0 119 30>;
909 mipi_dsi: mipi-dsi@30a00000 {
952 dphy: dphy@30a00300 {
965 i2c1: i2c@30a20000 {
975 i2c2: i2c@30a30000 {
985 i2c3: i2c@30a40000 {
995 i2c4: i2c@30a50000 {
1005 uart4: serial@30a60000 {
1016 mu: mailbox@30aa0000 {
[all …]
/kernel/linux/linux-5.10/arch/arm64/boot/dts/allwinner/
Dsun50i-h6.dtsi213 sram_c1: sram@1a00000 {
340 drive-strength = <30>;
349 drive-strength = <30>;
358 drive-strength = <30>;
419 iommu: iommu@30f0000 {
/kernel/linux/linux-5.10/arch/arm64/boot/dts/zte/
Dzx296718.dtsi282 gic: interrupt-controller@2a00000 {
622 dmas = <&dma 30>;
/kernel/linux/linux-5.10/arch/arm64/boot/dts/qcom/
Dipq8074.dtsi457 dwc_0: dwc3@8a00000 {
533 timeout-sec = <30>;
Dapq8096-db820c.dtsi258 "GPIO-H", /* GPIO_8, LCD0_RESET_N, LSEC pin 30 */
1078 dwc3@6a00000 {
Dmsm8996.dtsi959 camss: camss@a00000 {
1768 dwc3@6a00000 {
2145 <GIC_SPI 30 IRQ_TYPE_LEVEL_HIGH>;
/kernel/linux/linux-5.10/arch/arm64/boot/dts/exynos/
Dexynos5433.dtsi1178 sysmmu_decon0x: sysmmu@13a00000 {
1455 dmas = <&pdma0 31>, <&pdma0 30>;
1703 usbhost_dwc3: dwc3@15a00000 {
/kernel/linux/linux-5.10/arch/arm64/boot/dts/ti/
Dk3-am65-main.dtsi494 hwspinlock: spinlock@30e00000 {
839 dss: dss@4a00000 {
Dk3-j721e-main.dtsi194 hwspinlock: spinlock@30e00000 {
1285 dss: dss@4a00000 {

12