| /kernel/linux/linux-6.6/Documentation/driver-api/media/ |
| D | tx-rx.rst | 28 `BT.601`_ and `BT.656`_ are the most common parallel busses.
31 .. _`BT.656`: https://en.wikipedia.org/wiki/ITU-R_BT.656
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/media/i2c/ |
| D | tvp5150.txt | 5 with discrete syncs or 8-bit ITU-R BT.656 with embedded syncs output formats.
50 BT.656 synchronization.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/media/i2c/ |
| D | tvp5150.txt | 5 with discrete syncs or 8-bit ITU-R BT.656 with embedded syncs output formats.
50 BT.656 synchronization.
|
| D | adv7604.txt | 58 endpoint will use embedded BT.656 synchronization.
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/panel/ |
| D | panel-ilitek-ili9322.c | 9 * - 8-bit ITU-R BT.656 interface
190 "8 bit ITU-R BT.656 720Y 360CbCr",
191 "8 bit ITU-R BT.656 640Y 320CbCr",
406 * None of this applies in the BT.656 mode. in ili9322_init()
425 * This is not used in the BT.656 mode (no H/Vsync or DE signals). in ili9322_init()
608 /* BT.656 VGA mode, 640x480 */
622 /* BT.656 D1 mode 720x480 */
|
| /kernel/linux/linux-6.6/drivers/media/platform/verisilicon/ |
| D | rockchip_av1_filmgrain.c | 19 488, -196, -224, 656, -236, -1128, 60, 4, 140, 276, -676,
23 -1244, -288, 276, 848, 832, -360, 656, 464, -384, -332, -356,
73 -116, -408, 60, -604, -392, 548, -840, 784, -460, 656, -544,
136 600, 424, 888, 656, -356, -320, 220, 316, -176, -724, -188,
176 648, -832, 508, 552, -52, -100, -656, 208, -568, 748, -88,
182 372, -900, -40, 472, -264, -592, 952, 128, 656, 112, 664,
184 -412, 188, -696, 508, -476, 324, -1096, 656, -312, 560, 264,
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/panel/ |
| D | panel-ilitek-ili9322.c | 9 * - 8-bit ITU-R BT.656 interface
191 "8 bit ITU-R BT.656 720Y 360CbCr",
192 "8 bit ITU-R BT.656 640Y 320CbCr",
407 * None of this applies in the BT.656 mode. in ili9322_init()
426 * This is not used in the BT.656 mode (no H/Vsync or DE signals). in ili9322_init()
609 /* BT.656 VGA mode, 640x480 */
623 /* BT.656 D1 mode 720x480 */
|
| /kernel/linux/linux-6.6/drivers/media/platform/ti/omap3isp/ |
| D | ispccdc.c | 975 * mode, enabling BT.656 mode should take precedence. However, in ccdc_config_sync_if()
977 * seems to be required in BT.656 mode. In SYNC mode set it to in ccdc_config_sync_if()
1007 /* The polarity of the vertical sync signal output by the BT.656 in ccdc_config_sync_if()
1028 /* Enable or disable BT.656 mode, including error correction for the in ccdc_config_sync_if()
1157 * input format is a non-BT.656 YUV variant. in ccdc_configure()
1233 * need two cycles per pixel in BT.656 mode, and one cycle per pixel in in ccdc_configure()
1277 /* Use PACK8 mode for 1byte per pixel formats. Check for BT.656 mode in ccdc_configure()
1653 /* In BT.656 mode the CCDC doesn't generate an HS/VS interrupt. We thus in ccdc_vd0_isr()
1663 /* Emulate a VD1 interrupt for BT.656 mode, as we can't stop the CCDC in in ccdc_vd0_isr()
1704 /* In BT.656 mode the synchronization signals are generated by the CCDC in ccdc_vd1_isr()
[all …]
|
| D | omap3isp.h | 41 * @bt656: Data contain BT.656 embedded synchronization
|
| /kernel/linux/linux-5.10/drivers/media/platform/omap3isp/ |
| D | ispccdc.c | 975 * mode, enabling BT.656 mode should take precedence. However, in ccdc_config_sync_if()
977 * seems to be required in BT.656 mode. In SYNC mode set it to in ccdc_config_sync_if()
1007 /* The polarity of the vertical sync signal output by the BT.656 in ccdc_config_sync_if()
1028 /* Enable or disable BT.656 mode, including error correction for the in ccdc_config_sync_if()
1150 * input format is a non-BT.656 YUV variant. in ccdc_configure()
1227 * need two cycles per pixel in BT.656 mode, and one cycle per pixel in in ccdc_configure()
1271 /* Use PACK8 mode for 1byte per pixel formats. Check for BT.656 mode in ccdc_configure()
1647 /* In BT.656 mode the CCDC doesn't generate an HS/VS interrupt. We thus in ccdc_vd0_isr()
1657 /* Emulate a VD1 interrupt for BT.656 mode, as we can't stop the CCDC in in ccdc_vd0_isr()
1698 /* In BT.656 mode the synchronization signals are generated by the CCDC in ccdc_vd1_isr()
[all …]
|
| D | omap3isp.h | 41 * @bt656: Data contain BT.656 embedded synchronization
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/tve200/ |
| D | tve200_drv.c | 21 * 8-bit BT.656 interface.
24 * it supports the ITU BT.656 standard. It requires a 27 MHz clock which is
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/tve200/ |
| D | tve200_drv.c | 21 * 8-bit BT.656 interface.
24 * it supports the ITU BT.656 standard. It requires a 27 MHz clock which is
|
| /kernel/linux/linux-6.6/include/media/ |
| D | v4l2-mediabus.h | 47 * Note: in BT.656 mode HSYNC, FIELD, and VSYNC are unused
153 * Used if the bus is parallel or BT.656.
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/media/ |
| D | video-interfaces.yaml | 62 divided into two separate ITU-R BT.656 8-bit busses. In such case bus-width
95 - 6 # BT.656
|
| D | atmel,isc.yaml | 18 with both external synchronization and BT.656 synchronization for the latter.
|
| /kernel/linux/linux-5.10/drivers/media/usb/dvb-usb-v2/ |
| D | mxl111sf-phy.c | 192 {0x1b, 0xff, 0x1e}, /* pin mux mode, Choose 656/I2S input */ in mxl111sf_init_i2s_port()
195 Inverted 656 Clock, I2S_SOFT_RESET, in mxl111sf_init_i2s_port()
|
| /kernel/linux/linux-6.6/drivers/media/usb/dvb-usb-v2/ |
| D | mxl111sf-phy.c | 192 {0x1b, 0xff, 0x1e}, /* pin mux mode, Choose 656/I2S input */ in mxl111sf_init_i2s_port()
195 Inverted 656 Clock, I2S_SOFT_RESET, in mxl111sf_init_i2s_port()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/media/ |
| D | allwinner,sun6i-a31-csi.yaml | 106 * embedded BT.656 sync is used.
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | vidioc-g-dv-timings.rst | 190 - Timings defined by BT.656/1120 specifications
214 - BT.656/1120 timings
|
| /kernel/linux/linux-6.6/Documentation/userspace-api/media/v4l/ |
| D | vidioc-g-dv-timings.rst | 192 - Timings defined by BT.656/1120 specifications
216 - BT.656/1120 timings
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/interrupt-controller/ |
| D | hisilicon,mbigen-v2.txt | 82 interrupts = <656 1>,
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | hisilicon,mbigen-v2.txt | 82 interrupts = <656 1>,
|
| /kernel/linux/linux-5.10/drivers/staging/media/atomisp/pci/isp/kernels/ctc/ctc_1.0/ |
| D | ia_css_ctc_table.host.c | 33 666, 656, 648, 639, 633, 626, 618, 612,
|
| /kernel/linux/linux-6.6/drivers/staging/media/atomisp/pci/isp/kernels/ctc/ctc_1.0/ |
| D | ia_css_ctc_table.host.c | 33 666, 656, 648, 639, 633, 626, 618, 612,
|