Lines Matching +full:attribute +full:- +full:set

3 Contact:	linux-iio@vger.kernel.org
9 Contact:	linux-iio@vger.kernel.org
16 Contact:	linux-iio@vger.kernel.org
23 Contact:	linux-iio@vger.kernel.org
33 			An upper or lower limit is set, mimicking limit switches
34 			in the mechanical counterpart. The upper limit is set to
35 			the Count Y ceiling value, while the lower limit is set
42 		non-recycle:
44 			underflow takes place. The counter is re-enabled when a
48 		modulo-n:
49 			A count value boundary is set between the Count Y floor
52 			counting up, while the counter is set to the Count Y
62 Contact:	linux-iio@vger.kernel.org
64 		Discrete set of available values for the respective Count Y
70 Contact:	linux-iio@vger.kernel.org
72 		Read-only attribute that indicates the count direction of Count
79 		This attribute exposes such count directions.
83 Contact:	linux-iio@vger.kernel.org
85 		Whether channel Y counter is enabled. Valid attribute values are
88 		This attribute is intended to serve as a pause/unpause mechanism
90 		movement of a conveyor belt: this attribute allows an operator
97 Contact:	linux-iio@vger.kernel.org
99 		Read-only attribute that indicates whether excessive noise is
104 Contact:	linux-iio@vger.kernel.org
116 		pulse-direction:
151 Contact:	linux-iio@vger.kernel.org
153 		Read-only attribute that indicates the device-specific name of
159 Contact:	linux-iio@vger.kernel.org
161 		If the counter device supports preset registers -- registers
162 		used to load counter channels to a set count upon device-defined
163 		preset operation trigger events -- the preset count for channel
164 		Y is provided by this attribute.
168 Contact:	linux-iio@vger.kernel.org
171 		attribute values are boolean.
175 Contact:	linux-iio@vger.kernel.org
177 		Action mode of Count Y for Signal Z. This attribute indicates
184 			Pulse-Direction count function mode, this Signal is
198 Contact:	linux-iio@vger.kernel.org
200 		Read-only attribute that indicates the device-specific name of
206 Contact:	linux-iio@vger.kernel.org
208 		Read-only attribute that indicates the total number of Counts
213 Contact:	linux-iio@vger.kernel.org
215 		Read-only attribute that indicates the total number of Signals
220 Contact:	linux-iio@vger.kernel.org
226 Contact:	linux-iio@vger.kernel.org
228 		Read-only attribute that indicates the device-specific name of