Lines Matching +full:long +full:- +full:press +full:- +full:mode

2  * arch/arm/mach-lpc32xx/pm.c
17  * direct-run, and halt modes. When switching between halt and run modes,
18  * the CPU transistions through direct-run mode. For Linux, direct-run
19  * mode is not used in normal operation. Halt mode is used when the
22  * Run mode:
25  * the HCLK_PLL rate. Linux runs in this mode.
27  * Direct-run mode:
30  * source or the frequency of the main oscillator. In this mode, the
33  * Halt mode:
37  * system event (ie, GPIO state change, RTC match, key press, etc.) will
38  * wake the system up back into direct-run mode.
43  * SDRAM will still be accessible in direct-run mode. In DDR based systems,
44  * a transition to direct-run mode will stop all DDR accesses (no clocks).
46  * and exit DRAM self-refresh modes must not be executed in DRAM. A small
53  *  Places DRAMs in self-refresh mode
54  *  Enter direct-run mode
57  *  Enter halt mode - CPU and buses will stop
58  *  System enters direct-run mode when an enabled event occurs
60  *  Run mode is entered
61  *  DRAMS are placed back into normal mode
64  *  Suspend mode is exited
91 		return -ENOMEM;  in lpc32xx_pm_enter()
100 	flush_icache_range((unsigned long)TEMP_IRAM_AREA,  in lpc32xx_pm_enter()
101 		(unsigned long)(TEMP_IRAM_AREA) + lpc32xx_sys_suspend_sz);  in lpc32xx_pm_enter()
128 	 * Setup SDRAM self-refresh clock to automatically disable o  in lpc32xx_pm_init()
129 	 * start of self-refresh. This only needs to be done once.  in lpc32xx_pm_init()